ASUS Vintage-PE2 User's Manual
Contents
1. two screws on the rear N IMPORTANT Repeat panel steps 1 and 2 to remove the other side plate Side lock tab DAT de on LIRA en Piet Release the side lock tabs Mu Hinge like tab Canc Saggi 7 Swing the left edge of the front panel outward then unhook the hinge like tabs from the holes on the right side of the front panel Installing a CPU 1 Press the load lever with your thumb 2 Move it to the left until it is released from the retention tab A CAUTION To prevent damage to the socket pins do not remove the PnP cap unless you are installing a CPU Alignment key Gold triangle mark Installing system memory A CAUTION A DDR DIMM is keyed with a notch so that it fits in only one direction DO NOT force a DIMM into a socket to avoid damaging the DIMM h Socket break DIMM notch VI Installing the fan and heatsink assembly Place the heatsink on top of the installed CPU making sure that the four fasteners match the holes on the motherboard NOTE Make sure to orient each fastener with the narrow end of the groove pointing Ju J outward The photo shows S DI ini the groove shaded for N n IL A emphasis a lt ii RARE dl Narrow end of the groove Fastener Push down two fasteners at a time in a diagonal sequence to secure the heatsink and fan assembly in place Connect the CPU fan cab2. AB HE Fa Vintage PE2 Barebone System Quick Installation Guide Front panel features NOTE The photos in this guide are for reference only For detailed information on your system s specifications refer to the user guide External Internal 5 25 inch bays drive not included HDD bay FDD bay drive not included Reset button HDD LED Power button USB 2 0 ports Microphone port Headphone port Rear panel features Power socket Voltage selector Power supply module PS 2 keyboard port PS 2 mouse port Parallel port VGA port Chassis fan vent USB 2 0 ports USB 2 0 ports LAN RJ 45 port Microphone port Line Out port Line In port Expansion slots Voltage selector The switching power supply that came with the system has a voltage selector switch below the power socket Use this switch to select the appropriate voltage according to the voltage supply in your area If the voltage supply in your area is 100 127 V set the switch to 115 V If the voltage supply in your area is 115 V 230 V 200 240 V set the switch to 230 V Voltage selector A N CAUTION Setting the switch to 115 V in a 230 V environment will seriously damage the system Internal components 1 PFC power supply 4 Hard disk drive bay 2 Motherboard 5 3 5 Floppy drive bay 3 Two 5 25 optical drive bays 6 Hard disk drive bays Removing the side plate and front cover Remove the
3. le to the connector on the motherboard labeled CPU_FAN1 LN IMPORTANT Do not forget to connect the CPU fan connector Hardware monitoring errors can occur if you fail to plug this connector Installing an optical drive Audio cable IDE ribbon cable Red stripe to Pin 1 Power cable no intial ining Tatin E u Ald TTD DNN ai Connect the blue interface of the IDE ribbon cable to the primary IDE connector blue connector labeled PRI_IDE1 on the motherboard IDE ribbon cable Power cable Vii vili Replacing the side plate and front cover Side lock tab ite F ary En Snap the side lock tabs to secure Hinge like tab the front panel tos She 4 r p Drive in two screws on the rear panel IMPORTANT Repeat steps 3 and 4 to replace the other side plate
Download Pdf Manuals
Related Search