Fisher & Paykel MOTTK-FP Installation Guide
Contents
1. FISHER amp PAYKEL TRADITIONAL MICROWAVE TRIM KIT INSTALLATION INSTRUCTIONS Before you begin read these instructions completely and carefully Getting Started m Remove packaging Contents Tools Required Part Description 1 8 Drill Trim Assembly 2 Phillip Screwdriver Base Mounting Bracket L R Sheet Metal Screws Installing Trim Kit 1 Cut opening in the cabinet face per the following dimensions Height 17 1 16 0 Width 24 3 4 1 16 0 Note Refer to diagram on the following page The minimum cabinet depth is 20 When installing the Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer please follow the recommendations in the Microwave Installation Use Care Manual 2 Add adequate platform base support in the bottom of the cabinet for trim kit base to rest on 3 Mark a centerline on the front edge of the cabinet bottom Fig 01 4 Place trim kit base and align centerline mark to the triangular notch on the front edge of the base Fig 02 5 Drill 1 8 pilot holes in the cabinet using the base as a template and install a screw through the base into the cabinet bottom to prevent the base from shifting Fig 03 6 Insert Microwave into opening on top of the base The Microwave feet should sit in the recesses on the base for correct alignment The Microwave should be plugged in at this point gt a Place the right and left mounting bra2. cket supports by resting the bottom edges of the supports on the bottom of the cutout Fig 04 The long flange on the side supports should clear the side of the cutout by approximately 1 16 Fig 05 Install top and bottom screws into the cabinet face by first drilling 1 8 pilot holes see inserts 3 and 4 Install trim kit face by inserting top pins of trim into corresponding sockets on the top corners of clip support plates see insert 1 Finish the assembly by inserting the bottom pins into the corresponding sockets on front edge of the base see insert 3 Check for proper door opening clearances Bracket Support on the bottom Fig 05 of cutout Fig 04 HORIZONTAL CLIP ORIENTATION ON MOUNTING BRACKET TOP PIN OF TRIM CABINET a 24 3 4 1 16 0 1 8 HOLE FOR a 5 MOUNTING SCREW SCREW HOLE CENTER INSERT 4 Q LINE MOUNTING gt Ni BRACKET SUPPORT Y TRIM KIT TRIM KT lt lt gt Pe gt 18718 Za BASE CABINET CUT OUT 17 1 16 0 e BOTTOM PIN OF TRIM e SS INSERT 2 X L TRIANGULAR CENTERING N NOTCH HORIZONTAL SCREW HOLE CLIP ORIENTATION LOCATE MOUNTING BRACKET ON BASE IN BOTTOM CORNERS OF CUTOUT INSERT 3 Note when installed the trim assembly is positioned symmetrically over the cabinet cut out Stainless Steel Care This Trim Kit is made of stainless
3. steel Use the mildest cleaning procedure first Start with hot soapy water rinse and dry If the trim kit has food soil remaining try a general kitchen cleaner such as Fantastik Simple Green or Formula 409 Apply cleaner with a damp sponge rinse thoroughly and dry Always scrub lightly in the direction of the grain Do not use a steel wool pad it will scratch the surface To touch up noticeable scratches in the stainless steel sand very lightly with dry 100 grit emery paper rubbing in the direction of the grain After cleaning use a stainless steel polish such as Stainless Steel Magic P N 242601 Rev B 06 14
Download Pdf Manuals
Related Search