Amer AMRDCP100KIT project mount
Contents
1. Model Number AMR DCP100KIT Installation amp Assembly Universal Drop Ceiling Mount amer pp oa c S IMPORTANT Read instruction sheet be le 2 G9 f installation and NS 2 ae C ore you start installation and assembly SSE Before you start make sure all parts listed Ca S 7T are included with your product SS your p Parts List Part Parts Description Qty Part Image Part Parts Description Qty Part Image A M5x45 Drywall 2 fanen Mount plate 1 saaw A A E Not used with 2x2 plate Plastic Anchor 2 r Not used with 2x2 plate G Ceiling Plate moe fejo S 3mm Allen 1 wrench S S 6mm Allen 1 wrench o e Universal Spider 1 Hold Down Clips www amer com For assistance call 1 800 241 1644 Middle Piece 1 C M6 5 Washer Not used with 2x2 plate pee e H f J K L 1 Caddy Speed Link 1 Installation Instructions Step 1 Decide where you want to hang your projector in the ceiling Remove the existing ceiling tile and place the 2 x2 plate in the ceiling using the best orientation for your alignment Step 2 Select the location hole to run wires and cables from the ceil ing Plug the four other holes with the provided plugs Use two 8mm hex bolts H to attach mount plate P to ceiling plate R hex bolt hex bolt Step 3 Insert two Y Toggles S through two of the sixteen slots on the back of the ceiling plate R and wrap cable over rafter or ceiling grid2. as shown m eas EL Integrated Cable Y Toggle Support Safety connection slots choose 2 depending on installation www amer com Step 4 Push Hold Down Clips T down to snap over t bar as lt shown Step 5 Attach the three or four arms M to the universal spider N using the screws H and washers 1 amp L Do not completely tighten the screws yet Step 6 Attach your projector to the arms M Several different screw sizes have been provided with your mount If none of them fit check with the manufacturer for the proper size Once finished make sure all screws from step 3 are tightened Step 7 Carefully hook the universal spider N with your projector attached to the ceiling Installation is now complete Adjustment You can change the tilt of your mount by carefully moving it to the desired position You may need to tighten the two tilt adjustment screws to hold the projector in place To change the facing of your projector first loosen the two swivel screws using the allen wrench Turn the projector to the desired facing and retighten the screws DO NOT CONTINUALLY TURN THE PROJECTOR IN A COUN TER CLOCKWISE DIRECTION This can cause the mount to come apart and may cause injury or damage swivel screw 0 4 swivel screw tilt screw amp tilt screw For assistance call 1 800 241 1644
Download Pdf Manuals
Related Search