Vision TC2-HDMIIPRX
Contents
1. x height RECEIVER DIMENSIONS as above PRODUCT WEIGHT 0 48 kg per set CONSTRUCTION MATERIAL Metal COLOUR White TECHNICAL DETAILS Standard EEE 568B Cable CAT5 5E 6 Bandwidth 50mbs Frame rate 30fps HDMI format supported 1080p 50 60Hz HDMI Version partial 1 4 e g 3D not supported Maximum cable length Standard Ethernet rules apply CAT5 80m between ethernet devices CAT5e 100m between ethernet devices CAT6 120m between ethernet devices Maximum resolution 1080p 50 60Hz Operating temperature range 5 C 35 C Operating humidity range 20 90 Power Consumption 3 Watts max each INPUTS 1 x HDMI type A OUTPUTS 1 x HDMI type A 2 x POWER SUPPLY 100 240v 50 60Hz AC External Power Supply integrated transformer plug type DC Output 5V 2A DC Cable 1 8m Transformer dimensions 76 x 44 x 26mm Interchangeable prongs including UK EU AU US Note a normal figure 8 cable can be plugged into the transformer if preferred COMPLIANCES RoHS WEEE CE and CB compliant ACCESSORIES 2 x Mounting ears 8 TC2 HDMIIP_manual_en WARRANTY This product comes with a 2 year return to base warranty effective from the date of purchase This warranty applies only to the original purchaser and is not transferable For the avoidance of doubt this will be taken from the information held by the appointed national distributor at the point of sale If the product is DOA dead on arrival you have 21 days from purchase date2. IANCE TO RAIN OR MOISTURE All products are designed and imported into the EU by Vision who is wholly owned by Azlan Logistics Ltd Registered in England Nr 04625566 at Lion House 4 Pioneer Business Park Clifton Moor York YO30 4GH WEEE Registration GD0046SY DECLARATION OF ORIGIN All Vision products are made in the People s Republic of China PRC 2 TC2 HDMIIP_manual_en USE ONLY DOMESTIC AC OUTLETS Connecting the unit to an outlet supplying a higher voltage may create a fire hazard HANDLE THE POWER CORD WITH CARE Do not disconnect the plug from the AC outlet by pulling the cord always pull the plug itself Pulling the cord may damage it If you do not intend to use your unit for any considerable length of time unplug the unit Do not place furniture or other heavy objects on the cord and try to avoid dropping heavy objects on it Do not tie a knot in the power cord Not only could the cord be damaged but a short circuit could also be caused with a consequent fire hazard PLACE OF INSTALLATION Avoid installing this product under the following conditions Moist or humid places e Places exposed to direct sunlight or close to heating equipment Extremely cold locations Places subject to excessive vibration or dust Poorly ventilated places Do not expose this product to dripping or splashing DO NOT PLACE OBJECTS FILLED WITH LIQUIDS ON OR NEAR THIS PRODUCT MOVI NG THE UNIT Before moving the un
3. TECHCONNECT TC2 HDMIIP OWNERS MANUAL J www visionaudiovisual com techconnect tc2 hdmiip 1 TC2 HDMIIP_manual_en DECLARATION OF CONFORMITY Where applicable Vision products are certified and comply with all known local regulations to a CB Certification standard Vision commits to ensure all products are fully compliant with all applicable certification standards for sale in the EU and other participating countries The product described in this owner manual is in compliance with RoHS EU directive 2002 95 EC and WEEE EU directive 2002 96 EC standards This product should be returned to the place of purchase at the end of its useful life for recycling WARNINGS RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER OR BACK NO USER SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL user to the presence of uninsulated dangerous voltage within the product s enclosure that may be h The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the of sufficient magnitude to constitute a risk of electric shock to persons important operating and maintenance servicing instructions in the literature accompanying the 1 The exclamation point within an equilateral triangle is intended to alert the user to the presence of appliance WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS APPL
4. by typographical errors inaccuracies of current information or improvements to programs and or equipment may be made at any time and without notice Such changes will be incorporated into new editions of the User Manual 9 TC2 HDMIIP_manual_en
5. here are multiple receivers on a network they will all display the output from one transmitter To setup discreet transmitter and receiver sets on the same network follow these steps Create a Virtual LAN on the network switch for each transmitter and receiver set Example e Connect 15 transmitters to ports 1 15 Connect 15 receivers to ports 16 30 e e Create VLAN 1 and assign ports 1 and 16 e Create VLAN 2 and assign ports 2 and 17 etc NOTE you must have a managed switch to achieve this 6 TC2 HDMIIP manual en TROUBLESHOOTI NG If your system is not operating properly please refer to the following information If the problem persists disconnect from power and contact your AV reseller immediately Problem Yellow light flashing slowly Yellow light flashing guickly no image No yellow light Image flashing or colour incorrect Correction Transmitter and receiver are reversed Source device not outputting signal HDMI input cable not working Reduce resolution of source to match display device Check HDMI output cable Check network cable Network cable is too long network cables are limited to 100m between devices Press reset button Check CAT5e 6 cable wiring It should be wired to 568B standard at both ends If one end has green and orange swapped this is a cross over cable and cannot be used 7 TC2 HDMIIP manual en SPECI FI CATIONS TRANSMITTER DIMENSIONS 110 x 58 x 26 mm length x width
6. it be sure to pull out the power cord from the AC outlet and disconnect the interconnection cords with other units WARNING SIGNS If you detect an abnormal smell or smoke turn this product off immediately and unplug the power cord Contact your reseller or Vision PACKAGING Save all packing material It is essential for shipping in the event the unit ever needs repair IF ORIGINAL PACKAGING IS NOT USED TO RETURN THE UNIT TO THE SERVICE CENTRE DAMAGE IN TRANSIT WILL NOT BE COVERED BY WARRANTY OVERVIEW This product converts HDMI signal into native ethernet signal and allows the signal to be routed through a normal local area network 3 TC2 HDMIIP_manual_en TRANSMITTER DC 5V HDMI IN 1 5V 2A Power input 2 HDMI Input 3 CAT5e 6 Output 4 Reset Button 4 TC2 HDMIIP_manual_en RECEIVER 1 CAT5e 6 Output 2 Reset button 3 5V 2A Power input 4 HDMI Output 5 TC2 HDMIIP_manual_en INSTALLATION NOTE This product is peer to peer and must be used as a set NOTE A power supply is required at each end Connect cables Notes 1 CAT5e 6 cables used should be wired to IEEE 568B standard Unshielded Twisted Pair UTP or Shielded Twisted Pair STP are both acceptable 2 Transmitter can connect directly to receiver without a cross over cable 3 The transmitter and receiver automatically find each other on a network when patched through a network switcher MULTIPLE SETS ON LAN If t
7. to notify the national distributor via your AV reseller The liability of the manufacturer and its appointed service company is limited to the cost of repair and or replacement of the faulty unit under warranty except for death or injury EU85 374 EEC This warranty protects you against the following Failure of any components including the power supply e Damage when the product is first removed from its packaging if reported within 24 hours of purchase If you find you do have a problem with this product you should contact the AV reseller you purchased this product from The original purchaser is responsible for shipment of the product to the manufacturer s appointed service centre for repair We will endeavour to return repaired units within 5 working days however this may not always be possible in which case it will be returned as soon as practicably possible In line with our WEEE commitments the manufacturer endeavours to replace the faulty parts of the product rather than replacing the whole unit This warranty does not protect this product against faults caused by abuse misuse incorrect installation unstable or faulty power input which might be caused by ignoring the guidelines set out in this manual LEGAL DISCLAIMER Because we are committed to improving our products the details above may change without prior warning This User Manual is published without warranty and any improvements or changes to the User Manual necessitated
Download Pdf Manuals
Related Search