Peavey Electronics AT-200
Contents
1. 4 VOLUME AUTO TUNE CONTROL Strum all six strings evenly and push down on the volume knob to engage tuning cy Features and specifications are subject to change without notice Peavey Electronics Corporation 5022 Hartley Peavey Drive Meridian MS 39305 601 483 5365 FAX 601 486 1278 www peavey com 2012 EX000154 Solid Tune is a trademark and Antares and Auto Tune are registered trademarks of Antares Audio Technologies All rights reserved2. Peavey AT 200 Quick Start Guide This quick start guide is designed to get you playing right away 1 Install four fresh AA cells in the battery compartment 1 on the rear of the guitar For maximum battery life use lithium ion batteries or good alkaline batteries Battery Cautions Take great care not to install the batteries backwards Do not mix used and new batteries Do not mix battery type Do not expose device to water Remove batteries when device is not used for long periods of time to avoid damage caused by battery leakage N Plug a 1 4 cable into the guitar 2 and into your amplifier w Adequate string tension is necessary in order for the String Tune function to work properly Strings that are too loose more than five half steps will not sense properly 4 To turn on the Auto Tune for Guitar system you must have a plug inserted in the output jack and the push pull switch that is part of the Tone knob 3 must be in the down position The LED 5 on the side of the neck pickup bezel will light steadily to indicate that the system has power 5 Strum all the strings evenly then push down on the volume knob 4 You should hear a tuning sound which indicates that the AT 200 has been tuned 5 LED INDICATOR 1 BATTERY BOX ON BACK OF GUITAR Install four AA batteries 2 JACK PLATE 1 4 output Make sure the guitar is plugged in 3 TONE CONTROL Pot down Turns on the Antares system
Download Pdf Manuals
Related Search