Sencor SVC 730RD ALTO vacuum cleaner
Contents
1. STOP button on the vacuum cleaner body Adjusting the suction strength The suction strength may be adjusted by moving the rider on the appliance body small range or by the moveable rider on the hose handler Tip LN If the hose holder on the hose gets clogged during vacuuming disconnect it from the telescopic tube and also disconnect the hose from the vacuum cleaner body Then place the holder inside the suction hole on the vacuum cleaner body and vacuum the stuck dirt out Temporary interruption of the vacuuming process If you want to stop the vacuuming process temporarily place the telescopic tube in the parking position on the rear of your appliance using the notch on the floor inlet nozzle Warning Do not move the appliance from place to place if the hose is in the parking position You may break the parking position holder Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR Using your accessories The narrow slot nozzle may be used to vacuum in hard to reach spaces such as window frames libraries upholstery corners joints etc Pillow nozzle may be used for bed vacuuming or upholstered furniture etc roA Tip Use the narrow nozzle with brush to vacuum in hard to reach spaces that may be scratched easily Ending the vacuuming process At first switch the vacuum cleaner off by pressing the START STOP button and then disconnect the supply cable plug from the wall outl2. or smouldering pieces matches or any other flammable or volatile liquids e g gasoline paint thinners etc e baking flour cement or cleaning dust during wall drilling 11 Pulling the supply cable from the wall power outlet by force may cause damages 12 In order to avoid damages to furniture or injuries to persons hold the cable in your hands as it winds up 13 In order to avoid deformation or fire of plastic components of the vacuum cleaner do not expose the vacuum to direct sunlight do not place it close to heaters open fire or other sources of heat and do not leave the vacuum cleaner operating for too long if the air input is blocked 14 Do not vacuum larger pieces of paper or plastic bags They may easily clog the pipe or hose In case the vacuum becomes clogged for any reason turn it off by removing the supply cable from the wall outlet and clean the pipe or hose 15 Do not use the appliance in an environment with excessive dust EN 2 Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR 16 In order to avoid damaging the hose do not step on it or bend it with force Do not use the vacuum if the hose is bent or damaged in any other way 17 Do not place the electric cord near hot surfaces or over sharp objects Do not place heavy objects on the cable position the cable so that it is not stepped on or tripped over Make sure the electric cord is not touching any hot surface 18 If the supply cable of the vac
3. shock 2 0 0 0 cee ees II Noiselevel sero reee a er eara Eee PSs a a ead Boe E E E lt 81 dB A Supply cable length nnna ga epee ea eRe esos Bone carey owen Sd SSGGMs eels Renee aces 5m Operational range iicc0n dee ed dea awe beds e544 90008 Rhee eed dd Bee edd es 7 5 mM Dust container capacity 5 6 2 2 oe sssaaa eaea 1 51 5 times filtrating system inlet H E P A filter Weight eeaeee bg rs grey ga E e tee ae E ane ot we E e E e a 5 8 kg The declared noise emission level for this appliance is 81 dB A which represents level A of the acoustic power relative to the reference acoustic power of 1 pW Changes in text and technical parameters reserved EN 7 Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING MATERIALS Dispose of packaging material at a public waste disposal site DISPOSAL OF USED ELECTRICAL AND ELECTRONIC APPLIANCES product shall not be treated as household waste Please dispose of this product at your applicable collection point for the recycling of electrical amp electronic equipment waste Alternatively in some states of the European Union or other European states you may return your products to your local retailer when buying an equivalent new product The correct disposal of this product will help save valuable natural resources and help in preventing the potential negative impact on the environment and human health which
4. Vacuum cleaner User s manual SENCOR SVC 730RD SVC 730GR Prior to using this appliance please read the user s manual thoroughly even in cases when you re already familiarised with previous use of similar types of appliances Use the appliance only as described in this user s manual Store the user s manual in a safe place for future reference EN 1 Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR CONTENTS IMPORTANT SAFETY INSTRUCTIONS ananunua auaa 2 DESCRIPTION ea eaae cae a hee eee a a eee ee e a Pee a E eee das 3 ASSEMBLY o o oe e a a tee e e e eee ws te aa ws Bec ae ee eee ote See 4 USING YOUR VACUUM CLEANER evctttaGeseutscsed ee eedee cence dose dst Seer eewee ess 35 528 94 4 STORAGE AND ACCESSORIES oci cc tees ee tbe hv dos die ee ete a ee ete E ee esa Pb eee 5 MAINTENANCE AND CLEANING succanecdsucstiddnseneeeeiobet esd ewewe sewn tebe eededas 5 TROUBLESHOOTING cose e ee eben pest sou a he oe ATENE aA ewes oes ow bus wares 7 TECHNICAL SPECIFICATIONS aasccesesegeced pigeascee ruts eeee de eos eke edits seed sa uedsss 7 LIQUIDATION OF USED ELECTRIC AND ELECTRONIC EQUIPMENT 3 2 0222 0200c00 s0 5eeeuee wea 8 HANDLING INSTRUCTIONS FOR DISPOSAL OF USED PACKAGING MATERIALS 005 8 IMPORTANT SAFETY INSTRUCTIONS 1 We recommend saving the original shipping cardboard box packaging material receipt and warranty card at least for the duration of the validity of the warranty policy In case of tra
5. could be caused as a result of improper liquidation of waste Please ask your local authorities or the nearest waste collection centre for further details The improper disposal of this type of waste may fall subject to national regulations for fines For business entities in the European Union If you wish to dispose of an electrical or electronic device request the necessary information from your seller or supplier Disposal in other countries outside the European Union If you wish to dispose of this product request the necessary information about the correct disposal method from local government departments or from your seller X The meaning of the symbol on the product its accessory or packaging indicates that this i This product meets all the basic EU regulation requirements that relate to it Changes to the text design and technical specifications may occur without prior notice and we reserve the right to make these changes Revision 05 2012
6. cure it in place by turning the filter to the opposite direction Close the bottom lid of the container Make sure the safety lock button is engaged Place the dust container back to the vacuum cleaner Warning b Before installing the dust container and the dust filter back to your appliance make sure that both the container and the filter are completely dry EN 5 Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR Tip We recommend washing the dust container and the dust filter under running lukewarm water Replacing and cleaning of filters Replacing the inflow H E P A filter Remove the dust container from the vacuum cleaner Pull it up to release the safety lock on the filter cartridge and remove it out of the vacuum cleaner by tilting it to the side Replace the filter cassette for a new one and click it back into place Place the dust container back into the vacuum cleaner Changing the outlet filter Press the safety button on the filter grill and remove it by tilting it to the side Change the filter for a new one Then insert the ribbing together with the filter back into the vacuum cleaner Warning Make sure to put the filter in the vacuum cleaner with the plastic grill facing out Cleaning of filters All filters inside the vacuum cleaner are washable If they are soiled wash them under running lukewarm water If the filters are so soiled that washing does not help replace with new fi
7. et Hold the cable with one hand during the winding process With your other hand press and hold the winding button Lead the cable towards the winding mechanism to protect the vacuum cleaner input area from damages Tip 7isN If the winding process stops and part of the supply cable is still outside release the winding button and pull the cable out again by about 50cm and press the winding button again and repeat the winding process Carrying your vacuum cleaner Your appliance may be carried from place to place by holding it by handle Warning Never try to carry your vacuum cleaner by holding the dust container handler STORAGE AND ACCESSORIES Before storage you may disassemble your appliance to each individual part or you may store it assembled and with the telescopic tube stored in one of the parking positions the rear or front position MAINTENANCE AND CLEANING Emptying the dust container Disconnect the hose from the vacuum cleaner Pull the handle up and remove the dust container Place the dust container above a waste bin Press the safety button underneath the suction opening and the dust bottom will open Dust and dirt may be put in regular household waste Also remove the dust filter from the dust container Turn the filter partially and empty the remaining dirt and dust from the filter to the waste bin as well Install the dust filter back to the dust container and se
8. lters Before placing the filter back into the vacuum cleaner ensure that it is completely dry Warning The vacuum cleaner is equipped with a heat safety fuse which in the case of over loading e g blocked filters will turn it off The vacuum cleaner may then only be switched on once it has cooled For this reason carry out regular cleaning i e replace filters this will extend the life of your vacuum cleaner Cleaning your vacuum cleaner Use only clean soft and dry cloth However you may dip the cloth slightly into water Do not use aggressive solutions or paint thinners Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR TROUBLESHOOTING Before you decide to contact authorized service centre read these following tips in the troubleshooting chart Problem Possible cause Recommended action The supply cable is not connected The engine will not correctly in the wall power outlet start The wall power outlet is damaged The vacuum cleaner is not switched on Vacuum cleaner or its air passageways are clogged with dirt of foreign object The dust filter needs cleaning The dust container has been installed incorrectly or in wrong position Filter is clogged The suction output is insufficient The cable is not wound in completely The cable may have slipped down from the winding pulley during winding Inspect the supply cable plug Make sure that it is firmly in
9. nsportation pack the product using the original packaging materials only 2 This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety 3 Children should be supervised to ensure that they will play with the appliance 4 Before connecting the appliance to the wall outlet make sure the voltage stated on the label corresponds with the voltage in your wall outlet 5 Never use accessories which have not been supplied with this appliance or which are not designed for this appliance 6 Do not spray the device with water or any other liquid Do not pour water or any other liquids into the vacuum cleaner Do not submerge the appliance under water or any other liquid 7 Do not use the vacuum cleaner near bathtub or shower 8 If the appliance is being used do not block its air input and output openings Blocked air vents may cause overheating and motor damage 9 If the vacuum cleaner is not used turn it off and disconnect the supply cable from the wall outlet Prior to cleaning proceed in the same manner 10 Vacuuming objects mentioned below may damage your appliance or cause injuries to operating person e wet floor water or other liquids e any sort of sharp objects such as needles pins e burning cigarettes
10. scopic tube Make sure to install the holder on the wider part of the telescopic tube Install the floor inlet nozzle on the telescopic tube Make sure to install the floor nozzle on the narrower part of the telescopic tube Adjust the length of the telescopic tube as needed Adjust the length of the telescopic tube as follow Move and hold the button on the tube forward as shown by arrows and adjust the length of the tube as needed Release the button and move the tube little bit forward until you hear click The telescopic tube is now securely set in position USING YOUR VACUUM CLEANER Connecting your vacuum cleaner to power source wall outlet Pull the plug of the supply cable from the vacuum cleaner until the desired length of the cable is out of the appliance Insert the plug to the wall outlet Warning b Yellow marking on the supply cable tells you that the cable is close to its end Do not pull the cable more than to the red marking Adjusting the floor inlet nozzle 9 according to the floor surface You may set the inlet nozzle according to the floor surface by adjusting the inlet flap If you want to vacuum carpets close the bristles of the inlet inside the inlet nozzle by turning the flap accordingly If you want to vacuum hard and smooth surface move the bristles out of the nozzle by turning the flap accordingly Turning your vacuum cleaner on and off To switch your machine on and off press the START
11. serted in the wall outlet Inspect the wall outlet Turn the appliance on Remove the clogging or foreign object Clean the dust filter Close the dust container Clean the filter Hold the cable during the winding Make sure to apply slight tension by pulling the cable back to the cable during the winding process The cable cannot be Theab kwou ue incored Press the winding button and pulled out p y try to rewind the cable again The speed control is not working The appliance has been broken down The supply cable starts to wind in when you do not need that The winding mechanism has broken down Have the vacuum cleaner repaired by technician only by qualified technician Have the vacuum cleaner repaired by technician only by qualified technician The dust container The dust filter is installed incorrectly or Reinstall and secure the filter in cannot be closed in incorrect position position and try again TECHNICAL SPECIFICATIONS Voltage ee a rare a6 grasa o oie ae ese a were ore po aie ete ea pater as Gare ceva setae we sine wee a a 230 V AC Nominal freq ent lt 5 526 eke uit ue eee eu ane Beek Me Sod eee eo oe esas Meet Get eec ewes ee as 50 Hz Rated power INOW n on hacen Sean caieaekiwea anes dees Sohen ue Ges Hees thee ees 1600 W Maxim m INDU 2 tc mec eed dred peda enneeeec cee dee sede sth a ees eee se a 1800 W Protective class with regards to protection from electric
12. uum is damaged have an authorised service or qualified person replaced it in order to prevent dangerous situations It is forbidden to use the vacuum if it has a damaged electric supply cable or plug 19 In no case should you attempt to repair the unit yourself do not make any amendments to it danger of electric shock Entrust all repairs and adjustments to a specialised company service Failure to do so will void the warranty policy 20 Never use the vacuum cleaner without the protective motor filter output filter or without the dust container installed 21 Pay extra attention if the vacuum is used near children Always place the vacuum away from the reach of children 22 This appliance is designed for household use Do not use in industrial surroundings or outdoors 23 Do not use the appliance for other purposes than intended DESCRIPTION Adjusting the suction strength ww STS Hold Holder eza A amp Telescopic am tube 2 Motor power A output control A Holder Button Winding START STOP A button inlet nozzle EN 3 Revision 05 2012 Vacuum cleaner SVC 730RD SVC 730GR ASSEMBLY Inserting the hose into the air suction hole on the vacuum cleaner Press the safety button on the hose end and insert the hose end into the air suction hole on the vacuum cleaner until you hear click The hose is now secured in correct position Place the holder on the tele
Download Pdf Manuals
Related Search