Denver CRB-818
Contents
1. OPERATING INSTRUCTIONS Bluetooth Clock Radio MODEL DENVER CRB 818 The lightning flash and arrowhead within the triangle is a warning sign alerting you of dangerous voltage inside the product CAUTION WARNING RISK OF ELECTRIC SHOCK To reduce the risk of electric shock do not remove cover or back No DO NOT OPEN user serviceable parts inside Refer servicing to qualified service personnel CAUTION The exclamation point within the triangle is a warning sign alerting you of important instructions accompanying the product WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPLIANCE TO DRIPPING OR SPLASHING LIQUIDS THE AC DC ADAPTOR IS USED AS THE DISCONNECT DEVICE AND IT SHALL REMAIN READILY OPERABLE TO COMPLETELY DISCONNECT THE POWER INPUT THE AC DC ADAPTOR OF THE APPARATUS MUST BE DISCONNECTED FROM THE MAINS COMPLETELY THE AC DC ADAPTOR SHOULD NOT BE OBSTRUCTED OR SHOULD BE EASILY ACCESSED DURING INTENDED USE CAUTION PLEASE NOTE YOU WILL FIND THE RATING LABEL FOR THIS PRODUCT Ax s eee LOCATED ON THE REAR OF THE UNIT CAUTION GROUNDING OR POLARIZATION THE PRECAUTIONS SHOULD BE TAKEN SO THAT THE WIDER BLADE OF THE AC PLUG MUST MATCH THE SLOT IN RECEPTACLE WALL SOCKET NOTE CAUTION SYMBOLS ARE PRINTED ON BOTTOM OF UNIT PLEASE REFER TO INSTRUCTION MANUAL ENG 2 FRONT VIEW LOCATION OF CONTROLS 1 Device rear support stand 2 Slot for2. 3 PRESS BACK tea AND NEXT KEY TO REACH THE HOUR OF THE DESIRED WAKE UP TIME THEN PRESS MODE KEY TO CONFIRM THE DISPLAY WILL NOW SHOW MINUTES FLASHING 4 PRESS BACK tea AND NEXT pei KEY TO REACH THE MINUTES OF THE DESIRED WAKE UP TIME THEN PRESS THE AL MODE KEY TO CONFIRM B ALARM MODE SETTING NOW SELECT THE SOURCE THAT YOU WISH THE UNIT TO PLAY AT THE WAKE UP TIME AS BELOW FOR RADIO PRESS THE ON OFF KEY TO SWITCH ON THE SET DISPLAY BACKLIGHT WILL BE ON TUNE IN THE DESIRED STATION ADJUST THE VOLUME LEVEL AS DESIRED BY PRESSING VOL UP OR VOL DN KEY ONCE THE DESIRED SOURCE IS READY PRESS THE ON OFF KEY TO PUT THE SET INTO STANDBY MODE AND THEN SHORT PRESS THE AL MODE KEY REPEATEDLY TO SELECT THE SOURCE AS DESIRED REMARK bb BUZZER ALARM FM RADIO 1 THE ALARM TIME IS NOW FULLY PROGRAMMED AND THE ALARM SYMBOL WILL APPEAR TO INDICATE THAT THE ALARM FUNCTION IS ACTIVE DISPLAY SHOWS AS FOLLOWS CURRENT TIME FM SYMBOL FM ALARM SYMBOL ENG 5 2 THE SET WILL NOW AUTOMATICALLY SWITCH ON AT THE WAKE UP TIME AS YOU HAVE CHOSEN AS LONG AS THE ALARM FUNCTION IS ACTIVE 3 TO TURN OFF THE UNIT AFTER IT HAS AUTOMATICALLY SWITCHED ON SIMPLY PRESS THE ON OFF KEY ONCE THIS WILL SWITCH OFF THE SET BUT WILL NOT CLEAR THE ALARM SETTINGS AND THE
3. FREQUENCY FM 87 5 108 MHz ENG 8 ALL RIGHTS RESERVED COPYRIGHT DENVER ELECTRONICS A S DENVER www denver elecironics com Electric and electronic equipment contains materials components and substances that can be hazardous to your health and the environment ifthe waste material discarded electric and electronic equipment is not handled correctly Electric and electronic equipment is marked with the crossed out trash can symbol seen below This symbol signifies that electric and electronic equipment should not be disposed of with other household waste but should be disposed of separately All cities have established collection points where electric and electronic equipment can either be submitted free of charge at recycling stations and other collection sites or be collected from the households Additional information is available at the technical department of your city Fill in the blank with the model number of this player so you can find it again later Imported by DENVER ELECTRONICS A S Stavneagervej 22 DK 8250 EGAA DENMARK www facebook com denverelectronics ENG 9
4. AN BE SAVED INTO ONE OF THE MEMORY POSITIONS SEE RADIO MEMORY SECTION RADIO MEMORY STATION PRESET MEMORY STORAGE AT ANY TIME THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE STORED INTO ONE OF THE MEMORY POSITIONS PRESS MEMORY KEY UNTIL P01 FLASHES IN THE DISPLAY PRESS BACK wa AND NEXT KEYS TO SELECT DESIRED MEMORY POSITION THERE ARE TOTAL 20 MEMORY POSITIONS PRESS KEY ONCE TO SAVE THE SELECTED STATION INTO THE SELECTED MEMORY POSITION RECALL ANY SAVED MEMORY SIMPLY PRESS MEMORY KEY ONCE THEN SELECT THE MEMORY POSITIONS BY BACK wea AND NEXT KEYS THE SAVED RADIO BAND WILL BE RECALLED TO CLEAR THE MEMORY OF ANY POSITION SIMPLY SAVE A NEW STATION TO THE SAME MEMORY POSITION USB CHARGING FUNCTION THIS UNIT IS EQUIPPED WITH A DC 5V USB CHARGING PORT ON THE BACK PANEL TO UTILIZE THIS FEATURE SIMPLY CONNECT THE DEVICE YOU WOULD LIKE TO CHARGE EG SMARTPHONE OR TABLET TO A SUITABLE USB CABLE AND PLUG IT INTO THE USB CHARGING PORT THIS FUNCTION IS ONLY ACTIVE WHEN THE UNIT IS PLUGGED INTO AN AC ADAPTOR THE EXTERNAL DEVICE WILL BE CHARGED AUTOMATICALLY WHEN IT IS SUCCESSFULLY CONNECTED EVEN DURING PLAYBACK SPECIFICATIONS POWER SUPPLY DC 5V 2A THOUGH BUILT IN DC JACK EXTERNAL AC DC POWER ADAPTOR 110V 240V 50 60Hz SPEAKER SPEAKER 2 X 2
5. AY BACKLIGHT SIMPLY ADJUST IT AS DESIRED BY PRESSING THE SNOOZE DIMMER KEY REPEATEDLY HI BRIGHTNESS LOW BRIGHTNESS OFF THE DISPLAY BACKLIGHT WILL ALWAYS RETURN TO HI BRIGHTNESS AS THE DEFAULT AFTER THE UNIT BEEN RESET DIGITAL CLOCK FUNCTION THE SET HAS A BUILT IN DIGITAL CLOCK THE DISPLAY WILL CONTINUOUSLY SHOW THE CURRENT TIME HOW TO SET CORRECT TIME 1 SWITCH UNIT TO STAND BY MODE 2 PRESS amp HOLD CLK SET KEY FOR 3 SECONDS DISPLAY SHOWS lf HOUR OR HOUR FLASHING 3 PRESS BACK mea AND NEXT pe KEY TO SELECT 12 HOUR OR 24 HOUR CLOCK DISPLAY SYSTEM 8 PRESS CLK SET KEY TO CONFIRM YOUR SELECTION 4 PRESS BACK mea AND NEXT pe KEY TO SET THE CORRECT HOUR IN THE DISPLAY amp PRESS CLK SET KEY TO CONFIRM 5 PRESS BACK mea AND NEXT gt KEY TO SET THE CORRECT MINUTE IN THE DISPLAY amp PRESS CLK SET KEY TO CONFIRM 6 CORRECT TIME IS NOW SET amp WILL BE SHOWN IN THE DISPLAY ENG 4 ALARM FUNCTION THIS SET IS EQUIPPED WITH 2 ALARM MODES BUZZER AND RADIO BEFORE SETTING THE ALARM MAKE SURE TO SET THE CLOCK SEE DIGITAL CLOCK FUNCTION IN THE PREVIOUS SECTION PREPARE FOR THE ALARM SETTINGS A ALARM TIME SETTING 1 PRESS THE ON OFF KEY TO PUT THE SET INTO STANDBY MODE 2 PRESS AND HOLD AL MODE KEY UNTIL THE DISPLAY WILL NOW SHOW HOUR FLASHING
6. E A CLICK CLICK CLICK REPEATING SOUND WHEN YOU ARE INCREASING OR DECREASING THE VOLUME THIS IS ANORMAL CONDITION amp THE SOUND WILL DISAPPEAR WHEN YOU RELEASE THE VOLUME KEY WHEN YOU REACH THE DESIRED VOLUME LEVEL OPERATION OF RADIO PRESS THE ON OFF KEY ONCE TO SWITCH ON THE UNIT PRESS THE FUNCTION KEY REPEATEDLY UNTIL THE DISPLAY SHOWS FM EXTEND AND ADJUST THE FM WIRE ANTENNA TO OBTAIN THE BEST RECEPTION USE THE PLAY PAIR KEY TO SELECT THE DESIRED MODE STEREO MONO IN SOME CASES WHERE RECEPTION IS POOR IT MAY BE ADVISABLE TO SELECT MONO MODE TO IMPROVE CLARITY OF THE RADIO SIGNAL ENG 7 MANUAL FREQUENCY ADJUSTMENT SCAN MODE PRESS AND IMMEDIATELY RELEASE THE BACK wea AND NEXT KEYS TO SCAN MANUALLY ADJUST THE RADIO FREQUENCY UP OR DOWN BY 1 STEP AT A TIME THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH STEP S POSITION WHEN A DESIRED FREQUENCY OR STATION IS REACHED IT CAN BE SAVED INTO ONE OF THE MEMORY POSITIONS SEE RADIO MEMORY SECTION AUTOMATIC FREQUENCY ADJUSTMENT SEEK MODE PRESS AND HOLD FOR 2 SECONDS THE BACK lt J AND NEXT pei KEYS TO SEEK AUTOMATICALLY ADJUST THE RADIO FREQUENCY UP OR DOWN TO THE NEXT AVAILABLE RADIO STATION THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE NEXT STATION THAT IS FOUND WHEN A DESIRED STATION IS REACHED IT C
7. N THE UNIT ON PRESS THE FUNC KEY UNTIL BT SYMBOL APPEASRS THE LED INDICATOR WILL FLASH TO INDICATE THE UNIT IS ON AND WAITING FOR PARING ON YOUR DEVICE IN THE BLUETOOTH SETTINGS MENU LOOK FOR THE BLUETOOTH DEVICE CALLED DENVER CRB 818 AND SELECT IT TO CONNECT TO THE UNIT THE LED INDICATOR WILL KEEP REMAIN LIT WHEN PAIRED NOTE ONLY ONE DEVICE CAN BE PAIRED AT ANY GIVEN TIME PREPARE YOUR PHONE OR OTHER BLUETOOTHO DEVICE TURN ON THE BLUETOOTH FUNCTION THIS IS USUALLY FOUND UNDER GENERAL SETTINGS OR OPTIONS PLEASE REFER TO YOUR DEVICE S MANUAL FOR FURTHER BLUETOOTHO DETAILS MAKE THE CONNECTION GO TO YOUR DEVICE S BLUETOOTHO SETTINGS ADD OR SEARCH FOR DEVICES IF ASKED FOR A PASS CODE ENTER 0000 THIS IS A ONE TIME EVENT PER DEVICE TO PAIR YOUR UNIT TO ANOTHER ENG 6 DEVICE REPEAT THE ABOVE PREPARATION AND CONNECTION STEPS DISABLING THE CONNECTION TO UNPAIR A BLUETOOTH DEVICE THAT IS ALREADY PAIRED PRESS AND HOLD THE PAIR KEY FOR A FEW SECONDS VOLUME CONTROL INCREASE AND DECREASE VOLUME USING THE VOLUME UP AND VOLUME DOWN KEYS ON THE UNIT OR USING THE VOLUME CONTROLS ON YOUR BLUETOOTHO ENABLED DEVICE NOTE THAT IF THERE IS NO PLAYBACK ENSURE THAT NEITHER THE UNIT NOR YOUR BLUETOOTH DEVICE ARE SET TO ZERO VOLUME AND THE CORRECT DEVICE FOR PLAYBACK IS PAIRED MUSIC PLAYBACK IN BLUETOOTH MODE PRESS THE PLAY PAUSE KEY gt n TO START PLAYBACK AT ANYTIME DURING PLAYBACK PRES
8. S THE PLAY PAUSE KEY gt u PAUSE OPERATION PRESS AGAIN TO RESUME OPERATION AT THE SAME TRACK amp POSITION AT ANYTIME DURING PLAYBACK PRESS AND RELEASE THE NEXT OR BACK KEY i OR gt gt TO SKIP BACKWARDS OR FORWARDS BY ONE TRACK AS DESIRED USING THE AUDIO LINE IN CONNECTION AUX INPUT YOU CAN CONNECT THE AUDIO OUTPUT OF AN EXTERNAL DEVICE SUCH AS A MP3 PLAYER TO THIS UNIT TO LISTEN TO THE SOUND OF THAT DEVICE THROUGH THE HIGH QUALITY AMPLIFIER OF THIS MUSIC SYSTEM TO CONNECT THE EXTERNAL DEVICE PLEASE USE A STANDARD STEREO HEADPHONE 3 5MM TO 3 5MM PLUGS CABLE TO CONNECT THE HEADPHONE OUT OR AUDIO LINE OUT OF THE DEVICE TO THE AUX INPUT SOCKET OF THIS UNIT SELECT THE FUNCTION TO AUX IN BY PRESSING THE FUNCTION KEY ONCE SWITCH ON THE EXTERNAL DEVICE EG MP3 PLAYER START PLAYBACK OF THE EXTERNAL DEVICE AND ADJUST THE VOLUME CONTROL OF THE UNIT TO THE DESIRED LEVEL REMEMBER TO SWITCH OFF THE UNIT AND THE EXTERNAL DEVICE WHEN YOU ARE FINISHED USING THE EXTERNAL DEVICE SWITCH BACK TO BLUETOOTH MODE ANYTIME BY PRESSING THE FUNCTION KEY AGAIN ELECTRONIC VOLUME CONTROL THIS UNIT USES AN ELECTRONIC VOLUME CONTROL PUSH BUTTON TYPE TO INCREASE OR DECREASE THE LOUDNESS OF UNIT PRESS THE VOLUME UP VOL OR VOLUME DOWN VOL KEYS RESPECTIVELY RELEASE THE KEY WHEN VOLUME LEVEL IS AT THE DESIRED LOUDNESS SOMETIMES ESPECIALLY DURING LISTENING TO THE RADIO YOU MAY NOTIC
9. SET WILL SWITCH ON AGAIN AUTOMATICALLY ON THE NEXT DAY AT EXACTLY THE SAME PRESET TIME 4 TO DEACTIVATE THE ALARM PRESS amp RELEASE THE AL MODE KEY THE ALARM SYMBOL AL DISAPPEARS FROM THE DISPLAY 5 TO ACTIVATE THE ALARM AGAIN REPEAT THE PROCEDURE OF ALARM TIME SETTING AS DESCRIBED SNOOZE FUNCTION WHENEVER THE ALARM COMES ON IT CAN BE TEMPORARILY SUSPENDED FOR A SHORT PERIOD OF 9 MINUTES BY PRESSING THE SNOOZE DIMMER KEY ONCE THE ALARM WILL THEN AUTOMATICALLY COME ON AGAIN AFTER THE 9 MINUTES SNOOZE PERIOD HAS ENDED THE PROCEDURE CAN BE REPEATED FOR APPROXIMATELY 90 MINUTES FROM ORIGINAL ALARM WAKE UP TIME AUTOMATIC POWER OFF SLEEP FUNCTION THIS SET HAS A SPECIAL SLEEP TIMER FUNCTION WHICH CAN AUTOMATICALLY SWITCH OFF THE UNIT THIS IS USEFUL FOR SLEEPING TO MUSIC AT NIGHT AT ANY TIME WHILE THE UNIT IS OPERATING PRESS amp HOLD THE SNOOZE DIMMER KEY UNTIL THE SL SYMBOL FLASHES THEN PRESS THE SNOOZE DIMMER KEY REPEATEDLY TO CHOOSE THE AUTOMATIC POWER OFF TIME mins T PuiNs Putus J Putus T Pins PE mins PL mins PE mins PE mins OFF MEANS SLEEP TIMER IS DEACTIVATED BLUETOOTHO WIRELESS PLAYBACK THE UNIT CAN WIRELESSLY STREAM AUDIO FROM ANY BLUETOOTH DEVICE WITHIN 30 FEET SIMPLY PAIR THE DEVICE AND ENJOY WIRELESS PLAYBACK AND CONTROL FROM YOUR BLUETOOTHO DEVICE PREPARE THE UNIT PRESS THE ON STANDBY KEY TO TUR
10. placing your Device Smartphone Tablet LED Display Back key Next key Memory key On Off key Vol AL Mode key Vol CLK Set key 10 Function key 11 Play Pair key 12 Snooze Dimmer key 13 USB output charger port 14 Aux Input socket 15 DC Input socket DC 5V 16 Headphones socket 17 FM antenna wire ENG 3 POWER SUPPLY AC OPERATION EXTERNAL AC DC POWER ADAPTOR THIS SET IS EQUIPPED WITH A DC JACK CAPABLE OF ACCEPTING lt AC ADAPTORS WITH A RATING OF DC 5V 2A AND WITH A PLUG WITH THE FOLLOWING POLARITIES AS SHOWN CENTER POSITIVE PLEASE USE ONLY THE SUPPLIED AC ADAPTOR TO OPERATE THE UNIT USE OF OTHER ADAPTORS MAY DAMAGE THE UNIT OR CAUSE IT TO MALFUNCTION PLUG THE TAIL END OF THE AC ADAPTOR INTO THE DC JACK SOCKET ON THE REAR OF THE UNIT INSERT THE PLUG OF THE AC ADAPTOR INTO A WALL OUTLET WITH AC POWER PRESS THE ON OFF KEY TO SWITCH ON THE UNIT THIS UNIT IS DESIGNED TO OPERATE WITHOUT EVER BEING TOTALLY POWERED OFF IT WILL EITHER BE ON OR IN STANDBY MODE IN STANDBY MODE THE BACK LIGHT OF THE DIGITAL DISPLAY WILL BE DIMMED BUT THE DISPLAY WILL SHOW THE CURRENT TIME CLOCK FUNCTION ANYTIME DURING STANDBY MODE YOU CAN SWITCH ON THE UNIT BY PRESSING THE ON OFF KEY SAVE ENERGY BY SWITCHING THE SYSTEM TO STANDBY MODE WHEN NOT IN USE DIMMER FUNCTION THIS SET HAS A DIMMER FUNCTION TO ADJUST THE BRIGHTNESS LEVEL OF THE DISPL
Download Pdf Manuals
Related Search