EK Water Blocks 3831109840511
Contents
1. nough force has been used and Sealing Screws M3x6 DIN7985 NUS Released on 29 of July 2010 Make sure you use the inlet hole marked on bottom picture only as inlet not as outlet However to make reservoir fully functional use holes as marked bellow Make sure outlet holes are plugged with enclosed plugs z r P omm Tg ed praua Predrilled holes for 5mm LEDs acrylic version only Outlet nai EK Plugs Fill reservoir through fill port marked by arrow and make sure liquid is not spilled all over your computer or any electrical devices nearby Run your pump shortly for couple of times to make sure water floods your tubes and other water cooling components Repeat that step by observing water level in your reservoir Idealy there should be as much water to make waterfall still available in reservoir max level indicator When you are done with filling please close your reservoir with G3 8 plugs and tighten them with enclosed allen key Me a r E F a T a a a a a t k a fl h 5 b i hlk 7 a a F meee age E ee ae i ume at Released on 29 of July 20102. omg ekwD Installation and mounting manual for EK BAY Spin DUAL Loop reservoir This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EKWB d o 0 assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwaterblocks com for updates The barb hose fittings require only a small amount of force to screw them in otherwise the high flow fittings might break These fittings do not need to be tightened with much force because the liquid seal is made using o rings EKWB recommends 24 hour leak testing for all EK products before powering on the computer This will eliminate any damages that may occur because of the users improper installation or products imperfections Take your reservoir and place it on a table If you bought extra impleres and you wish to change them then simply unscrew all screws attached with allen key to acrylic top and replace impeler Before closing reservoir blow gently on impeler and make sure it spins flawlessly and without any unusual noises If you Suspect disturbances please check hole in impeler When attaching top back to housing make sure you do not use too much force since acrylic is prone to cracking Usually when gasket flatens equally this means e
Download Pdf Manuals
Related Search