EK Water Blocks 3831109855218
Contents
1. and fasten remaining M3x8 screws HINT do not tighten screws until they are all positioned in their mounting holes Please note that nuts must be used on M3x8 screws in order to provide proper connection of PCB and backplate Backplate has milled in standoffs so there is no fear of overtightening the screws Nevertheless do not exaggerate with screwing force as there is no need for it Please note that EKWB holds no responsibility of any kind if assembly is not made by instructions This applies also for all products that are not out of EKWB production line Users must by all means also consider instructions that are being made for proper use of FC blocks Use enclosed allen key on M3x12 screws M3x8 screws screws to attach backplate en me gt et a a mu jt REQUIRED TOOLS AND MOUNTING SCREWS P P 3 x screws M3x12 7991DIN 4 x M3x8 7991DIN 4 x M3 nut 2mm allen key All disclosures notices and warranty conditions are being written on the back of the box Released on 19 of May 20102. ekwD Installation and mounting manual for EK FC480 GTX backplate This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EK Water Blocks assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwaterblocks com for updates Before installation of this product please read important notice disclosure and warranty conditions printed on the back of the box STEP 1 GENERAL I NFORMATI ON Sample picture of NVidia GeForce 480 GTX graphic card E ENIS 1006 IF I ie TELLEF DLL HUTS 600 GFi00 375 43 a O gt i O AE EEHTH i envi LRL f TTT AUUOUOT UUT UT OIOI STEP 2 PREPARING YOUR GRAPHIC CARD 480 GTX EK FC480 GTX backplate is very easy to install First install EK FC480 GTX water block according to its manual If you have it already installed please check below which mounting screws for water block are to be left in their position Please remove all other screws not encircled cs STEP 3 ATTACHING EK FC480 GTX BACKPLATE Take enclosed mounting screws and install them as shown on picture below EKWB recommends users to start with M3x12 screws please use M3 washers on all mounting screws Afterwards turn card around
Download Pdf Manuals
Related Search