Magellan MAP410 User's Manual
Contents
1. delete a waypoint in a route Answer While viewing the route you wish to delete a waypoint from use up down arrow keys to highlight the waypoint you wish to delete Press menu Use up down arrow keys to highlight delete and press enter mark 48 Question How do I save a route in my MAP 410 GPS Answer While viewing the route you wish to save Use up down arrow keys to highlight save route and press enter mark Or press menu Use up down arrow keys to highlight save route and press enter mark 49 Question How do activate a route in my Map410 GPS Answer Press menu Use up down arrow keys to highlight routes and press enter mark Use up down arrow keys to highlight the route you wish to activate Press menu Use up down arrow keys to highlight activate and press enter mark 50 Question How do deactivate a route in my Map 410 GPS Answer Press menu Use up down arrow keys to highlight routes and press enter mark Use up down arrow keys to highlight the route you wish to deactivate Press menu Use up down arrow keys to highlight deactivate and press enter mark 50 Question How do reverse a route in Map 410 GPS Answer Press menu Use up down arrow keys to highlight routes Enter Mark Use up down arrow keys to highlight the route you wish to reverse Press menu Use up down arrow keys to highlight reverse Enter Mark The screen will display th2. AGELLAN Map 410 GPS FAQs Question How many baiteries does my Map 410 GPS use Answer Map 410 GPS uses four AA batteries Question How long will the batteries operate for my Map 410 GPS Answer Using four AA batteries your Map 410 GPS will operate continuously for up to 12 hours Question How long will my Map 410 GPS keep memory active without a battery Answer The internal lithium backup battery will keep your receiver s memory active for up to 10 years Question How do install the batteries in my Map 410 GPS Answer The Map 410 GPS uses four AA alkaline batteries that are installed from the bottom of the receiver Use the rings to unscrew the water seal battery caps Insert the batteries into the battery tubes with the positive end first two batteries in each side and screw the battery caps until securely closed Although it is recommended that four AA batteries be used in case of an emergency the receiver will operate with only two batteries if both are inserted into one of the battery tubes Question How do I turn on my Map 410 GPS Answer To turn your Map 410 GPS on press the power light key and then press the enter key when prompted If the enter key is not pressed within 10 seconds of being prompted the receiver will turn off Wait for the unit to scroll through the start up screens Question How do I turn off my Map 410
3. GPS Answer To turn your Map 410 GPS off press and hold the same power light key This will start a shutdown sequence that counts down the seconds until the receiver actually turns off To immediately turn the receiver off release and press the power light key again To cancel the shutdown sequence press any other key Question How do initialize my MAP 410 GPS for the first time use Answer Turn your receiver on by pressing the power light key and the enter key when prompted Because this is the first time you have used your receiver a screen will be displayed prompting you to initialize your receiver Press the enter key When the region screen appears Use up down arrow keys to highlight the region where you are located Enter mark Use up down arrow keys to highlight country province or state where you are located Enter mark The elevation screen appears Use the arrow keys to enter your present elevation Enter mark From the time field on the elevation screen Use the arrow keys to enter the local time and toggle between AM and PM Enter mark From the date field on the elevation screen Use the arrow keys to input the date Enter mark During Initialization at the Preference screen Use the arrow keys to toggle between marine and land Enter mark When you have chosen the primary usage for your receiver the status screen will be displayed At this point you should go out
4. aves fewer bread crumbs when you are traveling in a straight line This keeps your track looking more like the actual path you traveled instead of jagged lines Your track history will be displayed on the map using a black dotted line 23 Question How do change the track interval settings in my Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight track hist and press the enter mark key Use up down arrow keys to highlight your choice and press enter mark 24 Question How do I clear my track history in Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight clr track and press the enter mark key A confirmation screen appears Use up down arrow keys to highlight yes and press enter mark 25 Question How do I pan map in my Map 410 GPS Answer While in the map screen you can use the 8 way arrow keys to pan around the screen This allows you to scan the map to see what your surroundings are or where a specific waypoint is located in relation to your current position While panning the cursor will be displayed as an icon representing crosshairs Pressing the quit key will center the map screen on your present position and hide the crosshairs 26 Question How do reset the odometer in my Map 410 GPS Answer From the speed screen press menu Use up down arrow keys to highlight odom re
5. e route menu and the waypoints in the titles will reverse 51 Question How do delete a route in my Map 410 GPS Answer Press menu Use up down arrow keys to highlight routes Enter mark Use up down arrow keys to highlight the route you wish to delete Press menu Use up down arrow keys to highlight delete Enter mark A confirmation screen appears Use up down arrow keys to highlight yes or no Enter mark 52 Question How do adjust the contrast in my Map 410 GPS Answer From any NAV screen press menu Use up down arrow keys to highlight contrast Enter mark Use left right arrow keys to adjust the contrast Enter mark
6. etup press the enter mark key Use up down arrow keys to highlight the uploaded data Press the enter mark key Use up down arrow keys to highlight on or off Enter mark A confirmation warning screen appears Use up down arrow keys to highlight yes or no Enter mark 20 Question What is hide show data and what does it do Answer This function allows you to hide or show the data window on the map screen When the data window is displayed the option on the menu will be hide data and when the data window is hidden the option will be show data 21 Question How do I enable hide show data in my Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight hide data or show data and press enter mark 22 Question What is track history Answer The track history function allows you to select the track history interval or turn it off Using track history records where you have been by automatically storing locations as dropping bread crumbs from your starting point as you travel This is useful when you want to return to your starting point The default setting is auto which depending on your speed and bearing automatically leaves bread crumbs displaying your track The auto setting makes use of the SmartTrack feature which stops leaving bread crumbs when your speed is zero leaves a lot of bread crumbs when you are making a turn and le
7. g you want for the waypoint Press enter on distance and enter the distance you want the waypoint to be projected 36 Question How do I find waypoints or landmarks User and non user in my Map 410 GPS Answer From any screen press menu Use up down arrow keys to highlight waypoints or landmarks and press enter Highlight the category of the waypoint Press enter mark Press menu Use up down arrow keys to highlight find Press enter Use up down arrow keys to input the characters of the waypoint Enter mark You are brought back to the waypoint menu with the chosen waypoint highlighted Enter mark The information on that waypoint is displayed 37 Question How do I create a GOTO route in my Map 410 GPS Answer From your present location Press GOTO Use up down ARROW KEYS to highlight the user category and press enter you wish to goto press enter use UP and DOWN keys to highlight the landmark or waypoint you want to goto and press enter 38 Question How do I clear a GOTO route Answer Press GOTO once then press menu Use up down arrow keys to select clear GOTO Press enter 39 Question How do create a Man Over Board MOB route Answer Press GOTO Use up down arrow keys to highlight MOB and press enter 40 Question What is a Man Over Board MOB route Answer Another type of route is Man Over Board MOB The MOB route is useful when you want to
8. instantly create a route When you press enter your receiver will store the position and set a GOTO route to it MOB waypoints are titled MOB001 MOBO02 and so forth If an MOB route already exists the receiver will give you the option of replacing the MOB route 41 Question How do I clear a MOB route in my Map 410 GPS Answer Press GOTO then press menu Use up down arrow keys to highlight clear the MOB route and then press enter 42 Question How do I create a backtrack route Answer Press menu Use up down arrow keys to highlight routes and press enter Use up down arrow keys to highlight backtrack and press enter mark 43 Question How do I create a multi leg route in my Map 410 GPS Answer Press menu Use up down arrow keys to highlight routes Press enter The route menu appears Use up down arrow keys to highlight an empty route Press menu Use up down arrow keys to highlight create Press enter A screen will appear with the first dotted line highlighted Enter mark Use up down arrow keys to highlight the category in which the waypoint is located Press enter mark A menu of all the waypoints saved from the selected category is displayed Use up down arrow keys to highlight the first waypoint of your route Press enter mark Your receiver will display the waypoint you just selected in the starting location and the second dotted line will be highlighted Enter Mark C
9. ion How do view the secondary coordinate system from the position screen in my Map 410 GPS Answer From the position screen press the left right arrows and the lower half of the screen changes to display your present position in the secondary coordinate system The datums that were selected under setup for each coordinate system are also displayed 13 Question How do customize the NAV screens in my Map 410 GPS Answer From the NAV screen press men Use up down arrow keys to highlight customize and press the enter Mark key Use up down arrow keys to highlight the field you wish to change and press enter A pop up menu appears gt Use up down arrow keys to highlight your choice Enter mark gt You are returned to the NAV1 screen in the customize mode gt You can continue customizing using the same steps or press quit to exit this mode 14 Question How do I customize the compass screen in my Map 410 GPS Answer From the compass screen Press menu Use up down arrow keys to highlight customize and press the enter mark key Use up down arrow keys to highlight the field you wish to change Enter mark A pop up menu appears Use up down arrow keys to highlight your choice and press the enter mark key Then You are returned to the compass screen in the customize mod gt You can continue customizing using the same steps or press quit to exit this mode 15 Question How do e
10. nter the map setup screen in my Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight map setup Press the enter mark key to exit map setup Press the quit key 16 Question What are all the options available in map screen orientation Answer The map screen has three types of orientation to choose from North up course up and track up North up has north located at the top of the screen Course up has the destination of the current leg at the top of the screen track up has the direction you are moving at the top of the screen 17 Question How do I change the map screen orientation in my Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight map setup and press enter on the enter mark key Use up down arrow keys to highlight the orientation setting Enter mark Use up down arrow keys to highlight your choice and press enter mark 18 Question How do turn on off the latitude longitude grid in my Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight map setup Enter mark Use up down arrow keys to highlight latitude longitude grid Enter mark Use up down arrow keys to highlight on or off Enter mark 19 Question How do enable disable uploaded map data in my Map 410 GPS Answer From the map screen press menu Use up down arrow keys to highlight map s
11. ontinue the above process until you have completed the desired route Use UP DOWN ARROW KEYS to highlight SAVE ROUTE Enter Mark OR Press Menu Use UP DOWN ARROW KEYS to highlight SAVE ROUTE Enter Mark 44 Question How do view edit a route in my Map 410 GPS Answer From any screen press menu Use up down arrow keys to highlight routes and press enter mark Use up down arrow keys to highlight the route you wish to edit Press menu Use up down arrow keys to highlight view edit and press enter mark 45 Question How do I change a waypoint or landmark in a route Answer While viewing the route in which you wish to change a waypoint use up down arrow keys to highlight the waypoint that you want to change and press enter mark Use up down arrow keys to highlight the category in which the waypoint is located and press enter mark Use up down arrow keys to highlight the waypoint you want to replace Enter mark 46 Question How do add a waypoint at the end of a route in my Map 410 GPS Answer While viewing the route you wish to add a waypoint to the end of use up down arrow keys To highlight the first available dotted line of the route press enter mark then use up down arrow keys to highlight the category the waypoint is located in and press enter mark Use up down arrow keys to highlight the waypoint you want to add to the end of your route and press enter mark 47 Question How do
12. set and press enter mark A pop up confirmation window appears Use up down arrow keys to highlight yes or no and press enter mark 27 Question How do I reset the trip odometer in my Map 410 GPS Answer From the speed screen press menu Use up down arrow keys to highlight trip reset and press enter mark Use up down arrow keys to highlight yes or no enter mark 28 Question How do I set the speed average in my Map 410 GPS Answer From the speed screen press menu Use up down arrow keys to highlight speed avg press mark A pop up window appears Use up down arrow keys to highlight trip 5 seconds 30 seconds 1 minute 5 minutes or 1 hour Enter mark 29 Question What information can view on the time screen of my Map 410 GPS Answer The time screen displays the current time estimated time enrooted ETE time of arrival and elapsed time in regards to the route in which you are navigating 30 Question How do I select the time format in my Map 410 GPS Answer From any screen press menu Use up down arrow keys to highlight setup Enter mark Use up down arrow keys to highlight time format Enter mark Use up down arrow keys to highlight your choice Enter mark 31 Question What are user waypoints Answer User waypoints are locations that you save in your receiver s memory including their coordinates and an icon you associate with them You can edi
13. side in an area where you can get a clear view of the sky Your Map 410 will begin receiving data from the satellites in view and will display the progress on the status screen When your receiver has computed a position fix the map screen will be displayed If the map screen has been turned off then the position screen will be displayed Question How do I save my position as a waypoint or landmark Answer From any screen press and hold enter mark you will then see a screen with you latitude longitude readings and also a default name LMKOOX press and hold the mark key again to save Question How do create a GOTO route to my saved waypoint or landmark Answer Press the GOTO key once then use up down arrow keys to highlight the user category and press enter mark Use up down arrow keys to highlight the waypoint you just saved Enter mark 10 Question How do I select the temp units in my Map 410 GPS Answer From the Sat Status screen press menu Use up down arrow keys to highlight temp units and press enter mark Use up down arrow keys to select either Fahrenheit or Celsius 11 Question How do I set a temperature calibration Answer From the sat status screen press menu Use up down arrow keys to highlight temp calib and press enter mark Use the arrow keys to change the temperature Enter mark Use up down arrow keys to highlight save edits Enter mark 12 Quest
14. t these waypoints and they can be deleted when you no longer need them 32 Question What are non user waypoints Answer Non user waypoints are uploaded into your receiver They display destinations of interest including their coordinates and their name Non user waypoints cannot be edited and are permanently stored in your receiver s memory They cannot be deleted unless written over by waypoints downloaded from the MapSend CD 33 Question How do I save a position fix with a user created name Answer Enter mark Press and hold Enter mark Use arrow keys to enter the alphanumeric characters of the name you choose Enter mark Use arrow keys to highlight the waypoint icon of your choice Enter mark Use up down arrows to highlight save wpt Enter mark 34 Question How do I select a waypoint to edit user only in my Map 410 GPS Answer From any NAV screen press menu Use up down arrow keys to highlight waypoints Enter mark Use up down arrow keys to highlight the user category Enter mark Use up down arrow keys to highlight the waypoint you wish to edit Enter mark Press Menu Use up down arrow keys to highlight edit wpt Enter mark 35 Question How do I project a waypoint or landmark in my Map 410 GPS Answer From the position screen press menu then select projection and press enter Highlight bearing and press enter Enter the bearin
Download Pdf Manuals
Related Search