Elica Hidden
Contents
1. plica EN Instruction on mounting and use 5 x gt gt wo Sy 2x 3 5x9 5mm EN Instruction on mounting and use Closely follow the instructions set out in this manual All responsibility for any eventual inconveniences damages or fires caused by not complying with the instructions in this manual is declined The hood is conceived for the suction of cooking fumes and steam and is destined only for domestic use The hood can look different to that illustrated in the drawings in this booklet The instructions for use maintenance and installation however remain the same Itis important to conserve this booklet for consultation at any moment In the case of sale cession or move make sure it is together with the product I Read the instructions carefully there is important information about installation use and safety I Do not carry out electrical or mechanical variations on the product or on the discharge conduits Note the elements marked with the symbol are optional accessories supplied only with some models or elements to purchase not supplied A Caution WARNING Do not connect the appliance to the mains until the installation is fully complete Before any cleaning or maintenance operation disconnect hood from the mains by removing the plug or dis2. light Hood on at power 2 medium Steady red light Hood on at power 3 maximum Flashing red light Hood on intensive power lasting 5 minutes then the hood automatically switches to power 3 Filter control device The hood is equipped with a device that indicates when the filters grease or charcoal must be cleaned or replaced Normally the device that warns when you need to perform maintenance of the filters is disabled To activate it proceed as follows Turn off the hood Press the knob for longer than 5 seconds The LED L2 starts blinking in green after 2 seconds the LED L2 will start flashing also in orange the filter control device is activated 15 L2 Led grease filter indicator The LED lights green when the grease filter needs to be cleaned this happens about every 40 hours Each time the hood is used check whether the L2 LED is turned on Led L2 charcoal filter indicator The LED lights up in orange when the charcoal filter needs to be cleaned replaced this happens about every 160 hours Each time the hood is used check whether the LED L2 is turned on Reset of the filter saturation indicator After cleaning or replacing the filters turn on the hood at any suction speed and press the knob for more than 3 seconds you will hear an acoustic signal beep confirming the reset of the filter saturation indicator at this point the LED L2 and the hood switch off In cases when the L2 LED i
3. cated in an accessible area after installation apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over current category III in accordance with installation instructions Warning Before re connecting the hood circuit to the mains supply and checking the efficient function always check that the mains cable is correctly assembled Warning Power cable replacement must be undertaken by the authorised service assistance centre or similar qualified person Mounting Before beginning installation e Check that the product purchased is of a suitable size for the chosen installation area e Remove the charcoal filter s if supplied see also relative paragraph This these is are to be mounted only if you want lo use the hood in the filtering version e Check for transport reasons that there is no other supplied material inside the hood e g packets with screws guarantees etc eventually removing them and keeping them e f possible disconnect and move freestanding or slide in range from cabinet opening to provide easier access to rear wall ceiling Otherwise put a thick protective covering over countertop cooktop or range to protect from damage and debris Select a flat surface for assembling the unit Cover that surface with a protective covering and place all canopy hood parts and hardware in it e In addition check whether nea
4. connecting the mains electrical supply Always wear work gloves for all installation and maintenance operations The appliance is not intended for use by children or persons with impaired physical sensorial or mental faculties or if lacking in experience or knowledge unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety This appliance is designed to be operated by adults children should be monitored to ensure that they do not play with the appliance This appliance is designed to be operated by adults Children should not be allowed to tamper with the controls or play with the appliance Never use the hood without effectively mounted grating The hood must NEVER be used as a support surface unless specifically indicated The premises where the appliance is installed must be sufficiently ventilated when the kitchen hood is used together with other gas combustion devices or other fuels The ducting system for this appliance must not be connected to any existing ventilation system which is being used for any other purpose such as discharging exhaust fumes from appliances burning gas or other fuels The flaming of foods beneath the hood itself is severely prohibited The use of exposed flames is detrimental to the filters and may cause a fire risk and must therefore be avoided in all circumstances Any frying must be done with care in order to make sure that the
5. e recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal For further detailed information regarding the process collection and recycling of this product please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product Additional Installation Specifications Use only the fixing screws supplied with the product for installation Use the correct length screws which are identified in the Installation Guide WARNING Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards Use The hood is designed to be used either for exhausting or filter version A Ducting version In this case the fumes are conveyed outside of the building by means of a special pipe connected with the connection ring located on top of the hood Attention The exhausting pipe is not supplied and must be purchased apart Diameter of the exhausting pipe must be equal to that of the connection ring In the horizontal runs the exhausting pipe must be slightly slanted about 10 and directed upwards to vent the air easily from the room to the outside Attention If the hood is supplied with active charcoal filter then it must be removed Connect the hood and discharge holes on the walls with a diameter equivale
6. nt to the air outlet connection flange Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction performance and a drastic increase in noise y responsibility in the matter is therefore declined Use a duct of the minimum indispensible length Use a duct with as few elbows as possible maximum elbow angle 90 I Avoid drastic changes in the duct cross section Use a duct as smooth as possible inside The duct must be made of certified material Filter version One active charcoal filter is needed for this and can be obtained from your usual retailer The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid Installation The minimum distance between the supporting surface for the cooking equipment on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers If the instructions for installation for the gas hob specify a greater distance this must be adhered to 14 AN Electrical connection The mains power supply must correspond to the rating indicated on the plate situated inside the hood If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area after installation If it not fitted with a plug direct mains connection or if the plug is not lo
7. oil does not overheat and ignite 13 Accessible parts of the hood may became hot when used with cooking appliance With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities The hood must be regularly cleaned on both the inside and outside AT LEAST ONCE A MONTH This must be completed in accordance with the maintenance instructions provided in this manual Failure to follow the instructions provided in this user guide regarding the cleaning of the hood and filters will lead to the risk of fires Do not use or leave the hood without the lamp correctly mounted due to the possible risk of electric shocks We will not accept any responsibility for any faults damage or fires caused to the appliance as a result of the non observance of the instructions included in this manual This appliance is marked according to the European directive 2002 96 EC on Waste Electrical and Electronic Equipment WEEE By ensuring this product is disposed of correctly you will help prevent potential negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of this product The symbol mw on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste Instead it should be taken to the appropriate collection point for th
8. onal lamps and allow to save 90 electrical energy For replacement contact the technical service 16
9. r the installation area of the hood in the area accessible also with the hood mounted an electric socket is available and it is possible to connect a fumes discharge device to the outside only suction version e Carry out all the masonry work necessary e g installation of an electric socket and or a hole for the passage of the discharge tube In the case of the presence of panels and or walls and or lateral wall units check that there is sufficient space to install the hood and that access to the command panel is easy Operation Use the high suction speed in cases of concentrated kitchen vapours Itis recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking Control panel The control panel is constituted by a knob and 2 led I 1 L2 L1 M To turn the lights on and off Press and release the knob M to turn on the lights press and release again to turn them off To select the available aspiration speeds Turn the knob M clockwise to increase aspiration speed and counterclockwise to decrease it without switching the hood off The hood is provided with a LED L1 that can display the selected aspiration speed based on the colour in which it lights up No light Light off Suction motor switched off Steady green light Hood on at power 1 minimum Steady orange
10. s indicating saturation of the filters either of the grease or of the charcoal filter you must repeat the reset operation Maintenance ATTENTION Before performing any maintenance operation isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse Or if the appliance has been connected through a plug and socket then the plug must be removed from the socket Cleaning The cooker hood should be cleaned regularly at least with the same frequency with which you carry out maintenance of the fat filters internally and externally Clean using the cloth dampened with neutral liquid detergent Do not use abrasive products DO NOT USE ALCOHOL WARNING Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause fire risks Therefore we recommend observing these instructions The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations Panel Fig 20 21 22 23 Clean the perimeter aspiration panel with the same frequency as the ant fats filter using a cloth and not too concentrated liquid detergent Do not use abrasive substances Grease filter Fig 17 19 Traps cooking grease particles This must be cleaned once a month or when the filter saturation indication system if envisaged on the model in posse
11. ssion indicates this necessity using non aggressive detergents either by hand or in the dishwasher which must be set to a low temperature and a short cycle When washed in a dishwasher the grease filter may discolour slightly but this does not affect its filtering capacity To remove the grease filter pull the spring release handle Charcoal filter filter version only Fig 18 It absorbs unpleasant odours caused by cooking The charcoal filter can be washed once every two months using hot water and a suitable detergent or in a dishwasher at 65 C if the dishwasher is used select the full cycle function and leave dishes out Eliminate excess water without damaging the filter then put it in the oven for 10 minutes at 100 C to dry completely Replace the mattress every 3 years and when the cloth is damaged Installation or replacement of the charcoal filter 1 Open the perimeter suction panel 2 Remove the grease filter 3 Insert the charcoal filter pad inside the two rear tabs so that it adheres to the grid for engine protection 4 Block it using the holding grid that is to be installed with the two fixing side screws Note Proceed in reverse order when disassembling 5 Reposition the grease filters 6 Close the perimeter suction panel Replacing lamps The hood is equipped with a lighting system based on LED technology The LEDs guarantee an optimum lighting a duration up to 10 times as long as the traditi
Download Pdf Manuals
Related Search