GE TS Series Installation Guide
Contents
1. GE Lighting Installation Guide Lumination LED Track Light TS Series BEFORE YOU BEGIN Read these instructions completely and carefully FOR USE WITH CEILING MOUNTED TRACK ONLY READ JUNO TRACK INSTALLATION INSTRUCTIONS FOR GUIDELINES ON TRACK INSTALLATION A WARNING RISK OF ELECTRIC SHOCK Turn power off before inspection installation or removal A CAUTION To reduce risk of fire and electric shock use only with Juno single circuit track system imagination at work IMPORTANT SAFETY INSTRUCTIONS When installing or using this track system basic safety precautions should always be followed including the following a Read all instructions b Do not install this track in damp or wet locations c Do not cut any track sections d Do not install any part of a track system less than 5 feet above the floor e Do not install any luminaire assembly closer than 6 inches from any curtain or similar combustible material f Disconnect electrical power before adding to or changing the configuration of the track g Do not attempt to energize anything other than lighting track luminaires on the track To reduce the risk of fire and electric shock do not attempt to connect power tools extension cords appliances and the like to the track h Do not connect a track to more than one branch circuit unless the track is constructed so that it can be used with more than one branch circuit Check with a2. mful interference and 2 this device must accept any interference received including interference that may cause undesired operation This Class B RFLD complies with the Canadian standard ICES 003 Ce DEFR de la classe B est conforme la NMB 003 du Canada Note This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense Fixture intended for commercial use only Use only in non insulated applications GE Lighting 1 888 MY GE LED 1 888 69 43 533 www gelighting com GE Lighting Solutions LLC is a subsidiary of the General Electric Company The GE brand and logo are trademarks of the General Electric Company 2014 GE Lighting Solutions LLC Information provided is subject to change without notice All values are design or typical values when measured under laboratory conditions IND130 100914
3. qualified electrician Although the track lighting system may seem to operate acceptably a dangerous overload of the neutral may occur and result in a risk of fire SAVE THESE INSTRUCTIONS For future reference when adding fixtures or changing the track configuration Fixture Installation Single Circuit Track Align locking tab Rotate with polarity line Tab snaps into track 1 Hold the adapter below the Rotate adapter 1 4 turn 90 Release the locking tab and the track with your thumb on the clockwise fixture should snap into position spring loaded locking tab Ensure Turn the fixture on by the switch locking tab is positioned directly below the polarity line Push adapter into track Fixture Installation Two Circuit Track Positive Contact Positive Contact in raised postion Lift with screwdriver Contact Support 1 For Two Circuit installation the Insert a Contact Support 3 To attach fixture to Track Positive Contact marked P under the raised Positive proceed the same as with Single must be in raised position Raise Contact These Positive Contact Circuit Track attachment Positive Contact by inserting Supports are supplied with all a thin screwdriver under the Juno Two Circuit Track sections contact and lifting upward This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause har
Download Pdf Manuals
Related Search