EK Water Blocks 3831109830048
Contents
1. 14 pcs of M2 5x20 Screws 4 pcs of M4x16 screws Use enclosed alen key Picture 3 Applying thermal pads on 295GTX single PCB back RAM modules Total of 14 pieces Thermal pad is 0 5mm thick and pre cut Please do not forget to remove plastic foil from both sides of thermal pad Step 4 Place 2 O rings in the channels on both side of the POM Acetal Link between the blocks Then align the Link part with the holes for M4x16mm screws Use enclosed allen key to screw these screws Step 5 Place the graphic card on the inverted water block and attach it with enclosed screws as shown in picture 3 For perfect thermal contact the block does not use a spring mounting system To prevent warping of the card please block has integrated standoffs When tightening the screws do not use high force When you feel back force of the screw stop applying additional force Step 6 Attach the liquid cooling tubes and connect the water block s into the cooling circuit With EK FC295 GTX series water blocks we recommend use of high flow fittings To ensure that the tubes are securely attached to the barb fittings please use hose clamps or an appropriate substitute The use of an algaecide is always recommended for any liquid cooling system VERY I MPORTANT NOTICE While all efforts have been made to provide the most comprehensive tutorial possible EKWB assumes no liability expressed or implied for any consequential damage s occurring to your equipment2. Installation and mounting manuals for EK 295 GTX Single PCB water block The only water block on the market to cool also back RAMs and with parallel water flow over the gpu s This product is intended for installation only by expert users Please consult with a qualified technician for installation Improper installation may result in damage to your equipment EK Water Blocks assumes no liability whatsoever expressed or implied for the use of these products nor their installation The following instructions are subject to change without notice Please visit our web site at www ekwaterblocks com for updates The barb hose fittings require only a small amount of force to screw them in otherwise the high flow fittings might break These fittings do not need to be tightened with much force because the liquid seal is made using O rings Fitting with o ring Please use spacer with o ring on both sides Front and back and top Picture 1 Sample picture of fitting installation Step 1 Remove the graphic card from computer Step 2 Follow the steps explained in EK FC295 GTX Single PCB water blocks Step 2a Removing the stock cooler o Oz i a 2 or ee gt l ai PETT AE j a i e O Sa S iE we KEE T bt Em ugt Eey pa an Sa at a EE aR a ara z a a k Unscrew all 17 encircled screws including backplate and store them Step 3 Apply pre cut 0 5mm thick thermal pads on all 14 back RAM modules
3. as a result of using EKWB cooling products either due to errors or omissions on our part in the above instructions or due to failure or defect in the EKWB cooling products
Download Pdf Manuals
Related Search