KitchenAid Sinks 8534966 User's Manual
Contents
1. pilot hole on the inside edge of the line that was traced onto the countertop Set jigsaw blade into the pilot hole and cut along the outline traced on the countertop Prepare the sink 3 Remove any protective film plastic bag and or tape from the sink Install hardware 4 Assemble clamps attach the assembled clamps to the sink in their install positions claws resting against sink or pointing away from the countertop Check sink fit adjust 5 Set the sink into the countertop opening in the desired position see Figure 1 The countertop opening may need to be adjusted for the sink Proper fit may be accomplished with the jigsaw and or file Care should be taken not to chip or crack the countertop material by aggressive filing or sawing The sink rim should rest evenly on the countertop Remove sink turn upside down and proceed to step 6 Install sink 6 Place a continuous bead of silicone sealant around the entire perimeter of the sink rim Lift the sink turn it right side up and lower back into the countertop cutout opening in the desired position see Figure 1 Move all clamps to their mount positions claws pointing away from the sink under the countertop Begin tightening clips see Figure 2 but do not overtighten It is only necessary to draw the sink rim down firmly to the countertop Tighten until the entire sink rim is sealed Wipe off any excess sealant from the countertop with a dry cloth Gc Fi2. 1 1 2 38 mm thick at the sink rim Solid surface countertop installations must be performed by a qualified fabricator installer with appropriate tools Installation Instructions e As with all metal objects follow proper handling techniques e The sink installation must comply with national and local plumbing codes and ordinances e This sink should be examined for damage prior to installation Do not install a damaged sink Return the sink to the dealer from whom you purchased it Failure to do so will void the warranty Clamp positions All provided clamps have two positions The install position refers to the position of the hardware as it is attached or attaches to the sink when the claw portion is NOT pointed to the outer edges of the sink rim This position allows the sink to fit through the countertop opening The mount position refers to the hardware as it is attached or attaches to the sink with the claw portion pointed toward the outer edges of the sink rim This position allows the sink to be clamped to the countertop via the claws Installing in countertop Prepare countertop 1 Locate template in sink package NOTE If no template is provided contact KitchenAid see Requesting Assistance or Service section Set template on countertop surface in desired position Hold template down firmly and trace around the template with a pencil onto the countertop Remove the template 2 Drill a 3 8
3. Dealer Plumbing Contractor Home Center or E tailer Or call our Customer Interaction Center at 1 800 422 1230 from anywhere in the USA or write CIC Center KitchenAid Brand Home Appliances Customer Interaction Center 553 Benson Road Benton Harbor MI 49022 2692 In the event of a warranty claim the owner will be required to provide proof of purchase and a complete description of the problem This warranty supersedes all other warranties expressed or implied Keep this book and your original invoice together for future reference You must provide proof of purchase or Dealer Name installation for in n ice installation date for in warranty service Address Write down the information about your sink in the box to the right to better help you obtain assistance or service if Phone Number you ever need it Product Model Number Color and Finish Purchase Date Requesting Assistance or Service If you need assistance or service in U S A Call the KitchenAid Customer Interaction Our consultants provide assistance with Center toll free at 1 800 422 1230 e Features and specifications on our full line of sinks Our consultants are available to assist you e Installation information When calling Please know the purchase date and e Use and maintenance procedures the complete model of your sink This e Accessory and repair parts sales information will help us better respond e Specialized customer assistance Spa
4. KitchenAid Top Mount Sinks Installation Instructions and Use amp Care Guide Quick Reference Table of Contents Pages Tools and Parts Installation Requirements Installation Instructions Use amp Care Guide Warranty Requesting Assistance or Service Part No 8534966 Installation requirements Tools and Parts Assemble the required tools and parts before starting installation Read and follow the instructions provided with any tools listed here Tools needed This section does not include new installations in solid surface countertops See Countertop Requirements section e drill e 3 8 drill bit jigsaw e file e tape measure e pencil e long handled Philips screwdriver e long handled flat blade screwdriver e silicone sealant Silicone caulk sealant must meet the qualifications of ASTM C920 FDA regulation no 21 CFR 177 2600 NSF 51 Dow Corning 786 is recommended Parts and materials needed e faucet with check valve and accompanying plumbing supplies as needed e strainer basket Parts supplied sink e sink template e sink mounting hardware clamps Installation Instructions Use and Care Guide Plumbing requirements Sink should be plumbed to local plumbing codes All plumbing connections should be made by licensed qualified plumbers Countertop requirements The thickness of the countertop must not be more than
5. gure 2 e Tighten clamps gradually in a sequence similar to that shown Use amp Care Guide Do routine cleaning To maintain luster Use soap warm water and sponge Rinse thoroughly Use a small amount of mineral oil on a soft cloth Apply and wipe dry evenly to the entire surface of the sink and buff to a To remove stubborn stains shiny finish Use any cleaner acceptable for use on stainless steel Do not use steel wool scouring pads steel brushes Always rub in the direction of the grain Rinse etc Their particles may become embedded in the sink thoroughly and wipe dry surface and cause a rusty discoloration Do not use rubber mats They trap water causing iron deposits and surface discoloration Warranty LIFETIME LIMITED WARRANTY For the lifetime of the product from the date of purchase when this sink is installed operated and maintained according to instructions attached to or furnished with the product KitchenAid will replace sinks found to be defective in materials or workmanship with an equivalent stainless steel sink supplied by KitchenAid KitchenAid reserves the right to inspect any sink reported to be defective prior to replacement This Lifetime Limited Warranty is offered to the original owner of the sink KitchenAid WILL NOT Pay For e Service calls to correct the installation of your sink to instruct you on how to use your sink to replace house fuses or correct house wiring or plumbing e Repairs when
6. nish speaking to your request hearing impaired limited vision etc e Referrals to local dealers service companies and repair parts distributors For further assistance If you need further assistance you can write to KitchenAid with any questions or concerns at KitchenAid Brand Home Appliances Customer Interaction Center 553 Benson Road Benton Harbor MI 49022 2692 Please include a daytime phone number in your correspondence KitchenAid HOME APPLIANCES Part No 8534966 Registered Trademark Trademark of KitchenAid U S A Dow Corning is a registered trademark of Dow Corning Corporation 2003 All rights reserved 7 2003 Printed in U S A
7. your sink is used in other than normal single family household use e Damage resulting from accident alteration unauthorized modification misuse abuse such as heavy impact or dropped objects fire floods acts of God improper installation or installation not in accordance with local electrical and plumbing codes or use of products not approved by KitchenAid e Damages resulting from improper care or maintenance e Damages resulting from improper application such as exposure to corrosive chemical photographic solution etc e Any unauthorized modifications made to the product after it leaves KitchenAid or its suppliers premises whether performed by a contractor service company or yourself e Any labor cost during the limited warranty period e Replacement parts for units operated outside the United States e Pickup and delivery This product is designed to be serviced in the home KITCHENAID SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES Some states do not allow the exclusion or limitation of incidental or consequential damages so this exclusion or limitation may not apply to you This warranty gives you specific legal rights and you may also have other rights which may vary from state to state Outside the 50 United States this warranty does not apply Contact your authorized KitchenAid dealer to determine if another warranty applies If you believe that you have a warranty claim contact KitchenAid through your
Download Pdf Manuals
Related Search