Atdec Vf-At-Aa Focus Accessory Arm VFATAA User's Manual
Contents
1. VF AT AA Installation Instructions visidec Focus Accessory Arm IMPORTANT The User Operating Card must be left with Visidec Focus Articulated Arm once installed Component Checklist Hard araware au a i yy M4x12mm Primary Arm e 4x Cable Cover gy sd Articulated Arm Hand Grip Secondary Arm Display Mounting Cable Cover Screws IMPORTANT INFORMATION IMPORTANT Install Visidec Focus Accessory Arm as per Installation Instructions This product is designed to be installed onto an existing Visidec Focus pole mount This products supports displays with a maximum weight of 8kg 17 lbs and VESA mounting hole configurations 75 x 75mm 3 x 3 100 x 100mm 4 x 4 The manufacturer accepts no responsibility for incorrect installation Step 1 Check Components Check you have received all parts against the Component Checklist and Hardware above Step 2 Remove Top Cap Pole Top Cap t UP Pole of the existing Visidec Focus Product Step 3 Attached Articulated Arm to the Existing Visidec Focus Product Articulated Arm J Hand Grip ta ax D Pole A Slightly insert Articulated Arm B Hold Articulated Arm at the lip of C Slide down Articulated D Twist and lock the Hand Grip the pole and insert Hand Grip tab Arm with Hand Grip to in the Articulated Arm the desired position Ensure the tab lines up with the slot in the Pole Step 4 Fasten Display to Articulated Arm M4 Displa2. y Mounting For displays with 75 x 75mm 3 x 3 mounting hole patterns Step 5 Replace Top Cap Step 6 Cable Management Ensure arm is fully extended Route the Cables underneath the Arms inserting the Primary and Secondary Arm Cable Covers to hold the Cables in place Screws Pull out tabs M4 Display Mounting For displays with 100 x 100mm 4 x 4 mounting hole patterns j INSERT To insert Cable Covers B Push In INSERT Secondary Arm Primary Arm Cable Cover Cable Cover TIP Leave enough slack in the cables at the joints to allow full movement Insert cables into the pole slot using the Cable Balls supplied with the Visidec Focus Mount to hold them in place Installation Complete Q INSERT C Then Push Up NOTE If the Articulated Arms are to be used in a multi user environment use the Cable Clip supplied with the Visidec Focus S Mount to secure the cables to the pole tdec No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent Atdec Pty Ltd Due to continuing product development the manufacturer reserves the right to alter specifications without noticed Published 06 09 12
Download Pdf Manuals
Related Search