ASUS Vintage PE1 User's Manual
Contents
1. BR HE ASS Vintage PE1 Barebone System Quick Start Guide Front panel features NOTE The photos in this guide are for reference only For detailed information on your system s specifications refer to the user guide External Internal jg 5 25 inch bays i drive not included HDD bay FDD bay drive not included Reset Button HDD LED Power button USB 2 0 ports IEEE port1394 ports Microphone port Headphone port Rear panel features Power socket Voltage selector Power supply module PS 2 keyboard port PS 2 mouse port Serial port Parallel port VGA port Chassis fan vent IEEE1394 port LAN RJ 45 port USB 2 0 ports USB 2 0 ports Microphone port Line Out port Line In port Expansion slots Voltage selector The switching power supply that came with the system has a voltage selector switch below the power socket Use this switch to select the appropriate voltage according to the voltage supply in your area 115V 230V If the voltage supply in your area is Voltage selector 100 127V set the switch to 115V If the voltage supply in your area is AN CAUTION Setting the 200 240V set the switch to 230V switch to 115V in a 230V environment will seriously damage the system Internal components 1 PFC power supply 4 3 5 HDD drive bay 2 Motherboard 5 3 5 Floppy drive bay 3 Two 5 25 optical drive bays 6 Hard disk drive bays Removing the2. entium 4 processor package should come ah with installation instructions for the CPU heatsink and the retention mechanism If the instructions in this section do not match the CPU documentation follow the latter Fastener M I p nm W L Re A Push down two fasteners at a time in a diagonal sequence to secure the heatsink and fan assembly in place Place the heatsink on top of the IMPORTANT Do not installed CPU making sure that the REN forget to connect the CPU four fasteners match the holes on fan connector Hardware the motherboard monitoring errors can occur if you fail to plug this connector vi Installing an optical drive Audio cable IDE ribbon cable Red stripe to pin 1 Power cable Installing a hard disk drive HDD label IDE ribbon cable Power cable Connect the blue interface of the IDE ribbon cable to the primary IDE connector blue connector labeled PRI IDE1 on the motherboard vii Replacing the side plate and front cover Side lock tab Snap the side lock tabs to secure Hinge like tab the front panel Replace the side plate Drive in two screws on the rear panel aN IMPORTANT Repeat steps 3 and 4 to replace the other side plate viii
3. side plate and front cover Remove the two screws on the rear IMPORTANT Repeat steps 1 and 2 to remove the other side plate panel Side lock tab Release the side lock tabs Hinge like tab Swing the left edge of the front panel outward then unhook the hinge like tabs from the holes on the right side of the front panel Installing a CPU AN CAUTION Incorrect installation of the CPU into the socket may bend the pins and severely damage the CPU Retention tab Load lever This side of the cam box should face you Press the load lever with your thumb A and move it to the left B until it is released from the retention tab Lift the load lever in the direction Position the CPU over the socket of the arrow to a 135 angle Lift making sure that the gold triangle is the load plate with your thumb on the bottom left corner of the and forefinger to a 100 angle A socket The socket alignment key then push the PnP cap from the should fit into the CPU notch load plate window to remove B Close the load plate A then push the load lever B until it snaps into the retention tab Installing system memory CAUTION A DDR DIMM is keyed with a notch so that it fits in only one direction DO NOT force a DIMM into a socket to avoid damaging the DIMM DIMM notch Socket break Installing the fan and heatsink assembly Z NOTE Your boxed Intel P
Download Pdf Manuals
Related Search