Lightolier IS:40620 User's Manual
Contents
1. into OUTLET BOX Position BACKPLATE over MOUNTING PLATE allowing MOUNTING SCREWS to come through the holes in BACKPLATE CAUTION Make certain wires are not pinched between parts Secure BACKPLATE in position by installing the two BATTERY NUTS over MOUNTING SCREWS and tighten Install recommended lamp For Compact Fluorescent Units WARNING RISK OF FIRE MOST DWELLINGS BUILT BEFORE 1985 HAVE SUPPLY WIRE RATED 60 C CONSULT A QUALIFIED ELECTRICIAN BEFORE INSTALLATION NOTE If supply wires are located within three inches of ballast use wire rated for at least 90 C CAUTION MAXIMUM WATTAGE AS MARKED ON FIXTURE MUST NOT BE EXCEEDED THUMB SCREW OUTLET 80X WIRE NUT GROUND WIRE BATTERY NUT MOUNTING PLATE Pa MOUNTING SCREWS OUTLET BOX SCREW SOCKET BACKPLATE DIFFUSER CATCH DIFFUSER gt m gO SECAUCUS NEW JERSEY 07096 Li e iHi La LEE ER monea uevec canava 1 40620 INSTRUCTIONS FOR INSTALLATION OF A D A LUNA Continued COVERS FIXTURES 40620 40620N1 40620H2 R0194 Page2of2 DIFFUSER INSTALLATION 1 Position DIFFUSER so that recessed area of DIFFUSER LIP hooks over DIFFUSER CATCH on BACKPLA ATE Fig 2 2 Swing DIFFUSER back against BACKPLATE and secure DIFFUSER in position by threading THUMB SCREW into hole in the top of BACKPLATE Fig 3 fe BOWE CAUTION Make certain that THUMB SCREW tightens into the recessed area of the DIFFUSER LiP Fig 3 Do not over tighten THUMB SCR2. EW DIFFUSER damage could occur THUMB SCREW ge c Vie SCREW UNTI IS my fi H DIFFUSER by co DIFFUSER LIP ly J FIG 2 are CATCH FiG 3 re gt
3. READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE INSTRUCTION SHEET NO This fixture is intended for installation in accordance with the National Electrical Code and local regulations To assure full compliance with local codes and regulations check with your local electrical inspector before l S a 40 6 2 0 installation To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference R0194 Page 1 of 2 INSTRUCTIONS FOR INSTALLATION OF A D A LUNA COVERS FIXTURES 40620 40620N1 40620H2 NOTE This instruction sheet covers both compact fluorescent and incandescent type fixtures Although illustration shows compact fluorescent version the incandescent version assembles and installs the same BACKPLATE INSTALLATION Thread MOUNTING SCREWS into back of MOUNTING PLATE so MOUNTING SCREW HEADS tighten into recessed area of MOUNTING PLATE Fig 1 ete ie aaa slots in MOUNTING PLATE secure MOUNTING PLATE to OUTLET BOX using OUTLET BOX SCREWS provided with While supporting BACKPLATE make connections black fixture lead or fixture without tracer marks to Bot black supply lead white fixture lead or fixture lead with tracer marks to neutral white supply lead Uninsulated fixture wire is a ground wire abd must be connected to grounding terminal or ground lead inside OUTLET BOX Use WIRE NUTS local hardware item Push supply wires and wir nut connections back
Download Pdf Manuals
Related Search