Brodit ProClip 530364
Contents
1. as follows If the battery is empty or has low charge a constant current charges the battery until the cell voltage reaches 8 4V The LED emits red light Hereafter the charge continues until the current goes down to OA The battery is now full and stays fully charged A special designed voltage controller is monitoring that the cell voltage is within limit The LED emits green light If the battery is used without disconnecting the charger current is supplied directly resulting in a fast recovery nrodit Compatible batteries 2 3 hours depending on battery capacity 1 6 A 5 0 to 50 mA Operating Temperature 40 C to 50 C 40 F to 122 F can be restricted by battery chemistry Input Transient Protected Withstands 150V amp 450V A 2 5A fuse is mounted on the incoming supply Output Short Circuit Protected The charger will supply a maximum current of 1 6 A which protects both the charger and the connected equipment The current limit is set to standards of the producer and shall not be higher2. Holder and Charging Specifications Item no 530364 532364 Reference doc 311 1125 Zodiac BT Series Connect Features amp Benefits e Always keep your battery fully charged o Made of high grade ABS plastic e Charges Li lon or Li Poly batteries Works in 12 and 24 volt vehicles e Rapid and trickle charges radio LED Red to Green charging status indicator e Custom fit to hold device securely o Designed and manufactured in Sweden e Allows one handed insertion and removal of radio You can charge just the battery alone in the holder e Works with or without belt clip on back of radio o Charging cable attached to holder providing dock type connection e Attach to ProClip Vehicle or Pedestal mounts e Can also be attached directly to any flat surface dashboard console wall or any type of mounting bracket Holder specifications item no 530364 Charging Holder with Cigarette Lighter Plug Rugged thermal resistant black ABS plastic FT103 Dimensions W x H x D 63 x 85 x 49 mm Weight 93 g 0 20 Ibs Cable Length un stretched Attachment AMPS hole pattern Holder specifications item no 532364 Charging Holder for Hard Wire Installation Rugged thermal resistant black ABS plastic FT103 Dimensions W x H x D 63 x 85 x 49 mm Weight 80 g 0 17 lbs Cable Length Attachment AMPS hole pattern Charging Specifications Lithium charging is based on CVCC Constant Voltage Constant Current The charging procedure is
Download Pdf Manuals
Related Search