La Crosse Technology WT-8002U User's Manual
Contents
1. ee 4 E g To Set the Time Alarm ccccccceeceesssssssseeeees 4 To Use The Alarm ossessi tisnin 4 Battery Replacement Information 5 Mounting the Unit ee eeeeeeeeeeeeeeneeeeaes 5 SET ALM 1B SNZ Online RESOUICES ccceeeseeeeeeeeeeeeeeesessnseeeees 5 Care and Maintenance ceeesceeeeeeeees 5 C O C O Troubleshooting eesseesseesseesessrnneseseseresennsenae 6 Warranty Information sseeeeeeeeeereereerne 6 Page 1 of 8 Page 2 of 8 Install Battery Insert 1 new AA 1 5 volt ALKALINE batteries into the clock according to the polarity marked on the battery compartment Once the battery is properly installed in the clock the unit will beep and all segments of its LCD will briefly light up The indoor temp and the time displayed as 12 00 will appear on the LCD If the time and temp do not appear after 30 seconds please reinstall the battery and try again Once the indoor temp is displayed proceed to the next step Set the Time and Date Please read through all of the steps below before starting to configure your clock Once you have started the configuration you will be able to move from one step to another by pressing the SET button If at any point during the setup process you need to start over avoid pressing any buttons for roughly 30 seconds or wait until the display stops flashing then repeat the steps outlined in this section Note The following2. or ninety 90 days whichever is longer La Crosse Technology Ltd will pay all expenses for labor and materials for all repairs covered by this warranty If necessary repairs are not covered by this warranty or if a product is examined which is not in need or repair you will be charged for the repairs or examination The owner must pay any shipping charges incurred in getting your La Crosse Technology Ltd product to a La Crosse Technology Ltd authorized service center La Crosse Technology Ltd will pay ground return shipping charges to the owner of the product to a USA address only Your La Crosse Technology Ltd warranty covers all defects in material and workmanship with the following specified exceptions 1 damage caused by accident unreasonable use or neglect including the lack of reasonable and necessary maintenance 2 damage occurring during shipment claims must be presented to the carrier 3 damage to or deterioration of any accessory or decorative surface 4 damage resulting from failure to follow instructions contained in your owner s manual 5 damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology Ltd authorized service center 6 units used for other than home use 7 applications and uses that this product was not intended or 8 the products inability to receive a signal due to any source of interference This warranty covers only actual def
3. Inventory of Contents La Crosse Technology 1 WT 8002 Clock WT 8002U 2 Mounting hardware 3 Instruction manual Features and Specifications e Digital time and date e 12 24 hour time Digital Clock with Indoor Temperature e Indoor temperature F or C 32 F to 122 F 0 C to 50 C e Time alarm with snooze fi e Calendar month date and weekday L e Wall hanging or free standing 1 F e Battery 1 X AA size 1 5V not included 5 e Battery life Up to 24 months e Dimensions 8 62 L x 1 29 W x 6 81 H 218 9 x 32 7 x 172 9 mm La Crosse Technology Ltd www lacrossetechnology com 2809 Losey Blvd S a gt La Crosse WI 54601 Phone 608 782 1610 Il o e Il I Table of Content 0 ieee annin 1 mt a F Inventory of Contents ccccccccseceseeeseeeeeens 2 O000O O Features and Specifications ccee 2 Back ViOWs sietoun inanan 2 i p Button VIEW sesesisiecsccsaccaceicadeaeseendesann ventexecesevsncdeet 2 o Install Battery ccccccccsseecsesecseseseceeesetecseneeees 3 lh a l Set the Time and Datte ccccceeeseeseeeneenes 3 ae eee To Change the Temperature Unit
4. aline battery that tests no less than 1 48 on a voltmeter or with an expiration date that is 7 years in the future e Ensure correct polarity Ensure that the clock has a fresh battery and is installed using correct polarity as shown inside the battery compartment Warranty Information La Crosse Technology Ltd provides a 1 year limited warranty on this product against manufacturing defects in materials and workmanship This limited warranty begins on the original date of purchase is valid only on products purchased and used in North America and only to the original purchaser of this product To receive warranty service the purchaser must contact La Crosse Technology Ltd for problem determination and service procedures Warranty service can only be performed by a La Crosse Technology Ltd authorized service center The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology Ltd or La Crosse Technology Ltd s authorized service center La Crosse Technology Ltd will repair or replace this product at our option and at no charge as stipulated herein with new Page 6 of 8 or reconditioned parts or products if found to be defective during the limited warranty period specified above All replaced parts and products become the property of La Crosse Technology Ltd and must be returned to La Crosse Technology Ltd Replacement parts and products assume the remaining original warranty
5. ects within the product itself and does not cover the cost of installation or removal from a fixed installation normal set up or adjustments claims based on misrepresentation by the seller or performance variations resulting from installation related circumstances LA CROSSE TECHNOLOGY LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL CONSEQUENTIAL PUNITIVE OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION THIS PRODUCT IS NOT A TOY KEEP OUT OF CHILDREN S REACH This warranty gives you specific legal rights You may also have other rights specific to your State Some States do not allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you For warranty work technical support or information please contact La Crosse Technology Ltd 2817 Losey Blvd S La Crosse WI 54601 Phone 608 782 1610 Fax 608 796 1020 For online contact support e mail www lacrossetechnology com support For information on other products visit www lacrossetechnology com Page 7 of 8 All rights reserved This handbook must not be reproduced in any form even in excerpts or duplicated or processed using electronic mechanical or chemical procedures without written permission of the publisher This handbook may contain mistakes and printing errors The informatio
6. lash Use the and F C buttons to select the correct date To Change the Temperature Units To change the temperature reading between Fahrenheit or Celsius press the F C button To Set the Time Alarm 1 To turn the alarm on Press the ALM button The LCD will display the alarm icon 2 To set the Alarm Time Hour Press and hold down the ALM button for 3 seconds until the hours digits flash Use the button to set the hour Press the ALM button to confirm your setting and move to setting the minutes 3 To set the Alarm Time Minutes The Minutes digits of the Alarm Time will flash Use the button to set the minutes You can hold the button in to speed up the setting of minutes by using five minute increments Press the ALM button to confirm your minutes setting and to end the setting procedure 4 To activate or deactivate the daily alarm Briefly press the ALM button once When the alarm is active the clock displays the alarm icon in the upper right corner When the alarm is deactivated the alarm icon will not display 5 About the Time Alarm After 15 seconds without pressing any button the clock switches automatically from alarm setting mode to normal clock mode To Use The Alarm The alarm can be silenced by pressing any button If it is not silenced it will sound for 2 minutes before stopping on its own The alarm repeats automatica
7. lly after 24 hours Page 4 of 8 If the SNZ button is pressed the alarm will silence for approximately 5 minutes after which it will begin to sound again The alarm uses 3 different patterns of tone beginning gently and increasing in intensity known as a Crescendo Alarm Battery Replacement Information To replace the battery 1 Lift up the battery compartment cover and remove the battery 2 Please take note to install the battery with the proper polarity as it relates to the battery diagram inside the battery compartment The battery will fit tightly To avoid start up problems please ensure that the battery does not spring free 3 Replace compartment cover take any used batteries to an authorized depot 4 Help us to keep our environment clean Please for recycling Mounting the Unit The clock can be set on a table or mounted onto a wall Table Standing An easel type foldout stand is located on the bottom of the back side of the clock Pull the easel out from the bottom to open it Wall Mounting Select a place to mount the clock Install a mounting screw not included Align the hanging hole to the mounting screw and ensure that the clock locks down into place before releasing it Online Resources Visit the WT 8002 page online at http www lacrossetechnology com 8002 Care and Maintenance Extreme temperatures vibration and shock should be avoided as these may cause damage to the u
8. n in this handbook is regularly checked and corrections made in the next issue We accept no liability for technical mistakes or printing errors or their consequences All trademarks and patents are acknowledged Ver 1 11 17 09 Printed in China Page 8 of 8
9. nit and give inaccurate readings Precautions shall be taken when handling batteries Injuries burns or property damage may be resulted if batteries are in contact with conducting materials heat corrosive materials or explosives Batteries should be taken out of the unit before it is stored for a long period of time Page 5 of 8 Immediately remove all low power batteries to avoid leakage and damage Replace only with new batteries of the recommended type When cleaning the display and casings use a soft damp cloth only Do not use solvents or scouring agents as they may mark the LCD and casings Do not submerge the unit in water Furthermore fix all parts in place where the units are adequately protected against moisture and rain Special care shall be taken when handling a damaged LCD display The liquid crystals can be harmful to user s health Do not make any repair attempts to the unit Contact the La Crosse Technology Warranty Department for help Opening and tampering with the unit may invalidate their guarantee Never touch the exposed electronic circuit of the device as there is a danger of electric shock should it become exposed Do not expose the units to extreme and sudden temperature changes as this may lead to reduce their accuracy Troubleshooting Battery Battery problems are the single largest cause of customer support cases A few things to check e Use a fresh battery Please use a plain Alk
10. steps often refer to two buttons and F C The button is used to increase setting values and the F C button is used to decrease setting values To enter setup mode and begin the configuration process press and hold the SET button for about 3 seconds or until the clock beeps The display is now flashing 12 Hr and you are ready to begin configuring your clock 1 Set 12 or 24 Hour Time Mode With the display flashing 12 Hr press the or F C button to select either a 12 or 24 hour time mode 2 Set Time Hour Once you have chosen 12 or 24 hr time mode press the SET button again and the Hour digits will begin to flash Use the and F C buttons to select the correct hour 3 Set Time Minute Once the hour is set press the SET button again and the Minutes digits will flash Use the and F C buttons to select the correct minute 4 Set Date Year Once the minute is set press the SET button again and the Year digits will flash Use the and F C buttons to select the correct year Page 3 of 8 5 Set Date Month Once the year is set press the SET button again and the Month digits will flash Use the and FC buttons to select the correct month 6 Set Date Date Once the month is set press the SET button again and the Date digits will f
Download Pdf Manuals
Related Search