Lenmar BCLC1X Charger
Contents
1. other end of the power adapter cable to the power input jack on the rear of the charger unit Status LED s Together the three LED s on the front of the OmniSource Li lon will indicate the status of the battery and the charger See the descriptions and diagrams included in tha following sections regarding the various indications and their meaning Cautions For use with Lithium ion batteries ONLY Use with other type batteries voids warranty may cause damage to the charger battery and possibly cause injury to the user Recharge Li lon batteries after use and before being put away Do not leave the battery connected to camcorder or camera when not to being used Do not leave the battery connected to the charger for prolonged periods Remove the battery after charge is complete Unplug the charger when not in use Do not use place or store the charger where t may come into contact with water or moisture Always replace frayed or damaged wire and broken plugs immediately Use this charger with the power adapters included in the package only It is not necessary or recommended to discharged a Li lon prior to charge Note Batteries will self discharge when not in use whether they are installed in a camcorder digital camera or not Batteries can be kept fresh if you recharge them every 2 3 months NiCD batteries should be stored uncharged Specifications Power Input 12 18 VDC 500mA Charge Method Const2. BATTERY SOLUTIONS OmniSourcee Li lon Universal Charger for Li lon Camcorder amp Digital Camera Batteries PLEASE READ THE INFORMATION AND FOLLOW ALL INSTRUCTIONS THOROUGHLY BEFORE USING THIS PRODUCT Introduction The OmniSource Lithium lon Li lon is a fully automatic camcorder battery charger which is compatible with virtually all 3 6 volt and 7 4 volt Li lon batteries for 8mm VHS C digital camcorders and digital cameras from Nikon Kodak Fuji Sharp Sony Canon JVC Panasonic RCA and other manufacturers In addition other adapter plates are available for virtually all other Li lon battery models This charger uses an advanced charging circuit which provides a safe full charge every time Charging and Full Charge status of the battery is shown on the built in LED indicators Flexible power input allows you to use the OmniSource Li lon from home with Its AC Power Supply or on the road using the DC Cigarette Lighter Adapter included Avoid prolonged use in an automobile whan the engine is not running as It may drain the battery in the vehicle Trouble Shooting Tips The right hand Power Indicator LED will glow red as long as power is connected If not the unit is not receiving power Re check the power connections to the charger when using the car adapter be aware that some cars tum off power to the cigarette lighter when the key is off If the green charge indicator LED turns on immediately when the
3. ant Voltage Rapid Charge Switching to Trickle Charge when full Operation Plug in either the AC 110V or the DC Cigarette Lighter power adapter depending on where you are going to use your OmnlSource Li lon charger unit Connect the other end of the power adapter cable to the power input socket on the charger unit While the unit is receiving power the red Power Indicator LED on the far right will be on See diag 1 Es ES Ee Diag 1 Connect the battery to the adapter plate on the charger unit and the red Charge Indicator LED in the center will tum on to indicate that the unlt is fast charging your battery Le di on dio Diag 2 When the red Charge LED tums off and the green Charge Complete LED tums on tha charger has switched to trickle charge mode and the battery is around 90 charged al this time The battery will reach 100 charge within 1 2 hours depending on the capacity of the battery after the green LED has turned on Be sure to remove the battery from the charger within a few hours after the green LED has turned on Diag 3 Limited 3 Year Warranty This limited warranty starts from the date of original purchase and expires 3 years thereafter If during this period any part because of manufacturing defects or workmanship falls to function properly under normal use will be repaired at no charge for parts and labor or at our option the product will be replaced The following is excluded dama
4. battery is attached the battery may nearly charged already Leave the battery on the unit for 1 2 hours to be sure the battery has been fully charged If aftar you have attached the battery to be charged neither the red or green Charge Indicator LED s tum on the battery or adapter plate may not be properly of fully connected Unplug the unit and check all connections of the battery to the adapter plate and the adapter plate to the charger base Also make sure the adapter plate is the proper one for your battery Use a clean dry cloth when necessary to keep the metal contacts of both charger and battery clean Note It is normal for the charger or the battery to become warm during recharging Getting Ready Choose the adapter plate for the type of battery you will be charging Each of the adapter plates is labeled as to the batteries it can work with If the charger base does not already have the adapter plate you want attached you will need to remove the adapter plate first by pushing down on the plate and sliding It to the rear of the charger base away from the LED indicators Then attach the selected adapter plate to the charger unit by aligning the arrows on the sides of the adapter plates and the charger base as shown While pressing down lightly on the adapter plate slide the plate toward the front of the charger base until it locks Plug in either the AC Adapter or the DC Cigarette Lighter power adapter and connect the
5. ges from delay or loss of use of equipment or damaged batteries malfunctions resulting from misuse tampering unauthorized repairs modifications or accident Package the unit and its accessories carefully using ample padding material to prevent damage in transit and ship It prepaid and insured to Lenmar Enterprises Inc 4035 Via Pescador Camarillo CA 93012 When sending in product for service your package should include evidence of date and place of purchase Enclose 10 00 for shipping and handling for addresses in the U S For outside the U S and Canada freight will vary depending upon ship to address Proposition 65 Notice California The following statement is required In the state of California pursuant te the settlement of an action brought by the Mateel Environmental Justice Foundation against multiple electronics and appliance manufacturers WARNING Handling the cord on this product will expose you to lead a chemical known to the state of California to cause birth defects or other reproductive harm Wash hands after handling For additional questions comments or to explore other Lenmar battery solutions visit our web site at wwwJenmar com or call 805 384 9600 from 9AM SPM PST 300 153 CT
Download Pdf Manuals
Related Search