Philips BT6000B
Contents
1. Option 1 Battery power The speaker can operate on the built in rechargeable battery Note Rechargeable battery has a limited number of charge cycles Battery life and number of charge cycles vary by use and settings It takes approximately three hours to fully charge the battery The red LED indicator flashes when the battery is low To recharge the built in battery Connect the speaker to AC power supply or Connect the USB cable between the lt socket on the speaker and e aUSB socket on a computer LED indicator Battery status Solid red Under charging Off Fully charged Option 2 AC power Caution e Risk of product damage Make sure that the power voltage corresponds to the voltage printed on the back or underside of the speaker e Risk of electric shock When you unplug the AC adapter always pull the plug from the socket Never pull the cord EN 5 e To turn the speaker on or off rotate the knob clockwise or anticlockwise until you hear a click L gt When the speaker is turned on the blue LED indicator flashes L gt When the speaker is turned off the blue LED indicator lights off and the and the 4 icons are towards the same direction Note e Ifthe battery level is low the red LED indicator flashes e Connect the adapter to the lt socket on the speaker Switch to standby mode e the power2. Always there to help you Register your product and get support at www philips com support a Question EAn Philips BT6000 PHILIPS User manual PHILIPS Contents 1 Important 2 2 Your Bluetooth speaker 3 Introduction 3 What s in the box 3 Overview of the speaker 4 3 Get started 5 Power supply 5 Turn on off 6 Adjust volume 6 4 Use Bluetooth devices 7 Connect a device 7 Play from Bluetooth device 8 Control your phone call 8 Disconnect a device 8 Reconnect a device 8 5 Listen to an external device 9 6 Product information 10 Specifications 10 7 Troubleshooting 11 General 11 About Bluetooth device 11 8 Notice 12 Compliance 12 Care of the environment 12 Trademark notice 13 EN 1 Important Warning Never remove the casing of this speaker Never place this speaker on other electrical equipment Keep this speaker away from direct sunlight naked flames or heat Make sure that you always have easy access to the power cord plug or adaptor to disconnect the speaker from the power Make sure that there is enough free space around the speaker for ventilation After use under humid circumstance immediately clean the product with a soft dry cloth The battery shall not be exposed to excessive heat such as sunshine fire or the like The adapter shall not be exposed to dripping or splashing No objects filled with liquids shall be placed on the adapter Use only pow
3. ake sure that your Bluetooth device is within the effective operational range No response from the speaker e Disconnect and reconnect the power plug then turn on the speaker again e Recharge the speaker About Bluetooth device The audio quality is poor after connection with a Bluetooth enabled device e The Bluetooth reception is poor Move the device closer to this product or remove any obstacle between them Fail to find Philips BT6000 on your device for pairing Press and hold PAIRING for three seconds and then try again Cannot connect with the device e The Bluetooth function of the device is not enabled Refer to the user manual of the device for how to enable the function e This product is already connected with another Bluetooth enabled device Disconnect that device and then try again The paired device connects and disconnects constantly e The Bluetooth reception is poor Move the device closer to this product or remove any obstacle between them For some devices Bluetooth connection may be deactivated automatically as a power saving feature This does not indicate any malfunction of this product EN 11 8 Notice Any changes or modifications made to this device that are not expressly approved by Gibson Innovations may void the user s authority to operate the equipment Compliance C 0890 Hereby Gibson Innovations declares that this pro
4. all press to end the current call During a call press and hold for three seconds to transfer the call to your mobile device Disconnect a device e Press and hold PAIRING for three seconds when there is no incoming call e Disable Bluetooth on your device or e Move the device beyond the communication range L gt The speaker beeps twice and the blue LED indicator flashes Note Before connecting another Bluetooth device disconnect the current device first Reconnect a device When you turn on the speaker it will reconnect the last connected device automatically If not select Philips BT6000 on your Bluetooth device to start connection 5 Listen to an external device With this speaker you can also listen to an external audio device such as an MP3 player Note e Make sure that music playback through Bluetooth is stopped AUDIO IN 1 Open the protective cover on the left of the speaker 2 Connect an audio input cable not supplied with a 3 5 mm connector on both ends to e the AUDIO IN socket on this speaker and e the headphone socket on the external device 3 Play audio on the external device refer to its user manual 6 Product information Note e Product information is subject to change without prior notice General information Power Supply AC Power power adapter Brand name PHILIPS
5. duct is in compliance with the essential requirements and other relevant provisions of Directive 1999 5 EC You can find the Declaration of Conformity on www philips com support This product is designed to be waterproof in compliance with IEC 60529 IPX4 Care of the environment Disposal of your old product and battery ab Your product is designed and manufactured with high quality materials and components which can be recycled and reused ps This symbol on a product means that the product is covered by European Directive 2012 19 EU 12 EN ps This symbol means that the product contains a built in rechargeable battery covered by European Directive 2013 56 EU which cannot be disposed of with normal household waste We strongly advise you to take your product to an official collection point or a Philips service centre to have a professional remove the rechargeable battery nform yourself about the local separate collection system for electrical and electronic products and rechargeable batteries Follow ocal rules and never dispose of the product and rechargeable batteries with normal household waste Correct disposal of old products and rechargeable batteries helps prevent negative consequences for the environment and human health Caution e Removal of the built in battery invalidates the warranty and may destroy the product Always bring your product to a professional to remove the b
6. er supplies listed in the user manual Where the plug of the Direct Plug in Adapter is used as the disconnect device the disconnect device shall remain readily operable EN 2 Your Bluetooth speaker Congratulations on your purchase and welcome to Philips To fully benefit from the support that Philips offers register your product at www philips com welcome Introduction This speaker has passed splash proof test IPX4 and can be used near water With this speaker you can enjoy audio from Bluetooth enabled devices or other external devices What s in the box Check and identify the contents of your package e Speaker e USB cable for charging e Power adapter with 2 interchangeable plugs Short user manual Safety and notice leaflet EN Overview of the speaker 1 PAIRING e Enter Bluetooth pairing mode e Disconnect Bluetooth connection e Answer or reject an incoming call End the current phone call e Transfer the call to your mobile device NFC Connect a NFC compatible device through Bluetooth GB e Charge the built in battery 4 AUDIO IN e Connect an external audio device G Volume knob e Adjust volume e Turn the speaker on or off 3 Get started Always follow the instructions in this chapter in sequence Power supply Either AC power or battery can be used as power supply of this product
7. odel GME10C 050200FBX nput 100 240 V 50 60 Hz 0 28 A Output 5 V 2 A Built in Battery Li ion battery 3 7 V 4400 mAh Standby Power lt 1 W Specifications Consumption Eco Standby lt 0 5 W Power Consumption Amplifier Di I imensions Rated Output Power 2 X 5W RMS Main Unit 188 x 70 x 71 mm Frequency Response 40 20000 Hz 3 dB WxHxD Signal to Noise Ratio gt 65 dBA Weight 0 5 kg Audio In 600 mV RMS 22 kohm Main Unit Speaker Speaker Impedance 8 ohm Speaker Driver 1 5 inch full range Sensitivity gt 85dB m W 2dB m W Bluetooth Bluetooth Version V4 0 Supported Profiles HFR A2DP AVRCP Range 10 m Free space 7 Troubleshooting Warning e Never remove the casing of this device To keep the warranty valid never try to repair the system yourself If you encounter problems when using this device check the following points before requesting service lf the problem remains unsolved go to the Philips Web page www philips com support When you contact Philips make sure that the device is nearby and the model number and serial number are available General No power e Make sure that the AC power plug of the unit is connected properly e Make sure that there is power at the AC outlet e Recharge your speaker No sound e Adjust volume on this product e Adjust volume on the connected device e M
8. outlet e The speaker switches to standby mode in the following situations Tu rn on off e The connection with Bluetooth device or other device is invalid for 15 minutes or e Music playback is stopped for 15 minutes Adjust volume During play rotate the knob to increase or decrease volume 4 Use Bluetooth devices With this speaker you can listen to audio from Bluetooth enabled devices and control the incoming call through Bluetooth Connect a device e The speaker can memorize a maximum of four paired devices The fifth paired device will replace the first one e Make sure that Bluetooth function is enabled on your device and your device is set as visible to all other Bluetooth devices e Any obstacle between this speaker and a Bluetooth device can reduce the operational range e Keep away from any other electronic device that may cause interference e Make sure that no audio input cable is connected to the AUDIO IN socket Option 1 Connect a device through NFC Near Field Communication NFC is a technology that enables short range wireless communication between various NFC compatible devices such as mobile phones and IC tags If your Bluetooth device supports NFC you can connect it with this speaker easily 1 Enable NFC on your Bluetooth device refer to its user manual 2 Turon the speaker L gt The blue LED indicator flashes 3 Tap the NFC tag on the to
9. p of the speaker with the NFC area of your Bluetooth device 4 Follow the on screen instructions to complete the pairing and connection Ly After successful connection the speaker beeps twice and the LED indicator turns solid blue Option 2 Connect a device manually Note e The operational range between this speaker and a Bluetooth device is approximately 10 meters 30 feet On your Bluetooth device enable Bluetooth and search for Bluetooth devices hat can be paired see the user manual of he device 2 Tumonthe speaker L gt The blue LED indicator flashes EN 7 3 Select Philips BT6000 displayed on your device for pairing If necessary input 0000 as the pairing password Ly After successful connection the speaker beeps twice and the LED indicator turns solid blue LED indicator Description Flashing blue Connecting Waiting for pairing Solid blue Connected Play from Bluetooth device Note e If there is an incoming call on the connected mobile phone music play pauses After successful Bluetooth connection play audio on the Bluetooth device L gt Audio streams from your Bluetooth device to the speaker Control your phone call After Bluetooth connection you can control an incoming call with this speaker Button Function C Press to answer an incoming call Press and hold for three seconds to reject an incoming call During a c
10. uilt in battery Environmental information All unnecessary packaging has been omitted We have tried to make the packaging easy to separate into three materials cardboard box polystyrene foam buffer and polyethylene bags protective foam sheet Your system consists of materials which can be recycled and reused if disassembled by a specialized company Please observe the ocal regulations regarding the disposal of packaging materials exhausted batteries and old equipment Trademark notice Bluetooth The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG Inc and any use of such marks by Gibson is under license Other trademarks and trade names are those of their respective owners mNnfc The N Mark is a trademark or registered trademark of NFC Forum Inc in the United States and in other countries This is CLASS I apparatus with double insulation and no protective earth provided EN 13 PHILIPS Specifications are subject to change without notice 2015 Gibson Innovations Limited All rights reserved This product has been manufactured by and is sold under the responsibility of Gibson Innovations Ltd and Gibson Innovations Ltd is the warrantor in relation to this product Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N V and are used under license from Koninklijke Philips N V BT6000_10 UM_V1 0
Download Pdf Manuals
Related Search