Lightolier B7760 User's Manual
Contents
1. INSTRUCTION SHEET NO INSTALLATION OF CALCULITE REFLECTOR TRIMS INSTRUCTION SHEET FOR ITEMS A7053 A7701 A7058 B7054 B7705 B7760 B7780 C7055 C7709 D7707 5 3 This fixture is intended for installation in accordance with the National Electrical Code and local or federal code specifications To prevent electrical shock turn off electricity at fuse box before proceeding Retain these instructions for maintenance reference OPTICAL SECTION FIG 1 A FRAME IN FIG 2 B SNAP IN V FIG 3 C PUSH IN WARNING A RISK OF FIRE DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR WIRING COMPARTMENT NOR ABOVE FIXTURE IN SUCH A MANNER SO AS TO ENTRAP HEAT A FRAME IN FIG 1 WHITE ie See Frame in Kit Instruction Sheet No IS A400 for installation procedure B SNAP IN FIG 2 4 S NOTE For Overlapping Trim installation slip WHITE l BD TRIM RING on over OPTICAL SECTION as shown on SECA Fig 4 and 5 before Snap in For Flangeless Trim FIG 4 FIG 5 installation WHITE TRIM RING is not required Fasten ADJUSTABLE SOCKET HOUSING to OPTICAL SECTION reflector or baffle by 1 aligning the SPRING with CUTOUT on top Fig 6 2 pushing ADJUSTABLE SOCKET HOUSING onto OPTICAL SECTION for engagement If SLOTS are provided on OPTICAL SECTION for vertical adjustment engage SPRING to desired lamp wattage position see label on inside and outside to neck of REFLECTOR HOUSING See Fig2. 6 and 7 C PUSH IN FIG 3 Push OPTICAL SECTION straight up into MOUNTING FRAME until tight against finished ceiling RETAINING SPRINGS on MOUNTING FRAME Fig 1 will secure OPTICAL SECTON reflector or baffle in place NOTE To remove OPTICAL SECTION use FINGER HOLE Fig 7 provided on upper part for sure grip turn OPTICAL SECTION counterclockwise while pulling downward After starting use both hands to remove See Fig 8 CARE AND MAINTENANCE OF ALZAK REFLECTOR If handling of reflectors with anodized or Alzak finish is required the use of clean white or plastic film gloves is recommended to avoid fingerprints Anodized or Alzak surfaces can be cleaned by the following methods 1 Wipe of with a soft clean dry lint free cloth 2 Wipe off with a clean cloth dampened in mild detergent solution Rinse then wipe dry with lint free cloth or paper towel 3 Wipe off with a clean cloth dampened with a solution of wetting agent and water such as 2 oz per gallon Pluronic L62 LF by Wyandotte Products or a liquid wax such as Glass Wax Then wipe dry Avoid gritty cleaning agents CUT OUT ON TOP LAMPIWATTAGE POSITION LABEL INSIDE NECK LAMPIWATTAGE POSITION LABEL OUTSIDE NECK FIG 6 ADJUSTABLE SOCKET HOUSING eee OPTICAL SECTION FINGER HOLE RETAINING SPRINGS FIG 7 TO REMOVE FIG 8 US Pat No 4 039 822 i SECAUCUS NEW JERSEY 07096 MONT
3. REAL QUEBEC CANADA LIGiiTOLill
Download Pdf Manuals
Related Search