APC Combination Lock Handle
Contents
1. Japan 0 35434 2021 Local country specific centers go to www apce com support contact for contact information Contact the APC representative or other distributor from whom you purchased your APC product for information on how to obtain local customer support Entire contents copyright 2003 American Power Conversion All rights reserved Reproduction in whole or in part without permission is prohibited APC the APC logo and NetShelter are trademarks of American Power Conversion Corporation and may be registered in some jurisdictions All other trademarks product names and corporate names are the property of their respective owners and are used for informational purposes only 990 1264 02 20032. To disable the lock 1 Dial in the factory set combination 000 or use the key provided up unlocked position 2 Turn the wing knob counterclockwise 180 until the arrow points lt O 180 To change the combination 1 Turn the wing knob until the arrow points up unlocked position Turn it counterclockwise an additional 15 and enter your new combination 2 Turn the wing knob clockwise 15 back to the unlocked position The new combination is set To change the combination you must know the existing one Note NetShelter Combination Lock 3 of 4 www apc com APC Worldwide Customer Support Customer support for this or any other APC product is available at no charge in any of the following ways e Visit the APC Web site to find answers to frequently asked questions FAQs to access documents in the APC Knowledge Base and to submit customer support requests www apc com Corporate Headquarters Connect to localized APC Web sites for specific countries each of which provides customer support information www apc com support Global support with FAQs knowledge base and e support e Contact an APC Customer Support center by telephone or e mail Regional centers APC headquarters U S Canada 1 800 800 4272 toll free Latin America 1 401 789 5735 USA Europe Middle East sie 353 91 702020 Ireland
3. APC NetShelter To remove the NetShelter lock 1 Remove the screws from the lock 2 Remove the handle and screw plate from the NetShelter enclosure To replace the cam 1 35 in 2mm 43mm 2 1710 55 E If your rack has a latch bracket that is 1 35 inches 34 3 mm deep use the cam that is pre i O installed on the combination lock If your rack has a latch bracket that is 2 17 inches 55 2 mm deep replace the pre installed cam with the smaller cam provided a Remove the screw holding the pre installed cam in place Slide the cam off the lock b Replace the old cam with the smaller cam and secure it in place using the screw removed in step a 990 1264 1 of 4 02 2003 To install the combination lock smaller cam shown 1 Slide the handle through the two openings in the enclosure where the original lock was located 2 Insert the screws that you removed from the NetShelter lock and secure the handle in place NetShelter Combination Lock 2 of 4 Combination dials Unlocked position Indicator arrow Locked position 9 O Wing knob To set the lock 1 Turn the wing knob until the arrow points down locked position 2 Jumble the combination in the above illustration or remove the key
Download Pdf Manuals
Related Search