Tripp Lite PowerVerter APS INT 3600W 36VDC 230V Inverter/Charger with Auto Transfer Switching, Hardwired, AVR
Contents
1. Output Voltage Regulation 214 Tripp Lite 1111 W 35th Street 6 Chicago IL 60609 USA Telephone 773 869 1234 Maximum Input Amps Watts Input Connection Type www tripplite com DC INPUT Full continuous load 114A at 36VDC AC INPUT 26 amps at 230VAC with full inverter and charger load 10 4A max charger only combined input load to support charger and AC output is automatically controllable to 66 33 0 based on AC output loading using the charger limiting set points see manual for setting instructions DC INPUT Set of DC bolt down terminals AC INPUT Hardwire via built in junction box with cover plate BATTERY VOLTAGE REGULATION Voltage Regulation Description Includes automatic voltage regulation to correct brownouts and over voltages back to usable levels Overvoltage Correction Over voltages are automatically reduced by 10 Brownout Correction Brownouts are automatically boosted by 10 USER INTERFACE ALERTS amp CONTROLS Set of 6 LEDs offer continuous status information on load percentage 6 levels reported and battery charge level 7 Front Panel LEDs levels reported See manual for sequences Switches PHYSICAL Shipping Dimensions hwd in Shipping Dimensions hwd cm Shipping Weight Ibs Shipping Weight kg Unit Dimensions hwd in Unit Dimensions hwd cm Unit Weight Ibs Unit Weight kg Cooling Method Material of Construction Form Factors Supported 3 position on2. TRIPP LITE Tripp Lite 1111 W 35th Street Chicago IL 60609 USA Telephone 773 869 1234 www tripplite com PowerVerter APS INT 3600W 36VDC 230V Inverter Charger with Auto Transfer Switching Hardwired AVR MODEL NUMBER APSINT3636VR Description Tripp Lite s APSINT3636VR DC to AC inverter with automatic line to battery transfer and integrated charging system serves as an extended run UPS a standalone power source or an automotive inverter Supplies up to 3600 watts of continuous 230V AC power from any 36V battery or automotive DC source When hardwire AC input is energized commercial power passes through to connected equipment and the battery set is recharged via 3 stage selectable wet dry cell battery charger 30 amp high 7 5 amp low In UPS mode the APS system responds to blackouts and severe voltage fluctuations with a near instantaneous automatic transfer to battery derived AC output Includes a set of high current DC input terminals for simple installation user supplies batteries and cabling see owner s manual for recommendations Passes sine wave utility or generator power during battery charging and UPS line power operation plus efficient PWM sine wave AC output in inverter and UPS backup modes Built in Automatic Voltage Regulation AVR corrects line power AC brownouts and overvoltages without using battery power during battery charging and UPS standby modes Reliable large transformer design with frequency control p
3. ery power Applications e Versatile inverter charger system with auto transfer switching serves as an automotive inverter for RVs over the road trucking conversion vans and fleet service vehicles a standalone alternative power source for off grid alternative energy or export applications and as an uninterruptible power supply UPS for items compatible with a 20 millisecond transfer time NOTE For sump pump applications Tripp Lite recommends its UT Utility Truck Inverter Chargers Package Includes e APSINT3636VR Inverter Charger e Instruction manual with warranty information e Wired Remote Switch with full LED status indicators model APSRM4 Tripp Lite 1111 W 35th Street 6 Chicago IL 60609 USA Telephone 773 869 1234 www tripplite com e OverPower inverter output supports longer duration overloads to 150 for 1 60 minutes under ideal battery and temperature conditions e 3 stage selectable wet dry cell battery charger 30 amp high 7 5 amp low e 3 position operating mode switch supports AUTO mode to enable automatic transfer between DC and AC modes CHARGE ONLY to maintain a full battery charge when AC is present without auto transfer and SYSTEM OFF settings e Set of six front panel LEDs display AC DC operational modes overload status DC voltage level shutdown status and system fault status e Set of 4 configuration dipswitches support wet gel battery charging profiles adjustable 259 264V high voltage au
4. et to shutoff or turn on inverter power in response to loads of any level up to 150 watts WARRANTY Product Warranty Period U S amp 1 year limited warranty Canada Product Warranty Period 2 year limited warranty International 2 z Product Warranty Period Mexico year limited warranty i Warranty Period Puerto 1 year limited warranty 2015 Tripp Lite All rights reserved All trademarks are the sole property of their respective owners Tripp Lite has a policy of continuous improvement Specifications are subject to change without notice Photos may differ slightly from final products 414
5. off remote switch enables simple on off power control plus auto remote setting that enables distant on off control of the inverter system when used in conjunction with optional APSRM4 accessory when used in inverter mode In AC uninterruptible power mode auto remote setting enables automatic transfer from line power to battery power to maintain continuous AC power to connected loads Mounting slots enable permanent placement of inverter on any horizontal surface see manual for additional mounting information 3 4 Tripp Lite 1111 W 35th Street Chicago IL 60609 USA Telephone 773 869 1234 www tripplite com ENVIRONMENTAL Relative Humidity 0 95 non condensing LINE BATTERY TRANSFER Transfer Time Line Power to 20 milliseconds typical compatible with many computers servers and networking equipment verify transfer time Battery Mode compatibility of loads for UPS applications Low Voltage Transfer to Battery In AC auto mode inverter charger switches to battery mode as line voltage drops to 144V user adjustable to 163 Power 182V see manual High Voltage Transfer to Battery In AC auto mode inverter charger switches to battery mode as line voltage increases to 259V user adjustable to Power 264 see manual SPECIAL FEATURES Optional load sense function enables automatic inverter shutoff and startup as connected equipment is powered off Load Sensing and on Front panel load sense potentiometer can be s
6. owers resistive electronic loads or large inductive motors compressors and other items with high current needs on startup Included APSRM4 wired remote power switch with full status LEDs provides remote power inverter on off switching and continuous status information APSRM4 included Supports an unlimited amount of runtime with any number of user supplied batteries connected Highly adaptable to a variety of applications and site conditions with adjustable charger settings for wet gel battery types and selectable line to battery power transfer voltages Features e Supports 230V AC output from a 230V AC line power source or 12V DC battery source e 20 millisecond automatic transfer between line and battery power supports UPS protection during blackouts and voltage fluctuations for equipment compatible with a one cycle transfer time e Double Boost inverter output supports momentary startup loads up to 200 of the continuous rating for up to 10 seconds see specification chart 1 4 Highlights e 36V DC or 230V AC input 230V 50 Hz output hardwired e 3600 watts continuous 5400 watts OverPower and 7200 watts DoubleBoost inverter output see specifications e 3 stage selectable wet dry cell battery charger 30 amp high 7 5 amp low e Auto Transfer Switching option for battery backup UPS operation includes wired APSRM4 remote control switch e Automatic Voltage Regulation corrects brownouts and overvoltages without using batt
7. to transfer during overvoltages and selectable 144 163 182 201V AC low voltage auto transfer during brownouts e Set of 4 additional configuration dip switches support 4 levels of charger limiting relative to output load size e Resettable 10A charger AC input breaker and resettable 15A AC output breaker and automatic 2 speed cooling fan protect the inverter from load and temperature related failures e Automatic overload and thermal shutoff safely turns off inverter as excessive loads or overheating conditions develop e Front panel remote control connector enables remote off on switching requires APSRM4 switch accessory Specifications General Info OVERVIEW Style Heavy duty with built in battery charger OUTPUT LINE POWER AC Maintains 230V nominal sine wave output from line power source INVERTER POWER AC Maintains PWM sine wave output voltage of 230 VAC 5 Output Frequency Regulation 50 Hz 0 3 Hz Overload Protection Includes 12A input breaker dedicated to the charging system and 20A output breaker for AC output loads INPUT Nominal Input Voltage s Supported 230V AC DC INPUT Requires 36VDC input source capable of delivering 114A for the required duration when used at full Recommended Electrical Service continuous capacity DC requirements increase during OverPower and DoubleBoost operation For automotive applications professional hardwire installation with 300A minimum battery system fusing is recommended
Download Pdf Manuals
Related Search