Graco 406813C User's Manual
Contents
1. GENUINE GRACO PARTS AND ACCESSORIES gt g GRACO Air Valve Seal Kits E Husky 1050 Diaphragm Pumps EN Kits 24B769 and 24C983 Ref Description Qty Ref Description Qty 206 O RINGS end cap 2 219 O RING for Kit 24B769 used for DataTrak 1 208 U CUPS piston 2 models with runaway protection 209 SCREW 2 108 GASKET air valve not shown 1 Kit 24B769 M3 shorter for metal pumps GREASE lithium based not shown 1 and 4 longer for plastic pumps Kit 24C983 M3 F See reverse for assembly directions All other models 206 A DataTrak Models with Runaway Protection O Ke i 219 A Apply lithium based grease S U cup lips must face piston SZ A APPIy lithium based grease to Pad contact surface housing Graco Inc P O Box 1441 Minneapolis MN 55440 1441 406813 Revision C December 2012 Copyright 2009 Graco Inc is registered to ISO 9001 PROVEN QUALITY LEADING TECHNOLOGY Assembly NOTE Apply lithium based grease whenever instructed to grease 1 Use all parts in the repair kits as applicable to your pump Clean other parts and inspect for damage Replace as needed Grease the detent cam 204 and install into housing Grease the u cups 208 and install on the piston with lips facing toward the center of the piston Grease both ends of the piston 202 and install it in the housing with the flat side toward the cup 213 Be careful not to tear u cups 208 when sliding pis to2. n into housing Standard or Pulse Count models no runaway protection solenoid Grease new o rings 206 and install on the end caps Install the end caps into the housing DataTrak models with runaway protection sole noid Invert the air valve with the air inlet facing away from you Grease and install new o ring 206 on right side end cap Grease and install new o ring 206 and the solenoid release button and o ring 219 on left side end cap Install the end caps into the housing Install a retaining ring on each end to hold end caps in place Grease and install the detent assembly 203 into the piston Install the o ring 214 on the cup 213 Apply a light film of grease to the outside surface of the o ring and the inside mating surface of the base 212 Install the cup 213 on the base 212 Install the spring 211 onto protrusion on the cup Install the cup assembly Align the small round magnet in the base with the air inlet Grease the cup side and install the valve plate 205 Align the small hole in the plate with the air inlet Tighten the screws 209 to hold it in place 406813C
Download Pdf Manuals
Related Search