Havis-Shields C-3190-F User's Manual
Contents
1. 900 with questions amp or comments Consolidator Kwik Raze Collins Dynamics Kwik Kit PrisonerTransports K 9Transports 75 Jacksonville Rd P O Box 2099 Warminster PA 18974 800 524 9900 215 957 0720 P 215 957 0729 F www Havis com C 3190 F INST 10 062. Havis Shields EQUIPMENT CORPORATION INSTALL INSTRUCTIONS C 3190 F 1996 2007 FORD CROWN VICTORIA TOOLS REQUIRED 7 16 wrench and socket Power Drill and 4 drill bit HARDWARE QTY DESCRIPTION PART 8 4 20 x 1 Hex Head Cap Screw GSM33002 12 4 Flat Washer GSM31005 12 4 20 Hex Head Flange Nut GSM30023 8 Y4 20 x 2 Hex Head Cap Screw GSM33000 4 3 8 16 Hex Nut GSM30008 l 12 4 Loom PRM97913 Step 1 Slide Tray out of housing Step 2 Place left and right support arms in place and fasten down with 4 4 20 x 2 hex head cap screws and 4 4 flat washers Step 3 Place lock arms in place with 4 4 20 x 2 hex head cap screws and 4 4 flange nuts Note Do not tighten down lock arms at this time Place 4 20 x 1 2 hex head cap screws from bottom to top on lock arms Step 4 Slide tray back into housing Adjust lock arms then tighten from bottom Step 5 Place radio tray on back shelf in trunk Align rear support bracket with existing holes in trunk using 4 14 20 x 1 hex head screws 4 4 flat washers 4 4 flange nuts and 4 3 8 16 hex nut spacers Note On 2005 and newer models Hex Nut spacers must be installed between rear support bracket and OEM Sheet metal This will space tray off seat wall so not to crush fuel pump harness Loom is provided to cover harness for extra protection Step 6 Drill 4 hole into trunk hinge support base on drivers and passenger
3. side and fasten down shelf by using 4 4 20 x 1 hex head cap screw 4 4 flat washer and 4 1 4 x flange nut C 3190 F INST 10 06 TECHNICAL SERVICE BULLETIN Subject Trunk Tray Installation Part C 3190 F Full Width Tray Vehicle 2005 and newer Ford Crown Victoria Police Interceptor Problem The Fuel Pump wire harness on 2005 mid model year Crown Victoria s and newer is now routed on the rear trunk side of seat strainer metal framework behind rear seat The location of this harness now interferes with the mounting bracket for the Havis Shields full width trunk tray Harness is subject to being pinched by bracket Solution The mount plate that connects to the seat strainer must be spaced out so it will not damage harness In addition to the original hardware kit four 4 GSM30008 3 8 16 hex nuts and one 1 foot PRM97913 protective wire loom must be used One 1 3 8 16 hex nut spacer is used with each of the four 1 4 x 1 bolts between the seat strainer and tray mount plate The protective wire loom must be wrapped around wire harness before mount plate is fastened Check Before and after all hardware is tightened make sure wire harness is not pinched NOTE Havis Shields Part C 3190 Drivers Side Trunk Tray mounting should not be affected The harness can easily be moved out of the way Havis Shields is committed to quality workmanship and Technical Support Please contact our team at 1 800 524 9
Download Pdf Manuals
Related Search