Oregon Scientific RM313PNA-B
Contents
1. Set Alarm section for set up instructions NOTE The alarm is activated whenever the icon shows on the display MODE SET A 5 Press to view day of week or seconds or press and hold for 3 seconds to set the time date and display language Refer to the Set Time and Date section for instructions PROJECTION ON A 6 Slide to enable or disable continuous time projection The AC power adaptor must be plugged his feature to work LCD DESCRIPTIONS TIME The top line of the display shows the hours minutes and time zone A RADIO FREQUENCY SIGNAL The RF signal indicates the strength of U S Atomic Clock signals reception To disable the signal for example if you wish to manually set the time press and hold ZONE for 2 seconds Y ALARM ON When is shown the alarm is activated Press to turn the alarm on or off ALARM MODE When is shown the clock is displaying the alarm time Alarm time is displayed in hours and minutes AM PM MONTH DATE The second line of the display shows the month and date Press MODE SET to switch views US MAP The U S Map indicates which Time Zone is selected Press ZONE to switch between Pacific Mountain Central or Eastern Time DI LOW BATTERY Replace the batteries whenever 4 is shown TEMPERATURE The indoor temperature is shown in the lower right corner of the LCD display Temperature is measured in F only This produ2. the button with the point of a Operation is subject to the following two blunt object such as a bail point pen whenever ABOUT OREGON SCIENTIFIC conditions 1 This device may not cause harmful the clock is not behaving as expected This will Visit our website www oregonscientific com to interference 2 This device must accept any return all settings to default value learn more about Oregon Scientific products interference received including interference that If you re in the US and would like to contact our may cause undesired operation SAFETY AND CARE Customer Care department directly please visit ia p Wash the unit with a slightly damp cioth and mild www oregon com service support as detergent Avoid dropping the unit or placing it in For international inquiries please visit www2 a high traffic location ategonsclentific com aboutintemnational asp WARNINGS This product is designed to give you years Rol of service if handled properly Observe the following guidelines Never immerse the unit in water A Thi cause electrical shock N This device complies with Part 15 of the FCC and damage the unit rapa s h Rules Operation is subject to the following two x f gt en fo i T Do not subject the main unit to conditions 1 This device may not cause harmful extreme force shock or fluctuations interference and 2 This device must accept in temperature or humidity any Interf
3. ct has two displays Clock with day of week in English French or Spanish and Calendar display with month and date The time is automatically updated by the U S Atomic Clock in Boulder Colorado unless you disable this feature Signals are collected by the main unit when it is within 932 miles 1800 km of a signal Initial reception takes 2 10 minutes and is initiated when you first setup the unit and whenever you press RESET Once complete the reception icon will stop blinking The icon 1s shown in the Clock Area Strong signal Weak signal No signal Poe l To force a manual search for Atomic Clock signals press and hold UP for 2 seconds If no signal is found check the batteries INOTE 1f the Atomic Clock signal is received and the hour is incorrect use the ZONE button to adjust to the correct timezone refer to the U S map ican PROJECTOR BACKLIGHT Press SNOOZE to activate the projector and backlight for 5 seconds To use the continuous projection feature connect the AC power adaptor to a wall outlet Figure Cc and slide the PROJECTION ON switch A 6 to the On position Then press SNOOZE to activate continuous projection To deactivate continuous projection slide the PROJECTION ON switch to the Off position BATTERIES FIGURE B This product operates on 2 AA size batteries To activate the unit open the battery compartment and replace the batteries whenever D9 shows on the di
4. erence received including interference Do not tamper with the internal that may cause undesired operation components Doing so will terminate the unit s warranty and may cause damage The unit contains no user CARRIS Changes or modifications not expressly approved by the party responsible 3 for compliance could void the user s authority to Do not mix new and old batteries operate the equipment or batteries of different types Do not use rechargeable batteries serviceable parts i with this product INGE This equipment has been tested and i found to comply with the limits for a Class B digital Remove the batteries if storing this device pursuant to Part 15 of the FCC Rules product for a long period of time These limits are designed to provide reasonable Do not scratch the LCD display protection against harmful interference in a Read this instruction manual residential installation thoroughly before operating the unit The contents of this user manual This equipment generates uses and can are subject to change without radiate radio frequency energy and if not further notice installed and used in accordance with the instructions may cause harmful interference Images not drawn to scale Cau fo radio communications However there is Do not make any changes or no guarantee that interference will not occur in modifications to this product a particular installation If this equipment does Unauthorized c
5. hanges may void cause harmful interference to radio or television your right to use the product reception which can be determined by turning the equipment off and on the user is encouraged TROUBLE SHOOTING to try to correct the interference by one or more of the following measures Check here before contacting our customer i ra Reorient or relocate the receiving antenna service department Increase the separation between the Problem Remedy equipment and receiver p Connect the equipment into an outlet on l kg quip toed ead jotumion tre Dally a circuit different from that to which the same time receiver is connected every day Consult the dealer or an experienced radio TV technician for help No power Check the batteries or dim ispl st display The following information is not to be used as contact for support or sales Please visit our No Check the AC power website at www2 oregonscientific com service continuous adaptor It should be for ali enquiries projection plugged in We Check the PROJECTION Name Oregon Scientific Inc ON switch it should be in Address 19861 SW the On position 3 P 95th Ave Tualatin Oregon 97062 USA Strange Check the time zone and date time display language Telephone No 1 800 853 8883 2008 Oregon Scientific All rights reserved 086L003323 067
6. recon SCIENTIFIC PROJECTION ALARM CLOCK WITH 472 BACKLIGHT Model RM313PNA User Manual FEATURES Time display with Hour Minutes Seconds Day and Date Day of Week displayed in English French or Spanish Blue Hf backlight Alarm with 8 minute snooze Crescendo Alarm increases in volume and intensity Adjustable U S time zone One touch time projection onto the ceiling for continuous night time display Low battery indicator PRODUCT OVERVIEW Figure A pee A Figure B Figure C BUTTON DESCRIPTIONS FIGURES A 1 A 6 SNOOZE A 1 Press SNOOZE to illuminate the backlight for 5 seconds view the projected time for 5 seconds or snooze the alarm for 8 minutes WHE The backlight and projector work together Both light up at the same time A ARROW A 2 Press to increase a vaiue or press and hold to turn on RF clock signal reception from the U S Atomic Clock in Boulder Colorado Refer to the Set Time and Date and Set Alarm sections for more instructions Y ARROW A 2 Press to decrease a value ZONE A 3 Press to select the U S Time Zone Once the desired zone is highlighted the clock will automatically adjust the time Press and hold for 2 seconds to turn off the RF clock signal reception from the U S Atomic Clock in Boulder Colorado Y ALARM A 4 Press to turn the alarm on or off Refer to the
7. splay Always match the correct polarity as shown in the battery compartment SET TIME AND DATE i 4 Press and hold MODE for 3 seconds 2 Select the hour minutes year month date and display language Press or to change the setting Press MODE to confirm wee The language options are E English F French and S Spanish 1 Press and hold for 3 seconds 2 Select the hour and minutes Press A or W to change the setting Press to confirm INOTE Alarm is automatically activated whenever you change the alarm time TURN ALARM ON OR OFF SPECIFICATIONS declare that the product Product No RM313PNA When activated the alarm starts quietly then Atomic Clock Auto or Disabied oe gradually becomes louder if no action is manual Product Name Projection Alarm taken the alarm will automatically snooze for 8 Clock Display HH MM SS Clock With Agee minutes then sound once more before it turns K ki H Backlight off completely for the day d Operating lemp ratiren 23 F i Manufacturer IDT Technology Limited To turn the Alarm on or off press E vigour baidies Address Block C 9 F Kaiser To snooze the alarm press SNOOZE 5 Estate Phase 1 41 Man F Electroluminescence Yue St Hung Hom Battery type 2 AA Kowloon Hong Kong R Power Adapter 3 0V AC DC Adapter The RESET button is located in the battery is in conformity with Part 15 of the FCC Rules compartment Press
Download Pdf Manuals
Related Search