FMI FEF26 User's Manual
Contents
1. Before attempting to perform any maintenance on this appliance turn all controls to the OFF position and unplug Allow the appliance to be OFF for at least 10 minutes before performing any maintenance in order to allow all components to cool properly Replacing Light Bulbs e Make sure that all controls are off and that the appliance is unplugged e Wear latex gloves to ensure that grease oil from your hands does not transfer to the bulbs e Take hold of each side of the bulb cover panel at the bottom of the firebox and pull straight out See Fig 5 You can see three 40W light bulbs in the firebox See Fig 6 e Examine the light bulbs to determine which bulbs require replacement e Remove the burnt out bulb and replace with a new 40W bulb do not over tighten e Replace the cover panel See Fig 7 A WARNING DO NOT EXCEED THE RECOMMENDED BULB WATTAGE e Replace the bulb cover panel Cleaning remove dust from glass window use clean dry cloth e remove fingerprints or other marks from glass window use clean damp cloth Do not spray glass cleaner or other liquids directly onto the window e Clean metal surfaces with a clean damp cloth making sure not to push dust or debris into any air intake or exhaust vents e Do not use abrasive cleaners or spray liquids on any part of the appliance Periodic cleaning vacuuming of the fan heater unit is strongly recommended to ensure that no dirt or foreign ob2. and unattended 4 Do not operate the heater if the power cord or plug has been damaged or the heater has been damaged or malfunctioned in any way Take the appliance to an authorized service facility for examination electrical or mechanical adjustment or repair Do not use outdoors This heater is not intended for use in bathrooms laundry areas and similar indoor locations Never locate heater where it may fall into a bathtub or other water container To disconnect the appliance turn all controls OFF and then remove the plug from the electrical outlet 8 The appliance comes equipped with a 3 prong grounding plug Do not cut the grounding prong Connect to properly grounded 120V outlets only 9 Do not insert or allow foreign objects to enter any ventilation or exhaust openings as this may cause an electric shock or fire or damage the appliance 10 To prevent a possible fire do not block air intakes or exhausts in any manner Do not use on soft surfaces like a bed where openings may become blocked 11 All electrical heaters have hot and arching or sparking parts inside Do not use in areas where gasoline paint or flammable liquids are used or stored or where the appliance will be exposed to flammable vapors 12 Avoid using the appliance with an extension cord Extension cords may overheat and cause risk of fire If an extension cord MUST be used the cord must 16AWG minimum size and rated not less than 1875 Watts
3. F2609E 26 IN ELECTIC FIREPLACE mi MODEL FEF26 FMI PRODUCTS LLC Optional face trim kit model FT26 FMI products LLC 1 TABLE OF CONTENTS ANENA AVS CATION Care and Maintenance A SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble operate or install the product A WARNING Any use of this appliance other than that recommended by the manufacturer in this owners manual may cause fire burns electric shock and or other serious injuries or death When using electrical appliances basic precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following 1 Read the manufacturers instructions completely before using this appliance 2 This appliance will become hot when in use avoid burns do not let bare skin touch hot surfaces The grill at the top of this heater in particular will become hot when the heater is active Take special care not to block the air intake or exhaust vents 3 Extreme caution is necessary when the appliance is used by or near children or invalids and whenever the heater is left operating
4. The extension cord must be a 3 prong cord with grounding type plug and cord connection and should not exceed 20 6m in length 13 When transporting or storing the heater take care to keep both the unit and power cord plug dry free from excessive vibration and away from heat sources 14 Use the heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons 15 Do not attempt to burn wood or other materials in this heater OPERATING INSTRUCTIONS Read all instructions and warning prior to operating the appliance Ensure that all controls are in the OFF position before plugging the appliance in to a properly grounded electrical outlet The control panel of the appliance is located behind the wire grate above the window on the front Fig 1 Grate fold down to reveal control panel Fig 2 HEAT T SETTING 55 2 77 5 22 S S x 750W 68 O 1500W 59 AUTO SET TEMP F OFF 26 3 8 ON OFF mn 7 E D C B A Using the Control Panel and the Remote Control Simulated Flame Effect Push button A power ON OFF Push button D to turn the flame ON OFF D Push button to flame brightness Heat Setting Push button once to activate low heat setting Push button C second time to activ
5. al or rental usage this warranty is limited to 90 days from the date of first purchase Factory Reconditioned Products Limited Warranty FMI PRODUCTS LLC warrants factory reconditioned products and parts thereof to be free from defects in material and workmanship for 30 days from the date of first purchase from an authorized dealer pro vided the product has been installed maintained and operated in accordance with FMI PRODUCTS LLC s warnings and instructions Terms Common to All Warranties The following terms apply to all of the above warranties Always specify model number and serial number when contacting the manufacturer To make a claim under this war ranty the bill of sale or other proof of purchase must be presented This warranty is extended only to the original retail purchaser when purchased from an authorized dealer and only when installed by a qualified installer in accordance with all local codes and instructions furnished with this product This warranty covers the cost of part s required to restore this product to proper operating condition and an allowance for labor when provided by a FMI PRODUCTS LLC Authorized Service Center or a provider approved by FMI PRODUCTS LLC Warranty parts must be obtained through authorized dealers of this product and or FMI PRODUCTS LLC who will provide original factory replacement parts Failure to use original factory replacement parts voids this warranty Travel handling transportation d
6. ate high heat setting SETTING Push button third time to activate the AUTO function Turn thermostat B dial to desired setting Push button C fourth time to shut heater off NOTE Flame and or heat can work separately or together 4 INSTALLATION INSTRUCTIONS PLUGGING IN THE HEATER Refer to Fig 4 This heater is for use 120 Volts The heater has 3 prong grounded plug fig A If your electrical outlet has only 2 slots fig B you will have to use an adapter fig C to convert from the 3 prong power cord to a 2 slot receptacle The green grounding plug extending from the adapter must be securely connected to a permanent ground such as a properly grounded outlet box The adapter should only be used if a proper 3 slot receptacle is not available NOTE Adapters are not allowed for use in Canada Fig 4 METAL COVER OF GROUNDED GROUNDING PIN A OUTLET BOX ADAPTER 3 4 1 2 Note The height that a combustible mantel is fitted GROUNDING above the heater NOT ALLOWED MEANS is dependent on IN CANADA the height of the front selected The minimum height is 1 above the front D Framing Heater for New Construction Renovation 15 AMP circuit is required to operate this appliance If the breaker trips when the appliance is running you may need to move the appliance to another location or unplug other appliances that are on the same circuit CARE AND MAINTENANCE A WARNING
7. iagnostic material labor and incidental costs associated with warranty repairs unless expressly covered by this warranty are not reimbursable under this warranty and are the responsibility of the owner Excluded from this warranty are products or parts that fail or become damaged due to misuse accidents improper installation lack of proper maintenance tampering or alteration s This is FMI PRODUCTS LLC s exclusive warranty and to the full extent allowed by law this express warranty excludes any and all other warranties express or implied written or verbal and limits the duration of any and all implied war ranties including warranties of merchantability and fitness for a particular purpose to one 1 years on new products and 30 days on factory reconditioned products from the date of first purchase FMI PRODUCTS LLC makes no other warranties regarding this product FMI PRODUCTS LLC s liability is limited to the purchase price of the product and FMI PRODUCTS LLC shall not be liable for any other damages whatsoever under any circumstances including indirect incidental or consequential damages some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights which vary from state to state For information about this warran
8. jects build up TROUBLESHOOTING A WARNING Turn off the appliance unplug and let cool for at least 10 minutes before attempting to service Only a qualified professional should attempt to service or repair the appliance Problem Flame is dim or not present The appliance turns off and will not turn back on The appliance does not turn on when the button is pushed to Remote control does not work Possible Cause Dimmer control button is set too low Light bulbs are burned out Flame wand has come loose from bracket Flame wand motor is not functioning The overheat protection device in the appliance has been triggered House circuit breaker has been tripped The overheat protection device in the appliance has been triggered Low batteries Manual controls on the appliance must be before operating the remote control Remove back panel Corrective Action Push button E to increase light Inspect light bulbs and replace if necessary see Maintenance section of this manual Secure end of flame wand back into the support bracket Call FMI Technical Service at 1 866 328 4537 Turn all controls off unplug the appliance allow to cool for at least 10 minutes then plug back in and restart Reset house circuit breaker Turn all controls off unplug the appliance allow to cool for at least 10 minutes then plug bac
9. k in and restart Replace all batteries in the remote control Push the appliance ON using the manual control panel then use remote control to operate If using the remote control to operate the appliance you must also turn the appliance ON using the remote control ILLUSTRATED PARTS BREAKDOWN MODEL FEF26 6 12537401 11 8 12537601 HANDLE 9 123701 FLAMERODASSEMBLY 1 TRIM KIT ORDERED 125396 01 REMOTE SENSOR 125397 01 REMOTE CONTROL 125398 01 MAGNETS 1 FMI PRODUCTS LLC 2701 S Harbor Blvd Santa Ana CA 92704 1 866 328 4537 www fmiproducts com 8 WARRANTY KEEP THIS WARRANTY Model located on product or identification tag Date Purchased Keep receipt for warranty verification PRODUCTS LLC LIMITED WARRANTIES New Products Standard Warranty FMI PRODUCTS LLC warrants this new product any parts there of to be free from defects in material and workmanship for a period of one 1 years from the date of first purchase from an authorized dealer provided the product has been installed maintained and operated in accordance with FMI PRODUCTS LLC s warn ings and instructions For products purchased for commercial industri
10. ty contact Fmi FMI PRODUCTS LLC 2701 S Harbor Blvd 125342 01 Santa Ana CA 92704 Rev A 1 866 328 4537 05 10 www fmiproducts com 9
Download Pdf Manuals
Related Search