Hostess IM01A ice cube maker
Contents
1. CLI Ice Maker Instruction Manual Model IMO1A 1 Important Safety Instructions Please read these instructions thoroughly before using this product and retain them for future use N WARNING This appliance must be earthed This Ice Maker is intended for household use only If the power cord is damaged a replacement must be obtained from the manufacturer Hold the plug firmly when removing it do not pull the power cord Do not place the appliance near an open flame cooking or heating appliance or hot surface For indoor use only To avoid electric shock do not open the casing There are no user serviceable parts inside Switch off the power and remove the plug when cleaning the appliance and when the appliance is not in use Do not operate the appliance if it has been damaged in any way This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play with the appliance The appliance must not be transported at an inclined angle greater than 45 Do not turn the Ice Maker upside down as this could cause the compressor or refrigerating system to malfunction A clearance of 150mm should be provided around the appliance to allow air to c2. small ice cubes and the cycle time will be the shortest Ice Full Indicator red When the Ice Container is full of ice cubes the indicator will turn red The ice making cycle will stop after the next batch of ice cubes have been released into the container The unit will then go into standby mode Remove the ice cubes before pressing the STOP and then START buttons to restart the ice making cycle Low Water Indicator red The Ice Maker will automatically check the water level in the Water Tank If the water level is too low the red light will come on and the ice making cycle will stop When water is added to the Water Tank the Low Water Indicator will go off and the unit will automatically restart c Moving the Unit When unpacking or moving the Ice Maker please note that the unit should not be tilted over 45 Keep the appliance upright at all times There are handles at the rear edges of the casing which should be used when moving the Ice Maker See picture C d Locating the Unit Position the Ice Maker on a sturdy flat surface so that there is a clearance of 150mm all around See picture below 2 150mm Sy gt gt 1 50mm ti Ce e Electrical Connection Connect the supply cord to the socket at the rear of the Ice Maker Ins
3. time please remove any ice cubes drain the water from the Water Tank and thoroughly clean and dry the inside of the appliance 4 Technical Specification Climate Type N Ice Making Capacity Ice Storage Water Tank Capacity Rated Voltage Frequency Rated Current Input Power 140W Shock Protection Class Refrigerant R134a 52g Insulation Layer Dimensions 332 h x 260 w x 335 d mm Net Weight 10kg 5 Environmental Note household waste Instead it should be handed over to the applicable collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal SY This symbol on the product indicates that it must not be discarded as general zu 6 Trouble Shooting Possible Cause Possible Solution The compressor Turn off the Ice Maker makes a strange noise Too low voltage Ensure the voltage is normal and restart Ice Full Indicator is on but there is no ice in the Ice Container Room temperature is Remove the Ice Container Wait too low several minutes before replacing the container and then restart the machine Ice blocking trouble Please clean the Ice Container and restart the unit If the Ice Full Indicator fails to go off then the unit will need to be replaced The sensor is broken Please contact Customer Service Low Water Indicator is The sensor is broken Please contact Customer Service Ko low wat
4. er Whether there is no Water conductivity is Drain the unit and clean the Water water or just a little low Tank especially the screw heads at water in the Water the rear of the Tank as these detect Tank but the Low the water level Add water and Water Indicator restart the appliance remains off The sensor is broken Please contact Customer Service Unit is not plugged in Check that the unit is properly Ice Size Indicator is off properly plugged in and the supply switched when the unit is on powered up The fuse on the PCB Please contact Customer Service has blown 7 Customer Service If you encounter any problems with your Hostess Ice Maker please contact the appropriate Service Department Ifthe Ice Maker was bought in the UK please contact Hostess Customer Service Department Crosslee plc Halifax West Yorkshire United Kingdom HX3 8DE Telephone 01422 203963 If the Ice Maker was bought outside the UK please contact your retailer 4213 194 09101
5. ert the 3 pin plug into a 13A socket Ensure that the supply is 220 240V 50Hz Switch off the supply and remove the plug when cleaning the appliance or the appliance is not in use See picture below L Pa 0 A WARNING This appliance must be earthed f Drip Tray Ir FT Y Sl _ E en Yo LES e NSS SNS Position the Drip Tray provided under the front edge of the appliance This will then collect any drops of water that may run down the front of the appliance when the Ice Container is pulled out g Removing the Ice Cubes Slide the Ice Container forwards and use the Ice Scoop provided to remove the ice cubes Push the Ice Container back fully into position when the ice cubes have been removed See picture below h Adding Water Slide the Ice Container fully forwards and then tilt it up slightly to remove it from the unit Use the jug provided to pour potable water into the Water Tank Note Do not ove
6. irculate Thoroughly clean the Water Tank and Ice Container before and after use Change the water regularly to ensure the quality of the ice cubes NOTE Only use still potable water in the Ice Maker Do not fill the Water Tank above the Full level mark If the power is switched off whilst the appliance is operating please wait 3 minutes before switching the power back on again Before storing the Ice Maker drain out the water and dry out the Water Tank and Ice Container The appliance contains flammable insulation foam and refrigeration gases please dispose of the appliance properly inline with local recycling regulations NOTE Please clean the inside of the ice maker thoroughly before use See Section 3 NOTE The first batches of ice cubes produced may not be full size A batch of 10 full sized ice cubes will be produced after approximately 25 minutes Subsequent batches of ice cubes will be produced every 7 10 minutes depending on the ice size selected NOTE Before using the Ice Maker for the first time please stand it upright for approximately 2 hours to allow the cooling system to stabilise following transportation 2 Operation a Ice Making Cycle The ice making cycle has 5 steps 1 Pumping water from the water tank up to the water tray 2 Operating the refrigeration system to create the ice cubes 3 Emptying the excess water from the water tray 4 Releasing the ice cubes into the ice container 5 Re
7. rfill the Water Tank above the Full level See picture below Return the Ice Container into its fully inserted position i Draining the Unit The drain point is located underneath the unit at the left hand side Carefully position the unit over a sink drain and unscrew the plastic cap Remove the rubber bung and allow the Water Tank to empty Slightly tilt the unit to the left hand side to ensure that all the water is removed Replace the rubber bung and the plastic cap See picture below Note The unit should be drained if it will not be used for some time and before the unit is stored 3 Cleaning and Maintenance Note Please clean the Ice Maker regularly Before cleaning the unit switch off the power and remove the plug Remove any ice cubes from the Ice Container and drain all the water from the Water Tank Use a dilute mild detergent in water to clean the inside and outside of the Ice Maker with a soft cloth Rinse and dry thoroughly Do not spray any liquids onto the appliance Do not use any acidic or abrasive detergents When cleaning the inside of the appliance take care not to damage the sensing probes If the Ice Maker will not be used for some
8. turning the water tray to its upright position This cycle continues until the ice container is full of ice cubes or there is insufficient water in the water tank b Control Panel START STOP ICE SIZE START and STOP buttons When the power is connected the unit will go into standby mode One of the ice size indicators will be flashing When the START button is pressed the selected ice size indicator will remain on and the ice making cycle begins When the STOP button is pressed the ice making cycle will stop The water tray will empty the water back into the water tank and any ice cubes will be released into the ice container before the unit goes back into standby mode ICE SIZE button Press this button to select the required size of ice cubes The default size is small The ice size indicator will cycle between small medium large and back to small each time the button is pressed Note If the Ice Maker is operated in a cool ambient it is recommended that Small ice cubes are selected w Large Size Indicator green When this light is on it indicates that the unit is making large ice cubes and the cycle time will be the longest y Medium Size Indicator green When this light is on it indicates that the unit is making medium size ice cubes Y Small Size Indicator green When this light is on it indicates that the unit is making
Download Pdf Manuals
Related Search