Metra AX-ADXSVI-GM2 car kit
Contents
1. White Black wire to the left front negative speaker output of the aftermarket radio Connect the Gray wire to the right front positive speaker output of the aftermarket radio Connect the Gray Black wire to the right front negative speaker output of the aftermarket radio Connect the Green wire to the radio s left rear positive speaker output Connect the Green Black wire to the radio s left rear negative speaker output Connect the Purple wire to the radio s right rear positive speaker output Connect the Purple Black wire to the radio s right rear negative speaker output continued on next page metraonline coOm COPYRIGHT 2004 2011 METRA ELECTRONICS CORPORATION The following wires are for the aftermarket radios that have navigation built in e Connect the Light Green wire to the parking brake wire of the aftermarket navigation radio if applicable e Connect the Blue Pink wire to the VSS or speed sense wire of the aftermarket navigation radio if applicable e Connect the Green Purple wire to the reverse wire of the aftermarket navigation radio if applicable e Cycle the key by turning the ignition on for 30 seconds Then off and on again to test the radio ASWC 1 if installing After the XSVI is initialized plug in the ASWC 1 into the 12 pin harness of the AX ADXSVI GM2 and refer to the ASWC 1 instructions IMPORTANT WARNING This product includes instructions for installation which must be carefully f2. REV 1 16 2014 INSTAX ADXSVI GM2 Installation Instructions for AX ADXSVI GMe2e AX ADXSVI GMe2 APPLICATIONS CHEVROLET SATURN Cobalt 2007 2010 Aura 2007 2009 HHR 2006 2011 Sky 2006 2009 Malibu 2008 2012 PONTIAC G5 2007 2008 G6 5th digit of VIN must be a J K or L 2009 G6 2010 Solstice 2006 2009 KIT FEATURES e Provides accessory 12 volt 10 amp Retains R A P retained accessory power Used in non amplified systems or when replacing amplified system Provides NAV outputs parking brake reverse and V S S Prewired ASWC 1 harness included ASWC 1 sold separately High level speaker input USB updatable Note 1 This harness must be used in conjunction with the AX ADXSVI 2 All chimes will be lost when using this harness METRA The World s best kits 1 800 221 0932 WIRING THE AX ADXSVI GM2 e Connect the Yellow wire to the radio s 12 volt battery or memory wire Connect the Black wire to the radio s ground wire Connect the Red wire to the ignition wire of the aftermarket radio Connect the Orange wire to the illumination wire of the aftermarket radio If the aftermarket radio has no illumination wire tape off the Orange wire The Orange White wire will not be used in this application Tape up or cap off this wire and disregard it Connect the Blue wire to the antenna turn on wire of the aftermarket radio Connect the White wire to the left front positive speaker output of the aftermarket radio Connect the
3. ollowed The instructions are worded in such a manner to assume that the installer is capable of completing these type of electronic installations If you are unclear as to what you are instructed to do or believe that you do not understand the instructions so as to properly and safely complete the installation you should consult a technician who does have this knowledge and understanding Failure to follow these instructions carefully and to install the interface as described could cause harm to the vehicle or to safety systems on the vehicle Interference with certain safety systems could cause harm to persons as well If you have any questions in this regard please call the Help line or Metra at 1 800 221 0932 for assistance TAL Metra recommends MECP certified technicians toward a better tomorrow
Download Pdf Manuals
Related Search