Metra 95-8204 car kit
Contents
1. panel including the a c vents from the factory radio Continue to kit assembly hh LES 95 8204 KIT ASSEMBLY DOUBLE DIN RADIO PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Snap the Double DIN trim plate into the factory trim panel Figure A 2 Slide the Double DIN radio into the Double DIN brackets and secure the radio to the brackets using the screws supplied with the radio Figure B Continue to final assembly hh LES 95 8204 KIT ASSEMBLY STACKED ISO UNITS PROVISION Note Refer also to the instructions included with the aftermarket radio 1 Snap the Double DIN trim plate into the factory trim panel Figure A 2 Slide the stacked ISO units into the Double DIN brackets and secure the units to the brackets using the screws supplied with the units Figure B Continue to final assembly Y Meng 95 8204 FINAL ASSEMBLY FINAL ASSEMBLY A Strip wire ends back 1 2 B Twist ends together C Solder D Tape 1 Locate the factory wiring harness in the dash Metra recommends using the proper mating adapter and making connections as shown Isolate and individ ually tape off the ends of any unused wires to prevent electrical short circuit 2 Re connect the negative battery terminal and test the unit for proper operation 3 Reassemble radio and dash assemblies in reverse order of disassembly FINAL WI2. INSTALLATION INSTRUCTIONS FOR PART 95 8204 APPLICATIONS Toyota Corolla 2003 2008 95 5204 KIT FEATURES e Double DIN Radio Provision e Stacked ISO Units Provision KIT COMPONENTS A Double DIN Trim Plate B Double DIN Brackets TOOLS REQUIRED Small Flat Blade Screwdriver e Panel Removal Tool e Phillips Screwdriver e Socket Set SS uy e As EA 300 221 0932 a www metraonline com COPYRIGHT 2004 2007 METRA ELECTRONICS CORPORATION 777 95 8204 OOOO TABLE OF CONTENTS Dash Disassembly Totota Corolla 2003 2008 1 Kit Assembly Double DIN Radio Provision 2 Stacked ISO Units Provision 3 FINALASSEMDIV ausw 20a rior Aran 4 Note Refer also to the instructions included with the aftermarket radio zh i I Mais 95 8204 DASH DISASSEMBLY TOYOTA COROLLA 2003 2008 A 1 Disconnect the negative battery ter minal to prevent an accidental short circuit 2 Unclip and remove the gear shifter trim panel Figure A 3 Remove the center a c knob and 1 Phillips screw exposed behind it Figure B 4 Unclip and remove the a c pocket assembly Figure C 5 Remove 4 10 MM bolts from the bot tom of the radio then unclip and remove the factory radio and trim panel together Unplug radio from fac tory harness Figure D 6 Unclip and remove the radio trim
3. RING CONNECTIONS Make wiring connections using the EIA color code chart shown below and the instructions included with the head unit Metra recommends making connections as shown below Strip Splice Solder Tape Isolate and individually tape off ends of any unused wires to prevent electrical short circuit METRA EIA WIRING CODE 12V lonition Acc Red 12V Batt Memory Yellow E doll as Black Power Antenna Blue Amp Turn On Blue White Amp Ground Black White Illumination Orange DINM 2 aria Orange White Right Front Gray Right Front Gray Black Left Front White Left Front White Black Right Rear Violet Right Rear Violet Black Left Rear Green Left Rear Green Black NOTE When a Black wire is not present ground radio to vehicle chassis All colors may not be present on all leads due to manufacturer s specifications 4 NOTES 95 8204 INSTRUCTIONS 1 800 221 0932 m www metraonline com REV 10 02 07 COPYRIGHT 2004 METRA ELECTRONICS CORPORATION INST95 8204
Download Pdf Manuals
Related Search