Brodit 513377 holder
Contents
1. 30 May 2012 www brodit com 2012 Brodit AB 513377 Active holder for fixed installation With tilt swivel with Molex adapter system 2A charger An active holder which is to be connected inside the dashboard this gives a discreet neat installation without cables hanging over the interior You can choose to use the holder as an active holder for charging of your device only or to connect an adapter to the Molex connector for additional features Then you can use the holder also for power supply of a GPS receiver or other own solutions can not be used for data communication or audio connection 12 24 Volt The product is E approved Connect the power cable with a 2 A fuse 2 A charger Professional installation recommended The holder is attached onto a tilt swivel and can be adjusted in order to avoid light reflection Attach onto ProClip Mounting Platform EAN 7320285133778 Item no 513377 fits HTC One X S720e For all countries 1 2 INSTALLATION INSTRUCTIONS Please read all of the instructions and look at the pictures before attaching the holder Important Note The charger unit is fused internally with 2 A automotive re settable thermal fuse but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided Ensure the char2. ger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot Note If you are connecting a GPS Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows 1 Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis 2 Connect the Red wire to a 12 24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle How to mount the holder 1 Unscrew the screw in the center of the holder Remove the holder from the tilt swivel base plate Place the base plate onto the desired position Screw the base plate into place by using the enclosed screws 2 Start to thread the center screw into the base plate When you connect with the nut pull the holder towards you to prevent the nut from spinning around Tighten the screw firmly Then loosen the screw sligthly for easier angling rotation of the holder 3 Slide the device into the holder To remove the device from the holder slide it out Use the tilt swivel to adjust the angle or rotate the holder into a horizontal landscape position if desired 4 The holder is in place 2 2
Download Pdf Manuals
Related Search