Havis C-CB-LOCK car kit
Contents
1. out all pieces to the lock assembly as shown in the picture Note that the Lock Assembly Kit may include additional hardware not pictured any such hardware is not needed Insert the Mounting Shell into the panel hole and place the Trim Ring on the inside of the panel as a washer Secure with the Mounting Shell Nut Insert the Tumbler into the Mounting Shell noting the orientation of the key Place the Lock Arm Bracket onto the Tumbler orienting it to be horizontal when unlocked and vertical when locked and noting the orientation of the catch Secure with the Locknut and Screw 5 Finish and Test The assembled lock should look as pictured Test for correct operation Note that the Lock Arm Bracket may need to be bent to correctly engage the Lock Catch Bracket Re attach the armrest pad removed during Step 1 Remove knockout plug Ensure notch is oriented as shown Keys Tumbler Mounting Shell Trim Ring Mounting Shell Nut Lock Arm Bracket Locknut Screw Correct orientation of assembled lock C CB LOCK_INST_6 09 docx6 092. V IS Productivity in motion Havis Inc 75 Jacksonville Road PO Box 2099 Warminster PA 18974 T 800 524 9900 F 215 957 0729 www havis com Installation Instructions C CB LOCK Lock Option For Combo Box Series Warning Please read all instructions prior to installation of the armrest lock TOOLS REQUIRED Phillips Screw Driver HARDWARE Supplied in Kit Qty Description 1 Lock Assembly Kit 1 Lock Arm Bracket l Lock Catch Bracket INSTALLATION 1 Remove Armrest Pad Remove the four screws that attach the armrest pad and set the pad aside Keep all of the hardware as the pad will need to be reattached to complete installation Adjustable Wrench Qty Description 2 8 32 PEM Studs 2 8 32 Hex Nuts Remove and save these four screws and washers 2 Attach Lock Catch Bracket to Inside of Armrest Place the two 8 32 PEM studs through the two holes provided and hold in place The two PEM studs do not need to be crimped Place the Lock Catch Bracket onto the two PEM studs in the orientation shown and secure with two 8 32 hex nuts 8 32 hex nuts 8 32 PEM studs Lock catch bracket C CB LOCK_INST_6 09 docx6 09 3 Remove Knockout From Panel Remove the plastic knockout from the panel side hole Verify that the alignment notch 1s oriented exactly as shown If it is not rotate and or flip over the panel to match this orientation 4 Assemble Lock Lay
Download Pdf Manuals
Related Search