Harman/Kardon ONYX STUDIO
Contents
1. you to increase or decrease volume Adjust volume using the Volume Up and Volume Down buttons located on top of the unit Short press Increase decrease volume by 1 step Press and hold Increase decrease volume continuously 1 step per 0 2 second Connecting Bluetooth amp Playing Music through Bluetooth 1 Press the Power button The LED will illuminate white The speaker enters pairing mode when it is switched on 2 Ifthe speaker has been paired with any source before press and hold the Bluetooth button for at least 2 5 seconds Perform a new device search on your Bluetooth capable device 4 Select HK Onyx Studio on the device s pair ing list and enter pasword as 0000 The device will be paired to HK Onyx Studio automatically If pairing is successful the Bluetooth LED will change to white 5 Control playback from your Bluetooth capable device 0 Nyx Stu d 0 Troubleshooting Troubleshooting If your Harman Kardon Onyx Studio is not performing the way you think it should check if the problem is covered in this section before calling your dealer or contacting a Harman Kardon representative Problems Solutions O There is no sound coming from the speaker e No power to unit Make sure that the wall outlet or power strip has power Make sure that all switches for outlet power strip are ON and that all switches for the unit are ON If you have not plugged it to the AC source make sure that the batte2. Onyx Studio Wireless Speaker System with Rechargeable Battery Owner s Manual harman kardon harman kardon by HARMAN Onyx Studio Table of Contents INTRODUCTION 3 DESCRIPTION AND FEATURES 3 DESIGN AND PERFORMANCE 3 WIRELESS CONNECTION 3 INCLUDED ITEMS 3 CONTROLS AND CONNECTIONS 3 TOP PANEL CONTROLS 3 REAR PANEL CONNECTIONS AND CONTROLS 4 LED INDICATIONS 4 OPERATION 4 SWITCHING ON AND OFF 4 ADJUSTING VOLUME 4 PLAYING MUSIC THROUGH BLUETOOTH 4 TROUBLESHOOTING 5 SPECIFICATIONS 5 Onyx Studio Introduction Thank you for purchasing the Harman Kardon Onyx Studio HK Onyx Studio is a premium wireless speaker with an iconic design and comes with a rechargeable built in battery that allows you to stream music from any smart phone tablet or other wireless devices through Bluetooth HK Onyx Studio is a 4 speaker advanced acoustic platform and its dual passive radiators deliver a truly fantastic sound experience with a balanced soundstage and powerful bass response Description and Features Design and Performance Dual passive radiators provide deep bass The built in rechargeable battery offers up to 5 continuous hours of playtime Wireless Connection Wireless connectivity allows you to place the speaker in any part of the room without having to worry over friends and family tripping over cables The HK Onyx Studio supports almost every popular wireless device via Bluetooth Included Items HK Onyx Studio speaker sys
3. ated amp Bluetooth The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG Inc and any use of such marks by HARMAN International Industries Incorporated is under license Other trademarks and trade names are those of their respective owners harman kardon by HARMAN
4. ry is charged Distortion static crackling or hissing sounds e Audio source or source material may be the problem Test the HK Onyx Studio with another source Loud hum or buzzing noise Itmight happen due to ground loop an unsuitable connection Turn the HK Onyx Studio OFF and connect it to another wall outlet Battery not charging No power to unit Make sure that your wall outlet or power strip has power Make sure that all switches for outlet power strip are ON and that all switches for the unit are ON Specifications No of channels 4 Transducers 2X 3 woofers 2 X 34 tweeters 2 x passive radiators Bi amplification 4X 15W Maximum SPL 95dB 1m Power requirement 100 240 V AC 50 60 Hz Power adaptor 19V 2 0A Built in battery 3 7V 2600mAh Cylindrical Lithium lon Rechargeable Battery Power consumption 38W Maximum lt 1W stand by Speaker impedance 4 ohm per speaker Frequency Response 60Hz 20kHz Frequency range 2402MHz 2480MHz Transmitter power lt 4dBm Modulation GFSK n 4 DOPSK 8 DPSK Wireless Bluetooth 3 0 A2DP v1 3 AVRCP v1 5 Dimensions Dia xW x H 280mm X 161mm X 260mm harman kardon HARMAN 2013 HARMAN International Industries Incorporated All rights reserved Harman Kardon is a trademark of HARMAN International Industries Incorporated registered in the United States and or other countries The beautiful sound logo is a trademark of HARMAN International Industries Incorpor
5. tem complete accessories consist of HK Onyx Studio speaker One AC power adaptor Regional power cable Quick Start Guide Safety sheet Warranty Card for some specific countries IMPORTANT If any included accessory is missing or if any part of your HK Onyx studio system fails to operate properly contact your dealer immediately Introduction Controls and Connections This section will help you identify the controls that are provided on the Onyx Studio top and rear panels Top Panel Controls The following control buttons are available on the top panel Power button Volume Controls Bluetooth t 4 Power Button This button when pressed turns the HK Onyx Studio ON or OFF and has an LED to indicate the power mode The two power modes are Operational mode OFF mode When the system is in OFF mode Power LED is not lit press the power button for more than 3 seconds to switch on the system The power LED turns white when the system is turned on To turn the speaker off press the Power button for more than 3 seconds When powered by the battery the speaker will go into off mode automatically after 30 minutes if no music stream is detected The power LED will be turned off To turn the speaker on press the power button for more than 3 seconds NOTE When the system gets into Operational mode from the OFF mode the last used volume setting will be restored Volume Controls Press the button to decrease
6. the volume Press the button to increase the volume Bluetooth This button helps you pair your system with other devices The system enters into Bluetooth pairing mode automatically when it is turned on NOTE The speaker s Bluetooth device name is HK Onyx Studio and password is 0000 Onyx Studio Rear Panel Connections The connections on the rear panel are 1 USB Port For service use 2 Power DC input USB Port The USB port is used to upgrade software as service purpose Power DC Input Connect the AC power adapter to this port to charge the built in battery a Plug AC Power pN 8 110 220 volt power source LED Indications The LEDs present on the top panel indicates the status of the speaker unit Refer to the table below to get a fair idea on the speaker LED indications Operational mode White Slow Flash Battery Charging White Quick Flash Low battery Power LED Factory settings restored Bluetooth LED Bluetooth connected eemo pea _ No Bluetooth device connected Operation Operation Switching ON and OFF The power button on the top panel of the speaker allows you to set your speaker to any of the following power modes Operational mode White constant LED illumination Off mode No illumination To change the power mode Long press Off mode to enter operational mode Long press Operational mode to enter off mode Adjusting Volume The volume buttons on the top panel allow
Download Pdf Manuals
Related Search