Amana AGG222VDW Dimension Guide
Contents
1. specified on the model serial rating plate for use with a different gas without consulting the serving gas supplier See Gas Conversions section Gas Supply Line e Provide a gas supply line of 34 1 9 cm rigid pipe to the range location A smaller size pipe on longer runs may result in insufficient gas supply With LP gas piping or tubing size can be 1 2 1 3 cm minimum Usually LP gas suppliers determine the size and materials used in the system NOTE Pipe joint compounds that resist the action of LP gas must be used Do not use TEFLON tape Flexible metal appliance connector e f local codes permit a new CSA design certified 4 5 ft 122 152 4 cm long 1 2 1 3 cm or 3 4 1 9 cm I D flexible metal appliance connector may be used for connecting range to the gas supply line e A 1 2 1 3 cm male pipe thread is needed for connection to the female pipe threads of the inlet to the appliance pressure regulator e Do not kink or damage the flexible metal tubing when moving the range Rigid pipe connection The rigid pipe connection requires a combination of pipe fittings to obtain an in line connection to the range The rigid pipe must be level with the range connection All strains must be removed from the supply and fuel lines so range will be level and in line e Must include a shutoff valve The supply line must be equipped with a manual shutoff valve This valve should be located in the same2. Amana 20 50 8 cm Freestanding Gas Range PRODUCT MODEL NUMBERS AGG222VD Electrical Requirements e A 120 volt 60 Hz AC only 15 amp fused electrical circuit is required A time delay fuse or circuit breaker is also recommended It is recommended that a separate circuit serving only this range be provided e This range is equipped with a power supply cord having a 3 prong ground plug To ae possible shock hazard the cord must be plugged into a grounded 3 prong outlet e Electronic ignition systems operate within wide voltage limits but proper grounding and polarity are necessary Check that the outlet provides 120 volt power and is correctly grounded This range is equipped with an electronic ignition system that will not operate if plugged into an outlet that is not properly polarized Gas Supply Requirements Natural gas This range is design certified by CSA International for use with Natural gas or after proper conversion for use with LP gas e This range is factory set for use with Natural gas See Gas Conversions section The model serial rating plate located on the oven frame behind the left side of the broiler door has information on the types of gas that can be used If the types of gas listed do not include the type of gas available check with the local gas supplier LP gas conversion Conversion must be done by a qualified service technician No attempt shall be made to convert the appliance from the gas
3. bination above the range follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface Because Whirlpool Corporation policy includes a continuous commitment to improve our products we reserve the right to change materials and specifications without notice Dimensions are for planning purposes only For complete details see Installation Instructions packed with product Specifications subject to change without notice Ref W10459123B 3 19 13
4. room but external to the range opening such as an adjacent cabinet It should be in a location that allows ease of opening and closing Do not block access to shutoff valve The valve is for turning on or shutting off gas to the range A Gas supply line B Shutoff valve open position C To range T TEFLON is a registered trademark of E l Du Pont De Nemours and Company PRODUCT DIMENSIONS Yap 106 6 cm 19 50 cm CABINET OPENING DIMENSIONS 13 33 0 cm max upper cabinet depth 20 50 8 cm min a cabinet opening width For minimum clearance to top of cooktop see NOTE 4 20 51 12 cm E opening width 18 45 7 cm 3 7 6 cm min min clearance a Countertop space to upper side side wall or other cabinet to ad combustible material countertop This shaded area recommended for installation of gas pipe This shaded area recommended for electrical outlet NOTE 24 61 cm minimum when bottom of wood or metal cabinet is covered by not less than 1 4 0 64 cm flame retardant millboard covered with not less than No 28 MSG sheet steel 0 015 0 4 mm stainless steel 0 024 0 6 mm aluminum or 0 020 0 5 mm copper 30 76 2 cm minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet IMPORTANT If installing a range hood or microwave hood com
Download Pdf Manuals
Related Search