Casio Edifice 3H3EDD User's Manual
Contents
1. MA1010 EA Operation Guide ANA SH3EDD casio e Your watch may differ somewhat from the one shown in the illustration Stopwatch hours To set the time Stopwatch minutes 1 Pull out the crown to the second click Minutes This causes the second hand to stop First click 2 Set the hands by rotating the crown setting day Move the minute hand four or five minutes past the time you want to set and then back it up to the proper setting Push the crown back in to the normal position to restart timekeeping To set the day 1 Pull out the crown to the first click Second click 2 Set the day by rotating the crown setting time 3 Push the crown back in to the normal position e Avoid setting the day between 9 00 p m and 1 00 a m the day display may not change in the following day Seconds Crown Stopwatch seconds normal position Using the Stopwatch The stopwatch lets you measure elapsed time up to 11 hours 59 minutes 59 seconds You can also correct the position of the stopwatch second hand when necessary e The illustration shows a time of 2 hours 20 minutes 40 seconds e Do not try to perform stopwatch operations while the crown is pulled out either to the first or second click If you try to press a button you might accidentally cause the crown to rotate and change the current time or day setting To measure elapsed time 1 Press to start the stopwatch 2 Press to stop the stopwatch e You can resume2. resistant models are equipped with a screw lock crown e With such models you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out Do not pull too forcibly on such crowns e Also note that such watches are not water resistant while their crowns are loosened Be sure to screw the crowns back in as far as they will go after making any setting Specifications Accuracy at normal temperature 20 seconds a month Display 3 analog hands timekeeping hour and minutes stopwatch seconds 3 dials timekeeping seconds stopwatch hours and minutes day Stopwatch function Measuring capacity 11 59 59 Measuring unit 1 second Measuring modes Elapsed time Battery One silver oxide battery Type SR927W Approximately 2 years on type SR927W assuming one stopwatch operation 60 min day
3. the measurement operation by pressing again 3 Press to reset the stopwatch Adjusting the Stopwatch Second Position Use of the stopwatch can cause the starting positions of the stopwatch minute hand and second hand to become misaligned Use the following procedures to check hand alignment and to adjust the positions of the hands so they point to 12 o clock when the stopwatch is reset To adjust the positions of the stopwatch hands 1 Press to reset the stopwatch and check the alignment of the stopwatch minute hand and second hand 2 Pull out the crown to the second click 3 Press to move the stopwatch second hand forward until it points to 12 o clock 4 If the stopwatch minute hand is aligned correctly proceed to step 5 If the stopwatch hour hand and stopwatch minute hand are also misaligned press 8 so the stopwatch minute hand jumps to 0 5 After making the adjustments you want push the crown back in to its normal position e Note that pulling the crown out also stops the timekeeping second hand After performing the above procedure you should also adjust the timekeeping setting For a watch with an elapsed time bezel ye minute hand i es After certain amount of time elapsed read the graduation on AE Rotate the elapsed time bezel to align the mark with the EY ot the elapsed time bezel which the minute hand points to The elapsed time is indicated Elapsed time bezel e Some water
Download Pdf Manuals
Related Search