Jarden BTF4011AR-BU fan
Contents
1. JCS shall not be liable for any incidental or consequential damages caused by the breach of any express implied or statutory warranty or condition Except to the extent prohibited by applicable law any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty or limitations on how long an implied warranty lasts so the above limitations or exclusion may not apply to you This warranty gives you specific legal rights and you may also have other rights that vary from province to province state to state or jurisdiction to jurisdiction How to Obtain Warranty Service In the U S A If you have any question regarding this warranty or would like to obtain warranty service please call 1 800 253 2764 and a convenient service center address will be provided to you In the U S A this warranty is offered by Sunbeam Products Inc doing business as Jarden Consumer Solutions located in Boca Raton Florida 33431 If you have any other problem or claim in connection with this product please write our Consumer Service Department PLEASE DO NOT RETURN THIS PRODUCT TO ANY OF THESE ADDRESSES OR TO THE PLACE OF PURCHASE 2011 Sunbeam Products Inc doing business as Jarden Consumer Solutions All Rights Reserved Distributed by Sunbeam Products Inc doing business as Jarden Consumer Solutions Boca Raton Florida 33431 154918 GCDS Bl022712 AB BIF2. CLEANING MAINTENANCE INSTRUCTIONS Follow these instructions to correctly and safely care for your fan Please remember REPLACEABLE FUSE If your 5 Amp 125 Volt replaceable fuse blows please order a new fuse at 1 800 253 2764 Follow the below instructions to replace the fuse on the plug User Servicing Instructions 1 Unplug your fan Grasp plug and remove from the caine or other outlet device Do not unplug by pulling on cord 2 Open hs cover located on the top of the plug b using your thumb or a flathead screwdriver to slide the cover down towards the prongs NOTE Ensure that fuse cover is completely open before atfempting to remove fuse 3 Remove fuse carefully by using a small screwdriver Figure 6 to pry the fuse out of the www bionaire com JCS disclaims all other warranties conditions or representations express implied statutory or otherwise compartment by the JCS shall not be liable for any damages of any kind resulting from the purchase use or misuse of or inability to use metal ends of the fuse the product including incidental special consequential or similar damages or loss of profits or for any breach of TOW R FA N see Figure 6 contract fundamental or otherwise or for any claim brought against purchaser by any other party 4 Place pl on a solid flat surface Insert new 5 Amp Some provinces states or jurisdictions do not allow the exclusion or limitation of incidental or consequential dama
3. 401 1AR11 EMI Printed In China BIONAIRE pure indoor living oe a SS a ae oe i a poz a o E Remote Control MODEL BTF4011AR Instruction Leaflet Read instructions before operating Retain for future reference BTF4011AR_11EM1 indd 1 D 9 19 11 11 27 AM PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS When using electrical appliances basic safety precautions should always be taken including the following 1 Read all instructions before using this appliance 2 Use fan only for purposes described in the instruction manual 3 To protect against electrical shock do not immerse unit plug or cord in water or spray with liquids and plug the appliance directly into a 120V AC electrical outlet Close supervision is necessary when any appliance is used by or near children Unplug from outlet when not in use when moving fan from one location to another before putting on or taking off parts and before cleaning Avoid contact with moving parts Do not operate in the presence of explosive and or flamma le umes To avoid fire hazard NEVER place the cord under gs or any parts near an open flame cooking or other heating appliance 9 Do not operate any appliance with a damaged cord or plug after the appliance malfunctions or has been dropped damaged in any manner Discard fan or return to an authorized service facility for examination and or repair Do
4. caions not expressly approved by the party responsible for compliance could void the user s authority to operate the equipment 9 19 11 11 28 AM
5. ce facility for examination and or repair PLEASE READ AND SAVE THESE IMPORTANT SAFETY INSTRUCTIONS Figure D Base Halves E Remote Control A Control Panel B Fan Housing C Remote Control Storage outlet reverse the P electrician to install t BTF4011AR_11EM1 indd 2 THIS APPLIANCE HAS A POLARIZED PLUG one blade is wider than the other To reduce the risk of electric shock this plug is intended to fit in a polarized outlet only one way If the plug does not fit fully in the ug If it still does not fit contact a qualified e proper outlet DO NOT ATTEMPT TO MODIFY THIS PLUG OR DEFEAT THIS SAFETY FEATURE IN ANY WAY INSTALLATION INSTRUCTION SEE FIGURE 1 Figure 2 Power Cord ASSEMBLY INSTRUCTIONS SEE FIGURE 2 Estimated assembly time 5 10 minutes tools required Screwdriver NOTE MAKE SURE YOU REMOVE ALL CONTENTS FROM THE PACKAGE PLEASE CHECK PACKAGING MATERIALS FOR PARTS THAT COULD BE REQUIRED TO OPERATE YOUR FAN 1 Assemble base halves around power cord To secure the base halves together slide the posts of one base half into the slots of the second base half Refer to Figure 2 2 Line up the screws holes of the base halves with the holes located on the bottom of the fan housing Secure with the four screws included with the product Refer to Figure 2 3 Run the Power Cord through the cord channel located underneath the base Refer to Figure 2 4 Turn fan right
6. for 3 seconds located on the control panel or press the power button once on the remote control NOTE Your fan features LED indicator lights When a specific feature is activated on your fan a corresponding LED indicator light will illuminate showing which Edie have been activated Figure 4 Remote Control PowerBution Speed Button l Timer Button Oscillation Button REMOTE CONTROL HANDSET SEE FIGURE 5 NOTE PLEASE REMOVE THE PROTECTIVE STICKER FROM THE REMOTE CONTROL BATTERY BEFORE OPERATION This unit includes one lithium battery CR2025 3V Remove battery before discarding the remote Battery Replacement a Locate the battery compartment on the back of the remote control handset Use a screwdriver to press into the battery cover lock and slide out the battery cover see Figure 5 b Remove old battery c Place new battery into battery compartment d Slide battery compartment into the remote control handset until the Battery Cover Lock is securely latched NOTES e THIS PRODUCT CONTAINS A BUTTON BATTERY IF SWALLOWED IT COULD CAUSE SEVERE INJURY IN JUST 2 HOURS SEEK MEDICAL ATTENTION IMMEDIATELY interference to radio or television reception which can be determined by turning the product on or off the user is encouraged fo try to correct the interference by one or more of the following measures e Remove the battery from the equipment when it is not being used for an extended period of ti
7. ges 125 Volt tuse into fuse compartment and use a small screwdriver to secure the metal ends of the fuse into the compartment CAUTION Risk of fire Replace fuse only with 5 Amp 125 Volt fuse 5 Slide fuse cover closed completely If fuse cover is difficult to close make sure fuse is secured in place completely by pressing down on metal ends of the fuse 6 Risk of fire Do not replace attachment plug Contains a sal device fuse that should not be removed Discard product if the attachment plug is damaged FAN CLEANING e Always unplug the fan before cleaning e Do not allow water to drip on or enter into fan housing e Be sure to use a soft cloth moistened with a mild soap solution e Do not use gasoline thinner or benzene as a cleaner Clean the fan grill housing and base with a soft damp cloth Do not attempt to remove the fan blade Please use caution around the motor housing area Do not allow the motor or other electrical components to be exposed to water FAN STORAGE When storing your fan in the off season it is important to keep it in a safe dry location It is important to protect the fan head from dust If you have any questions regarding your product or would like to learn more about other Bionaire products please contact our Consumer Service Department at 1 800 253 2764 or visit our website at 5 YEAR LIMITED WARRANTY Sunbeam Products Inc doing business as Jarden Consumer Solutions co
8. llectively JCS warrants that for a period of five years from the date of purchase this product will be free from defects in material and workmanship JCS at its option will repair or replace this product or any component of the product found to be defective during the warranty period Replacement will be made with a new or remanufactured product or component If the product is no longer available replacement may be made with a similar product of equal or greater value This is your exclusive warranty Do NOT attempt to repair or adjust any electrical or mechanical functions on this product Doing so will void this warranty This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable Keep the original sales receipt Proof of purchase is required to obtain warranty performance JCS dealers service centers or retail stores selling JCS products do not have the right to alter modify or any way change the terms and conditions of this warranty This warranty does not cover normal wear of parts or damage resulting from any of the following negligen use or misuse of the product use on improper voltage or current use contrary to the opaan instructions disassembly repair or alteration by anyone other than JCS or an authorized JCS service center Further the warranty does not cover Acts of God such as fire flood hurricanes and tornadoes What are the limits on JCS s Liability
9. me e Remove the used battery promptly e Do not discard used batteries into household trash containers Contact your local government for disposal or recycling practices in your area Figure 5 A Battery Cover Lock B Battery Cover FCC STATEMENT Potential for Radio Television interference This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation This product has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC rules These limits are designed to provide reasonable protection against harmful interference in a residential installation The product generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that the interference will not occur in a particular installation If the product does cause harmful Reorient or relocate the receiving antenna Increase the separation between the product and the receiver Connect the product into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Changes or hodi
10. not run cord under carpeting Do not cover cord with throw rugs runner or similar coverings Do not route cord ii furniture or appliances Arrange cord away from traffic area and where it will not be tripped over The use of attachments not recommended or sold by the appliance manufacturer may cause hazards 12 Do not let the cord hang over the edge of a table counter or come in contact with hot surfaces or leave exposed to high traffic areas 13 Do not use outdoors nau A coco O O 14 To disconnect grip plug and pull from wall outlet Never yank on a 15 Always use on a dry level surface 16 Do not operate fan until fully assembled with all parts properly in place 17 This product is intended for household use ONLY and not hr commercial or industrial applications 18 WARNING To reduce the risk of electrical shock and injury to persons do not use in window 19 WARNING To reduce the risk of fire or electric shock do not use this fan with any solid state speed control device 20 This product employs overload protection fuse A blown fuse indicates an overload or short circuit situation If the fuse blows unplug the product from the outlet Replace the fuse as per the user servicing instructions follow product marking for proper fuse rating and check the product If the ae uit fuse blows a short circuit may be present and the product should be discarded or returned fo an authorized servi
11. side up and place on a dry and level surface Figure 3 Control Panel A Power Speed Button E Timer Indicator Lights S 2hr 4hr 8hr F Timer Button C C Speed Indicator Lights 1 5 G Oscillation Button ea D Breeze Mode Indicator Light OPERATING INSTRUCTIONS SEE FIGURE 3 4 l To turn the fan on press the power speed button 9 located on the control panel or press the power button on the remote control 2 The fan will run at the lowest speed setting 1 To cycle through to higher speed settings 2 3 4 5 press the power speed button located on the control panel or press the speed button on the remote control The corresponding indicator light will illuminate to indicate which setting is selected 3 To turn the oscillation on and off press the oscillation button es located on the control panel or remote control 4 To set your fan to automatically shut off press the timer button CS located on the control panel or the remote control When set the fan will run an automatically shut off after the set duration of time 2 4 or 8 hours has expired 5 To activate the breeze mode press the breeze button SF located on the control panel or remote control When turned on the fan will randomly cycle through the five speeds settings recreating a natural outdoor reeze 6 To turn the fan off press and hold the power speed button S
Download Pdf Manuals
Related Search