Metra Electronics 95-7324 User's Manual
Contents
1. Metra recommends making connections as shown below Strip Splice Solder Tape Isolate and individually tape off ends of any unused wires to prevent electrical short circuit METRA EIA WIRING CODE 12V Ignition Acc Red Right Front Gray 12V Batt Memory Yellow Right Front Gray Black Ground Black Left Front White Power Antenna Blue Left Front White Black Amp Turn On Blue White Right Rear Violet Amp Ground Black White Right Rear Violet Black Illumination Orange Left Rear Green DIMM eee bros Orange White Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis All colors may not be present on all leads due to manufacturer s specifications 4 WC Ma NOTES 95 7324 INSTRUCTIONS ee o_o 1 800 221 0932 www metraonline com REV 04 27 10 COPYRIGHT 2004 10 METRA ELECTRONICS CORPORATION INST95 73242. INSTALLATION INSTRUCTIONS FOR PART 95 7324 APPLICATIONS KIA Optima 2006 5 2010 95 7324 KIT FEATURES e Double DIN radio provision e Stacked ISO units provision KIT COMPONENTS A Double DIN Trim Plate B Double DIN Brackets WIRING AND ANTENNA CONNECTIONS Sold Separately Harness e 70 1004 Hyundai 2006 up KIA harness 2004 up e 70 7303 Hyundai KIA Harness 2009 Antenna Adapter e 40 KI11 2009 10 Kia Optima TOOLS REQUIRED Phillips Screwdriver e Small Flat Blade Screwdriver Panel Removal Tool A 1 800 221 0932 www metraonline com O COPYRIGHT 2004 10 METRA ELECTRONICS CORPORATION ce Ma TABLE OF CONTENTS Dash Disassembly Kia Optima 2006 5 2010 4 ous ssssssuumunurs 1 Kit Assembly Double DIN Radio Provision 0000000000 20 1 2 Stacked ISO Units Provision sos ENEE 3 FINALASSEMDIV er de sauna haare 4 Note Refer also to the instructions included with the aftermarket radio Aeren A 25 7324 DASH DISASSEMBLY KIA OPTIMA 2006 5 2010 1 Disconnect the negative battery ter minal to prevent an accidental short circuit 2 Unclip and remove the panel sur rounding the radio including the a c vents and climate controls Figure A 3 Remove 4 Phillips screws securing radio Unplug and remove radio Figure B Continue to kit assembly LES 95 7324 KIT ASSEMBLY DOUBLE DIN RADIO P
3. ROVISION Note Refer also to the instructions included with the aftermarket radio A 1 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate Figure A 2 Slide the Double DIN radio into the bracket trim plate assembly and secure the radio to the assembly using the screws supplied with the radio Figure B Continue to final assembly LES 95 7324 KIT ASSEMBLY STACKED ISO UNITS PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Snap the Double DIN brackets to the inside edge of the Double DIN trim plate Figure A 2 Slide the stacked ISO units into the bracket radio housing assembly and secure the units to the kit using the screws supplied with the units Figure B Continue to final assembly LS BETETE FINAL ASSEMBLY A Strip wire ends back 1 2 B Twist ends together C Solder D Tape 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown Isolate and individ ually tape off the ends of any unused wires to prevent electrical short circuit 2 Re connect the negative battery terminal and test the unit for proper operation 3 Reassemble radio and dash assemblies in reverse order of disassembly FINAL WIRING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit
Download Pdf Manuals
Related Search