Manitowoc Ice Q-SERIES Q-0600 User's Manual
Contents
1. Deburr suction line before fitting new tubing in NOTE IF REPLACING COMPRESSOR INTO A REMOTE CONDENSER ICE MACHINE MAKE SURE TO FIRST FOLLOW THE INSTRUCTIONS A B AND C BELOW BEFORE PROCEEDING TO INSTRUCTION 11 A Cut process tubing approximately 3 from the horizontal portion of the tube Make sure to cut both ends of the tube to make sure that a T fitting can be placed in between the pieces riz rita Porio Ni B Place T fitting in between process tubing and place pieces of additional tubing between open end of T and HPR valve as shown below Pd ee C Return to instruction 11 11 12 13 Place armaflex insulation provided in kit on suction line as shown in picture below Slide insulation up tubing and secure while brazing Braze all tubing into place Purge system with nitrogen during all brazing operations on the ice machine Use electrical tape to seal suction line insulation Replace the filter dryer before evacuating the machine Make sure that filter dryer tubing is not rubbing against the compressor Evacuate machine to 500 microns Charge the machine with nameplate charge Make sure that all tubing is not rubbing against anything else in the machine Reinstall corner post that was removed earlier and place electrical cover on compressor Reinstall back panels of ice machine 8006173 Sheet 2 of 3 06 25 01 21 Reinstall all other panels2. 22 Reconnect power and test run ice machine 8006173 Sheet 3 of 3 06 25 01
3. Manitowoc ICE MACHINES amp REACHINS J Q 0600 Compressor Replacement Installation Instructions NOTE THIS REPLACEMENT IS ONLY FOR THE Q SERIES MACHINES NO CHANGES WITH START RUN COMPONENTS ARE NEEDED 1 Disconnect power to the ice machine at the electrical 8 Remove extra section of suction service valve disconnect moving the toggle switch to the off process tube from the ice machine at swedge joint position will not disconnect line voltage Repeat this procedure with discharge line Remove 2 Remove panels top front left and right sides up to T section 3 Recover refrigerant from ice machine 4 Remove right side corner post when facing the front of the machine and back panel ie ty P T Section 5 Remove wiring from compressor terminals Swedge Joint 6 Cut tubing suction discharge and process lines at the compressor ports 7 Remove compressor from machine Make sure to crimp and braze shut ports to compressor 9 Insert new compressor into the machine as shown Suction Manitowoc Ice Inc 2110 South 26 Street P O Box 1720 Manitowoc WI 54221 1720 USA 8006173 Telephone 920 682 0161 Fax Sales 920 683 7589 Service Parts 920 683 7585 Other 920 683 7879 Sheet 1 of 3 Web Site www manitowocice com 06 25 01 10 Fit tubing provided into the proper place as shown Make sure that the discharge line ends up on the inside of the suction line Cut ice machine suction line to fit new tubing
Download Pdf Manuals
Related Search