Lightolier IS:2005 User's Manual
Contents
1. INSTRUCTION SHEET NO E INSTALLATION OF LYTECASTER REFLECTOR TRIM IS 2 0 0 5 IN THE 2000 SERIES FRAME IN KIT WITH ROTO CLIPS k READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE This fixture is intended for installation in accordance with the National Electrical Code and local or federal code specifications To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference FIG A FIG B FIG D 1 FRAME IN 2 ROTATE CLIPS 4 PUSH UP WARNING RISK OF FIRE DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR WIRING COMPARTMENT NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT 1 FRAME IN Fig A See Frame in Kit Instruction Sheet for installation 7 procedure 2 ROTATE ROTO CLIPS Fig B As shown in Fig E 3 SNAP ON Fig C Insert SOCKET CUP in neck of REFLECTOR Make REFLECTOR ROTO CLIP POSITION FIG E 4 PUSH UP Fig D Push REFLECTOR TRIM straight up until it is tight against ceiling NOTE To remove REFLECTOR TRIM turn REFLECTOR TRIM counterclockwise while pulling downward WARNING USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER INC USE OF OTHER MANUFACTURERS REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD sure SPRINGS of SOCKET CUP snap into SLOTS of EN U S PATENT NOS 4 039 822 4 313 154 and 4 327 403 FOREIGN PATENTS PENDING ii ics HiT O2. l i a un NEW JERSEY 07096 nd MONTREAL QUEBEC CANADA 1 2005 1088 PIN SLOT 2006 AND PINHOLE 2011 REFLECTOR TRIM 1 Make sure power is OFF 2 Remove FACEPLATE from REFLECTOR TRIM Push up REFLECTOR TRIM tight against ceiling 3 Lamp fixture with the recommended lamp as specified in REFLECTOR TRIM FACEPLATE 4 an up FACEPLATE into REFLECTOR TRIM Fig F NOTE For Pin Slot No 2006 make sure SLOT in ro he is in line with the adjusted lamp position Fig H FIG F REFLECTOR TRIM SOCKET CUP FACEPLATE SLOT LAMP HOLDER FIG G APERTURE TRIM ASSEMBLY YOKE SLOT
Download Pdf Manuals
Related Search