Dimplex Indoor Electric Fireplace User's Manual
Contents
1. NORTH AMERICA LIMITED i c iet ui n M W rite your Remote Quality checked by Control Code Number Here QUICK REFERENCE GUIDE FOR THE OPTIFLAME ELECTRIC FIREPLACE Prior to the first use of the fireplace verify the following Are the circuit breakers for the fireplace on Are the light bulbs in your fireplace loose to check follow the instructions for replacing the light bulbs under the maintenance section of this manual The heater on your fireplace may emit a slight harmless odor when first used This odor is a normal condition caused by the initial heating of internal heater parts and will not occur again If your heater does not emit heat ensure the large switch is on that the first two red indicator lights are on for BF30E both switches on the unit should be on and there are no red indicator lights the wall thermostat is set above the current room temperature and any wall switches for the unit are on If this does not work switch the unit off for 5 minutes and try again Consult operation section of your practical users guide for further information The information regarding the model of your fireplace can be found on the rating plate located under the logs If you have any technical questions questions regarding the operation of your fireplace or require service for your fireplace contact Dimplex North America customer service at 1 888 DIMPLEX 1 888 346 72. Do not strike fireplace glass Always use a certified electrician for installation Disconnect all power coming to fireplace at main service panel before performing any cleaning or maintenance When transporting or storing the fireplace keep in a dry place free from excessive vibration and store as to avoid damage CAUTION Procedures and techniques which if not carefully followed will result in damage to the equipment WARNING Procedures and techniques which if not carefully followed will expose the user to the risk of fire serious injury illness or death Remove To access the light bulb area Open steel curtain remove glass doors if applicable Remove two screws on log grate and remove Pull rear edge of ember bed up and forward by grasping ember bed by the sides handle the logset only by the emberbed and not the logs and pulling solidly until the rear tab pops out from under the back ledge then lift out Pull the left side of the rotating element up and out of the bracket Swing the rotating element out of the way just enough to access the light bulbs being carefull not to damage the mounting spring Examine the bulbs to determine which bulbs require replacement Unscrew bulbs counter clockwise Insert new bulbs Install the rotating element back into the mounting bracket ensuring that the rubber grommet is fully seated Replace the log by inserting front edge
3. and pushing the back down until rear tab snaps under back ledge and the logs are resting against mirror 10 Replace log grate using two screws previously removed Logset o Log grate Pull up on Rotating element Light bulbs MAINTENANCE WARNING Disconnect all power coming to fireplace at main service panel before attempting any maintenance or cleaning to reduce risk of fire electric shock or damage to persons Light Bulb Replacement Light bulbs need to be replaced when you notice a dark section of the flame There are two bulbs which generate the flames and embers Tool Requirements Slot Screw Driver Bulb Requirements Quantity of 2 clear chandelier or candelabra ase 60 watt rating Example GE light bulbs to pe UTION pos P watts per bulb og only apply force to the not directly to the logs eplace all light bulbs at one time if they are close to d life Group replacement will reduce the number open the unit to replace light bulbs Long life nded to reduce the frequency of bulb changes OPERATION FIGURE 1 REMOTE CONTROL The Optiflame fireplace is supplied with a radio frequency remote control all models except BF30E This remote control has a range of approximately 50ft 15 25m it does not have to be pointed at the fireplace and can pass through most obstacles including w
4. including the following 1 2 Read all instructions before using this fireplace This fireplace is hot when in use To avoid burns do not let bare skin touch hot surfaces The trim around the heater outlet becomes hot during heater operation Keep combustible materials such as furniture pillows bedding papers clothes and curtains at least 3 feet 0 9m from the front of the unit Extreme caution is necessary when any heater is used by or near children or invalids and whenever the fireplace is left operating and unattended Do not operate any fireplace if the heater has malfunctioned or if the fireplace has been dropped or damaged in any manner Do not use outdoors This fireplace is not intended for use in bathrooms laundry areas and similar indoor locations Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage to the heater To prevent a possible fire do not block air intake or exhaust in any manner All electrical heaters have hot and arching or sparking parts inside Do not use in areas where gasoline paint or flammable liquids are used or stored or where the unit will be exposed to flammable vapors Do not modify this fireplace Use it only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons Do not burn wood or other materials in this fireplace
5. warranties expressed implied or statutory and the Company neither assumes nor authorizes any person to assume for it any other obligation or liability in connection with said product Light bulbs are not covered in the warranty ACCESSORIES Please contact your local dealer for genuine Dimplex accessories Example Glass door kits brass trim cabinets designed to fit your Optiflame fireplace 1 888 DiMPLEx 2CDimplex 1 888 346 7539 NORTH AMERICA LIMITED 1367 Industrial Road 0 Cambridge Ontario Canada N1R 7G8 Approved for use in the United States and Canada Mirror Cleaning The mirror is cleaned in the factory during the assembly operation During shipment installation handling etc the mirror surface may collect dust particles these can be removed by buffing lightly with a clean dry cloth To remove fingerprints or other marks the mirror can be cleaned with a damp cloth using good quality household glass cleaner The mirror should be completely dried with a lint free cloth or paper towel CAUTION e not use abrasive cleaners on mirror surface or spray liquids directly onto any surface CONTENTS IMPORTANT INSTRUCTIONS OPERATION MAINTENANCE WARRANTY amp ACCESSORIES IMPORTANT INSTRUCTIONS PLEASE RETAIN THIS USER S GUIDE FOR FUTURE REFERENCE When using electrical appliances basic precautions should always be followed to reduce the risk of fire electric shock and injury to persons
6. 539 WARRANTY Dimplex Built in Electric Fireplaces are tested and inspected prior to shipment and are guaranteed from defect to the purchaser of each new product Any part which proves to be defective in material or workmanship under normal use within on year will be repaired or replaced without charge The Company will not be responsible for any expense incurred for installation removal from Service or transportation costs Any such defect should be brought to the attention of the Dealer where the product was purchased and is authorized to repair or replace within the terms of this warranty The Company s only obligation under this warranty will be at its sole option to repair or replace any part proving defective or to refund the purchase price thereof The owner user assumes all other risks if any including the risk of any direct indirect or consequential loss or damage arising out of the use of or inability to use the product The warranty will not apply if in the sole judgment of the Company damage or failure has resulted from accident alteration misuse abuse incorrect installation or operation on an incorrect power Source Dimplex requires that all electric fireplace products are to be field serviced when ever possible Dimplex electric fireplaces are covered by a free in home service for the period that the fireplace is under warranty For service call 1 888 DIMPLEX 1 888 346 7539 The foregoing is in lieu of all other
7. alls It is supplied with one of 243 independent frequencies to prevent interference with other units The frequency designation is indicated on the back of the transmitter FIGURE 1 A Remote Control Initialization This procedure is required every time there is a loss of power to the remote control in the fireplace i e power failure breaker tripped main power switch is turned off Ensure that power is supplied through main service panel Access the manual controls remove glass doors if applicable pull right hand edge of right hand steel curtain towards the center of unit FIGURE 2 Locate manual controls refer to FIGURE 3 Activate main power switch red indicator light 1 will flash Press ON button located on the remote control transmitter FIGURE 1 This will synchronize the remote control transmitter and receiver B REMOTE CONTROL USAGE The remote control operates the fireplace levels sequentially The level is increased every time the ON button on the transmitter is pressed The fireplace can be turned off at any point by pressing the OFF button on the remote control transmitter Level 1 The flame effect is turned on and the first red indicator light is activated Level 2 The flame effect remains on the heater is activated to the low heat setting and the first and second red indicator lights are activated Level 3 The flame effect remains on the heater is set to the high heat setting and all th
8. ree red indicator lights are activated i y seca MANUAL CONTROLS The fireplace can also be controlled in a similar manner to the remote control with switches located on the fireplace FIGURE3 A Main Power Switch models with remote control Main on off switch supplies power to the remote control receiving unit When placed in the on position level 1 indicator will flash Main Power Switch models without remote control Main on off switch activates the flame effect B Heater Control Switch models with remote control Operates fireplace in the same manner as the remote control transmitter Pressing the left side of this switch has the same effect as the ON button on the remote control and the right side has the same effect as the OFF button of the remote control Pressing once to the left activates Level 1 twice activates Level 2 three times activates Level 3 Pressing to the right turns the fireplace off Heater Control Switch models without remote control Heater on off switch activates heater to high level
Download Pdf Manuals
Related Search