Fisher-Price COZY TIME 79658 User's Manual
Contents
1. Do not dispose of a battery in a fire The battery may expolode or leak e Never short circuit the battery terminals Anon rechargeable battery is not to be recharged Only a battery of the same or equivalent type as recom mended in the Battery Installation instructions is to be used If a removable rechargeable battery is used it is only to be charged under adult supervision e A rechargeable battery is to be removed from the toy before it is charged If you use a battery charger it should be examined regularly for damage to the cord plug enclosure and other parts Do not use a damaged battery charger until it has been prop erly repaired We recommend the use of alkaline batteries for longer battery life Operation amp Use IMPORTANT Before each use inspect this product for damaged hardware loose joints missing parts or sharp edges Do not use if any parts are missing or broken Contact Fisher Price for replacement parts and instructions if needed Never substitute parts A WARNING Failure to follow these warnings and instructions could result in serious injury or death e To prevent falls Never place product on an elevated surface e To prevent strangulation Never place items with a string such as hood strings or pacifier cords around child s neck Never place product near a window net fice down where cords from blinds or drapes e Pull the back stand toward the WARNING label on the liner ca2. e Press to fasten the fasteners on the pad and the liner Fisher Price Inc a subsidiary of Mattel Inc East Aurora NY 14052 U S A Printed in China 2001 Mattel Inc All Rights Reserved and designate U S trademarks of Mattel Inc 79658pr 0920
3. liner e Push down on the back stand to snap it into place Turn the bassinet upright e While lifting the latches on each side of the handle fold the foot of the bassinet toward the canopy e Fasten the buckles on each side of the bassinet 11 Care FCC Statement United States Only Machine wash the pad and toys in cold water and a mild detergent Do not use bleach Tumble dry on low heat and This equipment has been tested and found to comply with the lim tly Surf h the f li rent its for a Class B digital device pursuant to part 15 of the FCC rules baa anne r Hes oe d S ene ap ae These limits are designed to provide reasonable protection against Dee ua ee ee ee eee te Use Dieacn harmful interference in a residential installation This equipment Do not use harsh or abrasive cleaners Rinse clean with water generates uses and can radiate radio frequency energy and if not to remove residue installed and used in accordance with the instructions may cause To Remove the Pad harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation Liner If this equipment does cause harmful interference to radio or televi sion reception which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increa
4. waist belts to the buckles on each side of the restraint pad Make sure you hear a click on both sides e Check to be sure the restraint is securely attached by pulling it away from your baby The restraint should remain attached e Attach the toys to the canopy straps When Putting Baby to Sleep e NEVER place any covering higher than an infant s shoulders e NEVER place infants to sleep on pillows sofa cush ions adult beds waterbeds beanbags or any other surface not specifically designed for infant sleep Do not overdress your baby If you feel comfortable your baby will too This important safety message is brought to you by the Juvenile Products Manufacturers Association Anchored End Anchored End Free End Free End Tighten Buckle Buckle Loosen To tighten the waist belts Feed the anchored end of the waist belt up through the buckle to form a loop Q e Pull the free end of the waist belt O e Repeat this procedure to tighten the other waist belt To loosen the waist belts e Feed the free end of the waist belt up through the buckle to form a loop Q Enlarge the loop by pulling on the end of the loop toward the buckle e Pull the anchored end of the waist belt to shorten the free end of the waist belt O e Repeat this procedure to loosen the other waist belt Note After adjusting the waist belts to fit your child make sure you pull on them to be sure they are securely
5. Fisher Price Cozy Time Bassinet Model Numbers 79658 79659 Please keep this instruction sheet for future reference as it contains important information Tool needed for assembly Phillips screwdriver not included Requires one C LR14 alkaline battery not included for operation Use only for a child who is unable to push up on hands and knees pull up or sit unassisted Warnings A WARNING Failure to follow these warnings and instructions could result in serious injury or death To reduce the risk of Sudden Infant Death Syndrome SIDS normal healthy infants should always sleep on their backs unless otherwise advised by a pediatrician e Infants can suffocate In gaps between an extra pad and side of the bassinet On soft bedding e Never add a mattress pillow com forter or padding Use ONLY the pad provided by the manufacturer e To prevent falls Do not use this product when infant begins to push up on hands and knees Never place product on an elev ated surface When used as an infant seat always use restraint e To prevent strangulation Never place items with strings such as hood strings or pacifier cords around a child s neck Never place product near a window where cords from blinds or drapes can strangle a child e Never leave child unattended Consumer Information Occasionally a consumer may experience a problem with one of our products If this should h
6. appen please call us toll free rather than return this product to the store Usually we can solve the problem over the telephone or send you replacement parts Please call Fisher Price Consumer Relations toll free at 1 800 432 KIDS 8 AM 6 PM EST Monday through Friday Hearing impaired consumers using TTY TDD equipment please call 1 800 382 7470 Or write to Fisher Price Consumer Relations 636 Girard Avenue East Aurora New York 14052 Parts Handles Back Stand 8 x 1 4 Screw 6 Shown Actual Size Assembly IMPORTANT Before assembly inspect this product for damaged hardware loose joints missing parts or sharp edges A CAUTION This package contains small parts eee in its unassembled state Plastic End Adult assembly is required Button Tube End Sleeve WARNING e While pushing the buttons on the tubes continue to slide the back stand over the buttons Make sure the buttons snap into the holes in the plastic ends of the back stand IMPORTANT If you cannot slide the back stand com pletely onto the tube ends so that the buttons snap into the holes you have probably assembled the back stand incorrectly Turn the back stand around and follow steps 2 and 3 again e Position the liner upside down on a flat surface e Note the locations of the sleeves on each side of the liner near the WARNING label Back Stand Tube End e Locate the tube ends wit
7. fastened Operation amp Use Bassinet Back Adjustment Calming Vibrations Upright Position e You can adjust the bassinet to an upright or recline position for baby s comfort UPRIGHT RECLINE Back of Liner Back of Liner ZA OND e Slide the power button to the ON position to start calming vibrations e Slide the power button to the OFF position to turn off calming vibrations IMPORTANT If vibrations become noticeably slower replace the battery with a new C alkaline battery see page 6 Battery Installation i Portability Buckle Back View To adjust the bassinet to upright Lift the back of the liner and then fasten the buckle Make sure you hear a click To adjust the bassinet to recline e Support the back of the liner with your hand unfasten the buckle and guide the back of the liner down into position Canopy Adjustment Sia N peers AS v i A gt A wen H vn 1 ae a oa lt N e The canopy can be adjusted up or down Fasten the snap on each side of the canopy for the 10 up position Operation amp Use To Fold WARNING Label e Turn the bassinet face down on a flat surface e Rotate the front stand toward the WARNING label on the liner e Push down on the front stand to snap it into place oe2 4 e e Press the button on each side of the back stand and push the back stand toward the NOTICE label on the
8. h red dots on them e Position the back stand so that it leans toward these tube ends Make sure the arrows on the ends of the back stand point toward the tube ends Slide the ends of the back stand onto the tube ends 3 Assembly Tube End Sleeve Now insert the tube ends through the sleeves on each side of the liner Smooth Side of Handle Handle Grip Tube End Position a handle so that the handle grip is toward you The smooth side of the handle should be facing the liner Fit the end of the handle onto one of the tube ends Make sure the handle covers the red dot on the tube end Hint The red dot on the tube end may be hidden by the liner You may need to adjust the liner for a clearer view of the red dot e Repeat this procedure to assemble the other handle Handle Insert a screw through each handle and into the tube end Tighten the screws with a Phillips screwdriver Do not over tighten e Pull on each handle to be sure each is properly secured to the tube end If you can remove one or both you have not assembled them properly Please review assembly steps 5 and 6 again Assembly Remaining Tube Ends e At an angle fit the remaining tube ends into the handles Align the holes in the tube ends with the holes in the handles Insert a screw through the inside of each handle and into the tube ends Tighten the screws with a Phillips screw driver Do not over tighten e Pul
9. l on each handle to be sure each is properly secured to the tube ends If you can remove one or both you have not assembled them properly Please review this assembly step again Front Stand Indents Inside e Fit the ends of the front stand into the indent inside each handle Insert a screw through each handle and into the ends of the front stand Tighten the screws with a Phillips screwdriver Do not over tighten e Pull the front stand to be sure it is properly secured to the handles If you can remove it you have not assembled it properly Please review this assembly step again IMPORTANT Attach the provided pad with restraint system to this product Never use this product without the provided pad e Place the pad in the liner Fit the waist belts through the slots in the pad e Fasten the fasteners on the pad and liner Battery Installation Battery Compartment Door e While inserting a coin or the end of a flat end screwdriver into the slot in the soothing unit remove the battery com partment door Insert one C alkaline battery as shown inside the battery compartment e Replace the battery compartment door and snap it securely closed Battery Tips 1 5V C LR14 SHOWN ACTUAL SIZE e Remove the battery during long periods of non use Always remove an exhausted battery from the product Battery leak age and corrosion can damage this product Dispose of the battery safely
10. n strangle a child until the buttons snap into place Button WARNING Label eine ie ey gt 77 a Liner NOTICE Label Front Stand e Place the bassinet on a flat surface Lift and then push down on the foot of the bassinet until it snaps into place IMPORTANT Be sure both latches have snapped into place e Pull the front stand toward the NOTICE label on the liner Operation amp Use Turn the bassinet upright Check to be sure the bassinet is fully erect e Push down on the bassinet Make sure the buttons on the back stand are snapped into place Restraint System A WARNING Failure to follow these warnings and instructions could result in serious injury or death To reduce the risk of Sudden Infant Death Syndrome SIDS normal healthy infants should always sleep on their backs unless otherwise advised by a pediatrician e Infants can suffocate In gaps between an extra pad and side of the bassinet On soft bedding e Never add a mattress pillow com forter or padding Use ONLY the pad provided by the manufacturer e To prevent falls Do not use this product when infant begins to push up on hands and knees When used as an infant seat always use restraint e Never leave child unattended Operation amp Use Waist Belt Restraint Pad e Place your baby in the bassinet Position the restraint pad between your baby s legs Fasten both
11. se the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from Waist Belts that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help CAUTION Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user s authority to operate the equipment e Feed the waist belts back through the pad e Remove the pad from the liner To Re assemble the Pad A WARNING Failure to follow these warnings and instructions could result in serious injury or death e Infants can suffocate In gaps between an extra pad and side of the bassinet On soft bedding e Never add a mattress pillow com forter or padding Use ONLY the pad p rovided by the manufacturer For other countries outside the United States Canada call 1 800 567 7724 or write to 4 Mattel Canada Inc 6155 Freemont Blvd Mississauga Ontario L5R 3W2 IMPORTANT Attach the provided pad with restraint Great Britain telephone 01628 500303 system to this product Never use this product without Australia Mattel Australia Pty Ltd 658 Church Street Locked Bag 870 the provided pad Richmond Victoria 3121 Australia Consumer Advisory Service 1300 135 312 e Position the pad into the liner p New Zealand 16 18 William Pickering Drive Albany 1331 Auckland e Feed the waist belts up through the slots in the pad
Download Pdf Manuals
Related Search