ATD Tools Sander ATD-2088 User's Manual
Contents
1. ATD 2088 6 RANDOM ORBITAL SANDER INSTRUCTION MANUAL 1 Please check tightness of all parts of the tool and inspect and be sure that it is in good condition before each use For best results and to prolong the tool life install a filter and a lubricator oiler at the air inlet The best pressure on tool during operation is from 10 Ibf to 15 Ibf 5 kgf cm to 7 kgf cm ALWAYS disconnect the air supply when replacing the sand paper or the backing pad ALWAYS wear eye protection dust mask and gloves during operation To avoid fatigue take breaks periodically 30 minute intervals are suggested NEVER let tool rotate freely without load at high speeds to avoid possible inguiry to human body and possible tool damage NEVER touch the rotating part of the tool with hand or body during operation 9 ALWAYS be sure that the sanding pad is attached flat on the surface of the backing pad before starting sanding job Refer to Illustration 1 RIGHT WRONG A ole a e Illustration 1 10 1f you notice any irregular sound or vibration during operation STOP USING THE TOOL IMMEDIATELY and check and repair the tool before using again 11 Be sure to use clean compressed air for operation Use an air filter in line with your air supply to clean impurities out of the compressed air 12 Before use lubricate with air tool oil and run the tool run slowly for 20 minutes Lubricate regularly after each use and at suggested intervals of 30 m2. inutes during use to maintain tool life An auto lubricator oiler is recommended 13 Dirt inside the motor may result in slow rotation and less power of the tool If this happens first disassemble the regulator and press the trigger Then drop 10 15 drops of air tool oil from the air inlet into the motor Restart the motor within 30 40 minutes by re fitting the air source and having the motor rotating at low speed for 1 2 minutes DO NOT USE GASOLINE KEROSENE OR ANY OTHER CAUSTIC CLEANERS as they will cause damage to your tool 14 Drain the water out of the air compressor and air hose after each operation 4 PRT2088 04 REVERSE VALVE 6 PRT2088 06_ SNAP RETAINER 08 PRT2088 08 MUFFLER 9 PRT2088 09 MUFFLER CONNECTOR ALSO AVAILABLE ATD 2088 PRT2088 SK SERVICE KIT INCLUDES ITEMS 02 03 05 06 10 12 13 14 23 25 30 x5 33 amp 45
Download Pdf Manuals
Related Search