Avanti RS88B safe
Contents
1. MODEL RS88B nk SECURITY SAFE INSTALLATION AND USAGE INSTRUCTIONS Your Avanti Room Security Safe is supplied with the followin 1 Security Safe Unit 4 1 5V Batteries 2 Emergency Access Keys 4 Felt Liner 1 Installation Usage Guide _ Installation Screws LCD display Case Door panel Digital e kevped Key hole cover Door panel _Handle Key hole Outside INSTALLING YOUR SECURITY SAFE When installing your safe be sure the location is sturdy enough to support the unit and is both secure and easy to access Safe can be installed onto either a concrete or wooden surface When installing use a 25 64 10mm drill bit and screws To prevent removal of your security safe it is recommended to use Allen type screws not included to affix the unit to the installation location BOTTOM Panel BACK Panel Boe 71181 200me 3 7 100mm 3s 100mm INITIAL SETUP AND CONFIGURATION After you have installed the unit in its final location proceed to set up digital access controls 1 2 3 4 5 6 7 NOTE Using the emergency Access Key open the safe Open the battery compartment cover Following the image shown in the battery compartment install 4 AA size batteries Close the battery compartment cover The words ALL READY will be displayed on the LCD display for approximately 1 second the security safe will then go into S2. TANDBY Mode Once in STANDBY Mode the LCD display will show the date and time YY MM DD Using the keypad enter the initial setup password 1234 or the administrator password 8888 Battery Life Level indicator The battery indicator on the LCD display will show the current status of the batteries Always replace all of the batteries at the same time If at any time the battery level is too low to operate the security safe use the emergency access key GUEST USER CODE SETUP To reset the access code read and follow the steps below 1 2 3 4 5 With the door open enter a new 4 8 digits code and press the key to confirm the new pass code You will hear and see the security lock engage and the word CLOSE will be displayed on the LCD screen Enter the new pass code and press the key again to open the security safe The security lock will disengage and the word OPEN will be displayed on the LCD screen Close the door and enter the new code set up in step 1 and press the key The word CLOSE will be displayed on the LCD screen and the security lock will engage If the Guest User enters the wrong pass code three 3 times in a row the alarm will sound for 1 minute and will continue to sound in 1 minute intervals until the correct code is entered or the emergency access key is used to open the safe RESETTING THE ADMINISTRATOR PASSWORD To reset the acce
3. ss code read and follow the steps below 1 2 3 4 With the door open press the key to activate the keypad then press the O key twice then press the red button on the battery compartment once to enter the programming mode Once in the programming mode you will hear a DI sound and LCD display Enter the new 4 8 digits administrator password and press the key to confirm The word INTO will show on the LCD display to confirm the new password has been set up successfully will be shown in the Se we Avanti Products Miami FL 33172 Service Issues 1 800 220 5570 C
Download Pdf Manuals
Related Search