Scosche NN1641B car kit
Contents
1. SCOSCHE NN1641B IN DASH DIN STEREO INSTALLATION KIT FOR 2007 UP NISSAN SENTRA 6465 RIGHT BRACKET 6463 MOUNTING PANEL INTRODUCTION PRELIMINARY This premium installation kit is for 2007 UP Nissan Sentra vehicles Included are all the parts you need to mount your car stereo or CD player into your vehicle s dash Refer to the individual instruction in this manual to remove your vehicle s factory radio and assemble the kit CAUTION DISCONNECT YOUR VEHICLE S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLATION TO HELP PREVENT ELECTRICAL DAMAGE WE RECOMMEND THE USE OF A VOLT OHM METER OVER A TEST LIGHT TO CHECK WIRING A TEST LIGHT OR GROUNDED WIRE PROBE CAN CAUSE DAMAGE TO THE VEHICLE S COMPUTER AND OR DIAGNOSTIC SYSTEMS AVOID ALL FACTORY AIRBAG WIRING AIRBAGS CAN ACCIDENTALLY DEPLOY CAUSING SERIOUS INJURY OR DEATH NOTES e See your vehicle s instructions for any special tools your installation might require e Read all instructions accompanying your car stereo for proper wiring and mounting instructions FACTORY WIRING CODES For Factory Wiring Codes go to www scosche cars com CAR STEREO CONNECTORS PROVIDE EASY CONNECTION OF YOUR CAR STEREO TO FACTORY WIRING HARNESS NNO4B NAA2B 2007 UP Nissan Sentra 2007 UP Nissan Sentra Antenna Adapter LIABILITY DISCLAIMER This instruction booklet is based on carefully documented data and research of automobile dash disassembly wire harness codes and informatio2. n and bolt the aftermarket double DIN ISO head unit REAR to the mounting brackets Use the hardware supplied SUPPORT with the aftermarket double DIN ISO STRAPS head unit to secure the mounting JON A A Y brackets to the aftermarket radio _Z DOUBLE DIN A STEREO gt NOTE REAR SUPPORTING THE STEREO ADDS TO THE INSTALLATION S STRUCTURAL INTEGRITY REAR SUPPORT AVAILABLE SEPARATELY r If you have any further questions or need dash disassembly instructions call our TOLL FREE number TECHNICAL HELP line 1 800 621 3695 x3 2
3. n pertaining to installation of this kit NN1641B in 2007 Nissan Sentra vehicles Scosche Industries Inc can not be held responsible for discrepancies inconsistencies that may occur due to the automobile manufacturing changes or options or damage that may occur in the automobile during the installation of components while using this booklet 2007 SCOSCHE INDUSTRIES INC SI 10 07 NN1641B 3000003 FACTORY STEREO REMOVAL RADIO REMOVAL Note The factory radio provision is for a DIN or Double DIN Remove shifter knob slide down chrome trim release snap ring in shifter knob and pull knob off Remove shifter cover plate The plate snaps off Using PRT remove A C controls underneath the radio Disconnect and remove Using PRT unsnap the panel above the radio assembly Remove the 4 Phillips screws holding the radio radio display and A C display Disconnect and remove Remove the 8 torx screws from radio Slide radio out of brackets and remove MOUNTING THE STEREO ATTACHING THE SINGLE DIN STEREO 1 Snap the 6465 and 6466 brackets to the 6463 kit panel 2 Align the 6464 pocket to the lower edge of the panel Secure the pocket to the mounting brackets with the two 2 supplied screws in the installation kit 3 Mount radio to brackets with the radio s supplied screws OORUN ATTACHING THE SINGLE DIN STEREO 1 Snap the 6465 and 6466 brackets to the 6463 kit panel 2 Align positio
Download Pdf Manuals
Related Search