Vutec Low Voltage Control Kit
Contents
1. LOW VOLTAGE CONTROL STANDARD MOTORIZED SCREEN 230VAC LOW VOLTAGE WALL SWITCH IR RECEIVER MODULE Jacks for IR Sensor Yellow Green Wire connections 24AWG minimum 100 feet maximum Manual Override Input Terminal Small flat blade screwdriver Yellow hex socket Insert and lift Upper limit switch y White hex socket Input terminal Wire Lower limit switch 18AWG minimum 12AWG maximum This Low Voltage control utilized an IR receiver module to deliver power to the screen motor It is mounted inside a 4x4 standard electrical gang box The Low Voltage control should be placed near the screen motor and easy access for future services The above illustration shows a screen motor and Low Voltage wall switch connected to the IR receiver module The 230VAC 50Hz power supply connections should be of minimum 18AWG wires Connections for the wall switch can be of minimum 24AWG wires if desired The distance between the wall switch and the IR receiver should be no more than 100 feet for proper operation Connections for the screen motor and power input terminals are as follows The wires should be stripped of no more than a 1 4 inch long for insertion As shown in the figure insert a small flat blade screwdriver into the upper slot of the terminal Lift up the screwdriver in the direction of the arrow to open the spring action of the contact Hold the screwdriver up while inserting the wire into the spring contact Hold the wi2. re in place and remove the screwdriver The wire will be held firmly VUTEC CORPORATION TEL 800 770 4700 FAX 800 548 5885 N T te RECOM al E MAIL info vutec com 230VAC 50Hz SUPPLY
Download Pdf Manuals
Related Search