Alvin Drafting Table User's Manual
Contents
1. left and right hinges for the time being with rods facing straight up and down and rear mounting Tighten securely brackets facing out as shown in diagram Tighten knobs securely Insert tilt adjustment rods F into Ej Base frame assembly is now complete Set aside threaded barrels on each side frame To Attach Tabletop to Base Frame This base can be used with 42 48 or 60 wide top Inspect tabletop carefully and choose which side you want facing up for use This side should be placed face down on a carpeted or otherwise protected floor to avoid scratches Carefully turn base frame assembly upside down and place on tabletop This may require two people 19 19 2 Position base assembly so that front hinges are 1 2 from the front edge of the tabletop as shown in diagram Hinges should also be centered evenly between left and right sides of tabletop Front Edge Adjust and position rear mounting brackets so they are 19 from the front edge of the table top and centered evenly between left and right sides as shown in diagram Brackets should sit flush on the tabletop surface with the rods facing straight up and down Mark locations of all 12 holes with a dark pencil or marker and then use an awl or drill with e bit to make starter holes Use care not to drill all the way through the tabletop Attach front hinges and rear brackets to tabletop using 34 Phillips screws ff Tighten securely but use care not2. i gt EVE For WOB42 WOB48 WOB60 Assembly Instr uc ti ons WOB42 WA and WOB48 WA Tools required Phillips screwdriver awl or drill with 146 bit Parts Included B C ipc A Footrest Crossbar Rear c jn 347 long 35 long E 2pcs D Qs Dust rr Adjustment Knobs Tilt Adjustment Rods G m IN H 8pcs Side Frames Left amp Right Hinge A Left amp Right 2 Allen Bolts 34 Phillips Screws Allen Wrench Key To Assemble Base Frame Unpack and inspect contents to confirm you have all the parts listed above Use care to differentiate rear crossbar B 34 2 long from footrest crossbar 35 long g Attach the rear crossbar B and footrest crossbar to one side frame A using 2 Allen bolts Hi Tighten securely Note Threaded barrels preattached to leg frames must be in rear and facing out Attach other side frame A to opposite ends of crossbars in step two using 2 Allen bolts Hi Tighten securely Place dust cover D over top of base frame and attach using 3 4 Phillips screws ff Note Wooden strip on dust cover should be in front of table and facing up Attach hinge assemblies G to side frames into pre drilled holes using Phillips screws ff as shown in Screw adjustment knobs E into threaded barrels on each side frame Set diagram Pay close attention to correct adjustment rods so that connecting brackets are about 2 above side frames orientation of
3. to over tighten and strip 2008 ALVIN amp COMPANY INC P O Box 188 Windsor CT 06095 0722 www alvinco com Phone 860 243 8991 e Toll Free 800 444 2584 e Fax 860 242 8037 e Toll Free Fax 800 777 2896 LIT A8156 7 08
Download Pdf Manuals
Related Search