Acclaim Lighting ACL7500U1 User's Manual
Contents
1. Max SPL Rated Power 114 dB 1 meter Lo Z Microphone 52 dBV 2 5 mVrms OWNER S MANUAL Frequency Response 60 Hz 15 kHz 3 dB Hi Z Microphone 43 dBV 7 5 mVrms AC Power Requirements 90 264 VAC 50 60 Hz 50 W max Auxiliary line 14 dBV 200 mVrms Dimensions Outputs Base HWD 14 x 22 5 x 13 5 35 6 x 57x 34 3 Line post fader Lo Z lk ohm buffered 1 4 phone am Microphone Lo Z balanced XLR Table Top 22 5 x 19 57 x 48 cm Speaker switched 8ohm 1 4 phone Weight 30 pounds 13 6 Kg unswitched 4ohm 1 4 phone Inputs ACL BASE Lectern Mic Lo Z balanced phantom power XLR Dimensions HWD 30 5 x 21 5 x 18 5 77 5 x 54 6 x 47 Auxiliary Mic Lo Z balanced phantom power XLR cm Line Hi Z unbalanced 1 4 phone Weight 38 pounds 17 2 Kg C Bovis ix med cas Specifications subject to change without notice CONTENTS GETTING STARTED CARING FOR YOUR BUILT IN BATTERIES ACCLAIM LECTERN BASIC SYSTEM OPERATION OPERATING THE BUILT IN UHF WIRELESS RECEIVER ACCLAIM ACCESSORIES OPERATING THE WIRELESS MICROPHONE TRANSMITTER HAVING TROUBLE W YOUR SOUND SYSTEM ssssscccccsssssssssssccssssssssssceccecssssssssscsecseessussseecsesssssnseseseeseet 8 Anchor Audio Inc ACCLAIM SOUND SYSTEM TECHNICAL SPECIFICATIONS A NCH O R Portable Sound Systems Torrance California 100 0163 000 C 4 09 A MESSAGE FROM THE OWNER Thank you for choosing an Anchor Audio portable sound system2. wireless system WIRELESS MICROPHONE VOLUME CONTROL WIRELESS RECEIVER CHANNEL SELECTION KNOB 1 Choose any available wireless channel frequency from 1 thru 16 transmitter instructions page 7 Set the Wireless Channel Selector Knob to the channel frequency you choose in step above WIRELESS MICROPHONE CHANNEL Remember to operate the receiver amp transmitter pair must be set to the same channels RX INDICATOR LIGHTS NOTE Ongoing wireless interference The frequency you selected may be in use by other systems in the area Change channels until you find a clear frequency NEED MORE HELP View demonstration videos on proper system setup and operation www anchoraudio com ACCLAIM ACCESSORIES AN 1001X Companion Speaker Unpowered companion speaker speaker cable not included SC 50 Heavy Duty Speaker Cable 50 speaker cable connect AN 1001X to powered Acclaim 5 550 Heavy Duty Speaker Stand Adjustable stand made of black anodized aluminum ACCBASE Base for Acclaim Acclaim lectern base amp traveling case MIC 90 Handheld Wired Microphone Anchor s dynamic balanced low impedance microphone w unidi rectional pick up pattern mic on off switch amp 20 cable ANCHOR WIRELESS 16 CHANNEL UHF WH 6000 Handheld Microphone Transmitter Wireless transmitter amp microphone in one unit WB 6000 Body Pack Transmitter Works w hands free microphones mic not included Body Pack Transmit
3. for a composite output For playback of tape CD player or other audio source LINE OUT OUTPUT JACK 1 4 PHONE Balanced provides combined output of all active system inputs Record presentation connect to another powered sound system INTERNAL SPEAKER SWITCH Turn internal lectern speaker out put on off SPEAKER OUT 8 OHM f e 7a Ve LINE OUTgOT d NN i y AUXILIARY MICIN BALANCED MIC OUT MADE IN USA BALANCED MICROPHONE OUTPUT JACK XLR Use to connect Acclaim to a house system SPEAKER OUT OUTPUT JACK 1 4 PHONE Balanced drives an unpowered 2 ohm speaker in addition to the built in speakers LECTERN MICROPHONE JACK ee ee ACCLAIM LECTERN TABLETOP NI Models BACK CONTROL PANEL
4. HAVING TROUBLE W YOUR SOUND SYSTEM For Setup amp Operation Videos Go To www anchoraudio com CONDITION POSSIBLE SOLUTION No Sound power LED off e turn POWER switch ON e charge battery or plug in AC cord Charge Indicator LED off e leave plugged in for 48 hours to repair battery No Sound power LED on e check for output from source e set Internal Speaker switch to ON e make sure all cables are completely plugged in e turn up volume control of input used i e remove plug from speaker output if not using external speaker output Shortened Battery Life e charge battery fully if battery life continues to deteriorate contact Anchor Audio customer service 888 444 6077 Distorted Sound ower system volume control Excessive Hum or Noise e use shielded cables P e use balanced microphone HAVING TROUBLE W YOUR WIRELESS SYSTEM WIRELESS MODELS ONLY CONDITION POSSIBLE SOLUTION No Sound RX Indicator ON set MUTE switch to on handheld mic only e turn up WIRELESS volume control e make sure mic is plugged into body pack transmitter No Sound RX Indicator OFF e push mic power button e turn Acclaim POWER switch on e make sure transmitter power switch is on e set receiver and transmitter to same channel e replace battery in transmitter ANCHOR AUDIO CUSTOMER SERVICE 888 444 6077 310 784 2300 ACCLAIM ACCLAIM TECHNICAL SPECIFICATIONS PORTABLE LECTERN SOUND SYSTEM Rated Power Output 22 watts Sensitivity For Rated Output
5. Our products incorporate state of the art design and the finest quality of ma terials and workmanship We re proud of our products and appreciate the confidence which you have shown by selecting an Anchor system hope you ll take a few minutes to review this manual We ve incorporated several unique features into our products and your knowledge of how fo use them will enhance the performance and your enjoyment of the system Se t Jacpbs Pr side i on behalf of all Anthor Employees GETTING STARTED Please check your new unit carefully for any damage which may have occurred during shipment Each Anchor product is carefully inspected at the factory and packed in specially designed boxes for safe transport Notify the freight carrier immediately of any damage to the shipping box or product Repack the unit in the original box and wait for inspection hy the carrier s claim agent Notify your dealer of the pending freight claim NOTE All damage claims must be made with freight carrier RETURNING SYSTEMS FOR SERVICE OR REPAIR For service or repair please contact the dealer you purchased your system from or Anchor Audio Customer Service at 888 444 6077 to obtain a RA Return Authorization number All shipments to Anchor Audio must include an RA number and must be shipped prepaid C 0 D shipments will be refused and returned at your expense IMPORTANT Save the shipping box amp packing materials they were specially designed to shi
6. d MIC 4 The RX indicators will light only one indicator will light at a time when the wireless signal is being transmitted and received Turn the transmitter power switch to ON The red LED will fash when the mic is turned on If the red LED stays on the battery is low CAUTION Harmful feedback may occur when walking in front of a sound system or speaker with a wireless microphone Always point microphone away from speakers REPLACE BATTERY HANDHELD TRANSMITTER REPLACE BATTERY BODY PACK TRANSMITTER 1 Unscrew battery cover on bottom of microphone 1 Slide open battery cover on front of transmitter 2 Replace old batteries with 2 fresh size AA 2 Replace old batteries with 2 fresh size AA alkaline batteries alkaline batteries 3 Replace battery cover and tighten firmly 3 Replace battery cover by sliding firmly into place NOTE Transmitter power must be OFF when changing batteries DIVERSITY WIRELESS BY ANCHOR AUDIO Anchor Audio UHF wireless is a 16 channel diversity wireless system that receives signals with two independent antennae With diversity wireless the receiver processes the stronger signal effectively minimizing dropouts and interference from other transmitting sources The antennae are mounted internally so there are no obstructions or risk of damage CHANNEL SELECTION BUILT IN RECEIVER Select a channel set the built in receiver and micro phone transmitter to that channel before using your
7. e Adjust BASS amp TREBLE controls to desired sound quality IMPORTANT Make all connections w shielded cables to avoid hum buzzing or interference CHARGER please see page 3 for instructions BATTERY LEVEL INDICATOR LIGHT ACCLAIM LECTERN pem CONNECTION PANEL Of Model Shown ACL 7500U1 ANCHOR www anchoraudio com 888 444 6077 UHF WIRELESS RECEIVER Available on selected models only TONE CONTROLS POWER ON WIRED MICROPHONE please see page 6 for instructions Buss amp Treble INDICATOR LIGHT LEVEL CONTROL WIRELESS MICROPHONE 1 Q RX Dot RX o Oo 9 VOLUME CHANNEL Max Load 500mA MADE IN USA READING LAMP JACK Remove cap to use ACCLAIM LECTERN CONTROL PANEL Model Shown ACL 7500U1 9 D TREBLE BASS LINE IN VOLUME MIC 2 VOLUME LECTERN VOLUME Om OO oO ACCLAIM LINE IN LEVEL LECTERN MIC LEVEL CONTROL CONTROL Waste electrical and electronic products must not be disposed of with household waste Please recycle where facilities exist Check with your Local Authority or Retailer for recycling advice Plug cord into AC outlet CHARGE INDICATOR LIGHT Ein 0H BATTERY Flashing Low Battery POWER INLET 100 240 VAC 47 63 Hz 250 watts max AUXILIARY MICROPHONE INPUT JACK XLR Balanced low impedance mi crophones powers condenser mics LINE INJUT Va IN Sy b LINE IN INPUT JACK 1 4 PHONE Jack may be combined w mic inputs
8. p your unit WARRANTY REGISTRATION Visit our website at www anchoraudio com and select Warranty Registration Complete the online form to activate the six year limited war ranty on your Acclaim lectern sound system and two year limited warranty for microphones CERTIFICATION This system conforms to part 74 and part 15 of the FCC rules contact the FCC office for filling forms Frequency Range 682 MHz 698 MHz WH 6000EU and WB 6000EU transmitters meet the essential requirements of the European R amp ITE Directive 99 5 EC and are eligible to carry the CE marking CE 0336 European Frequency Range 863 125 MHz 864 875 MHz OPERATING THE WIRELESS MICROPHONE TRANSMITTER CHANNEL SELECTION HANDHELD TRANSMITTER CHANNEL SELECTION BODY PACK TRANSMITTER 1 Unscrew battery cover on bottom of microphone The channel selection dial is located on the 2 Set the CHANNEL SELECTOR dial to match the side of the transmitter channel setting of your receiver 2 Set the CHANNEL selection dial to match the channel setting of the receiver 3 Replace battery cover and tighten firmly NOTE When using dual wireless each microphone must be set to a different channel USING YOUR WIRELESS MICROPHONES After you have set the transmitter channel see above you are ready to use your wireless microphone l Body pack transmitter users must insert the mic 3 Turn the Acclaim power switch to ON plug into the transmitter jack marke
9. stem w Batteries Fully Charged SYSTEM STORAGE amp BATTERIES Always store your sound system with the batteries fully charged For extended periods of storage leave the system plugged into an AC outlet If this is not possible charge the system at least once each month for a minimum of 24 hours CHARGER INDICATOR LIGHT ACCLAIM BATTERY LEVEL INDICATOR LIGHT CHARGING YOUR BUILT IN BATTERIES An automatic charging system is built in to your Acclaim Lectern Sound System It is designed to properly charge and maintain the systems built in batteries To charge the batteries 1 Plug the power cord into your sound system 2 Plug the other end of the cord into AC outlet Charger LED will stay on during charging 3 Batteries will be fully charged in approximately 6 8 hrs Charger LED will flash When in AC mode the system automatically transfers power from the battery charger to the power amplifier at high volume output causing the Charger LED to flicker BASIC SYSTEM OPERATION NOTE Fully Charge Battery Before First DC Use l Setall Input Level Controls to minimum amp Tones Controls to flat the middle setting before turning your system on Plug lectern gooseneck microphone into the Lectern Mic Jack located on the tabletop Plug reading light into the Reading Lamp Jack on control panel Switch POWER to ON the BATTERY LED will light Slowly increase the Level Control for the input jacks used to the desired volum
10. ter Microphones CM 60 Collar Microphone Lightweight low profile mic EM 60T UltraLite Microphone Hands free Over the Ear mic 6 LM 60 Lapel Microphone Lightweight clip on lapel mic HBM TA4F Headband Microphone Ultra lightweight headband mic CARING FOR YOUR BUILT IN BATTERIES It is very important that you fully charge the batteries in your new sound system before the first time its used To preserve battery life it is also recommended that batteries be fully charged as soon as possible after every use regardless of the length of operation UNDERSTANDING THE BATTERY LEVEL INDICATOR LIGHT LED Flashing Red Battery charge is very low in 15 30 minutes the Battery Protection Circuit will turn the system off LED Off Battery is completely drained and must be charged NOTE System Can Be Used When Batteries Are Being Charged OPERATING ACCLAIM IN AC MODE Plug your sound system into an AC outlet and operate as normal while charging the built in batteries at the same time The Charger LED will light during charging and flash when the battery is fully charged BATTERY SERVICE TIME With the batteries fully charged you can expect approx 6 8 hrs Medium Volume 24 hrs Full Volume Of continuous music input longer for speech However service time will vary depending on control settings and the use of accessories built in CD player wireless receivers and or a companion speaker IMPORTANT Always Store Your Sy
Download Pdf Manuals
Related Search