World Marketing of America NF15-9BMB space heater
Contents
1. flammable liquids are used or stored Use this heater only as described in this manual Any other use not recommended by the manufacturer may cause fire electric shock or injury to persons CAUTION Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire However if you have to use an extension cord the cord shall be No 14 AWG minimum size and rated not less than 1875 watts The output of this heater may vary and its temperature may become intense enough to burn exposed skin Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns SAVE THESE IMPORTANT INSTRUCTIONS FOR EASY REFERENCE ASSEMBLY This heater is pre assembled in factory ELECTRICAL RATINGS This product is rated 12 5 amps 1500W at 120V 60 Hz Power Indicator Light Power and Setting Control Thermostat Control Oscillation Dad gt 3 OPERATION Place the heater on a firm level surface free from obstructions and at least 3 ft 0 9m away from any wall or combustible material e With the Power Switch in the OFF position plug the heater into a grounded 120V outlet Always operate the heater in the upright position e To use the fan only function and no heat needed please push the Power and Setting Control switch B to FAN position the fan inside will work and Power Indicator Light A will illustrate To turn the heater on pleas2. runners or the like Arrange cord away from traffic areas where it can be tripped over 9 CAUTION This appliance has a polarized plug one blade is wider than the other To reduce the risk of shock this plug is intended to fit only one way in a polarized outlet If the plug does not fit fully in the outlet reverse the plug If it still does not fit contact a qualified electrician DO NOT attempt to defeat this safety feature To do so could result in an electric shock hazard 10 This heater draws 12 5 amps during operation To prevent overloading a circuit do not plug the heater into a circuit that already has other appliances working 11 CAUTION It is normal for the plug to feel warm to the touch however a loose fit between the AC outlet receptacle and plug may cause overheating and distortion of the plug Contact a qualified electrician to replace loose or worn outlet 12 To disconnect the heater first turn controls to the OFF position then remove plug from outlet Never pull by the cord 13 Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire or damage the heater 14 To prevent a possible fire do not block air intakes or exhaust in any manner Do 15 16 17 18 not use on soft surface like a bed where openings may become blocked A heater has hot and arcing or sparking parts inside Do not use it in the areas where gasoline paint or
3. your heater fails to operate please follow these instructions e Ensure that your circuit breaker or fuse is working properly Be sure the heater is plugged in and that the electrical outlet is working properly Check for any obstruction If you find any obstruction turn the heater off Unplug the heater and wait a few minutes for it to cool down Carefully remove the obstruction Plug the heater in and turn it on again by referring to the OPERATING INSTRUCTIONS NOTE IF YOU EXPERIENCE A PROBLEM WITH YOUR HEATER PLEASE SEE THE WARRANTY INFORMATION FOR INSTRUCTIONS PLEASE DO NOT ATTEMPT TO OPEN OR REPAIR THE HEATER YOURSELF DOING SO MAY VOID THE WARRANTY AND COULD CAUSE DAMAGE OR PERSONAL INJURY IF THE PROBLEM STILL PERSISTS PLEASE CONTACT US BY REFERRING TO THE SERVICE amp SUPPORT INFORMATION ON THE FOLLOWING PAGE CLEANING AND STORAGE We recommend that the heater be cleaned at least once a month and before off season storage Turn the heater off and unplug it Allow it to cool down e Use a dry cloth to clean the external surfaces of the heater DO NOT USE WATER WAX POLISH OR ANY CHEMICAL SOLUTION e Clean your heater using the above mentioned steps then pack the heater in its original container and store it in a cool dry place e This heater does not disassemble The motor is factory lubricated for life and will require no further lubrication SPECIFICATIONS Model No NF15 9BMB Voltage 120V 60Hz Curr
4. PELONIS FAN FORCED HEATER Model NF15 9BMB Listed Intertek PLEASE READ AND SAVE THESE INSTRUCTIONS 1 IMPORTANT SAFETY INSTRUCTIONS WARNING When using electrical appliances basic precautions should always be followed to reduce the risk of fire electric shock and injury to persons including the following INSTRUCTIONS FOR USE AND CARE 1 Read all instructions before using heater 2 This heater is hot when in use To avoid burns do not let bare skin touch hot surface If provided always use handles when moving this heater Keep combustible materials such as furniture pillows bedding papers clothes and curtains at least 3 feet 0 9m from the front of the heater and keep them away from the sides and rear 3 Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended 4 Always unplug the heater when not in use 5 Do not operate the heater with a damaged cord or plug if the heater malfunctions has been dropped or damaged in any manner Return heater to authorized service facility for examination electrical or mechanical adjustment or repair 6 Do not use the heater outdoors 7 This heater is not intended for use in bathroom laundry areas and similar moist indoor locations Never locate heater where it may fall into a bathtub or other water container 8 Do not run cord under carpeting Do not cover cord with throw rugs
5. e turn the Power and Setting Control switch B clockwise to the desired position LOW O or HIGH and turn Thermostat Control C to your desired setting from MIN to MAX Symbol Function FAN The heater turns off 2 Fan working only The heater operates at 900 watts The heater operates at 1500 watts e For quicker heat up you can turn the Power and Setting Control switch B to position HIGH and turn the Thermostat Control C to MAX when the room reaches a comfortable temperature slowly turn C counter clockwise until the Power Indicator Light A turns off This is the point at which the thermostat setting equals the room temperature and the thermostat will auto matically turn the heater on to and off to maintain this selected temperature Then you can turn B to position LOW for energy saving and prevent overheat e To turn on the Oscillation feature D turn the Oscillation switch ON Note If the fan was shut off either because of by pressing POWER to select OFF or the unit was turn off automatically for high room temperature the oscillation will be off RESET INSTRUCTIONS e This heater is equipped with an internal High Limit Switch which causes the unit to stop operating in the event the internal temperature exceeds normal operating temperatures IF THE UNIT SHUTS DOWN 1 TURN THE UNIT OFF 2 UNPLUG UNIT AND WAIT 10 MINUTES 3 PLUG IN AND TURN ON TROUBLESHOOTING If
6. ent Maximum 12 5 Amps Tolerances on all specifications Not exceeded than 105 PRINTED IN CHINA SERVICE amp SUPPORT In the event of a warranty claim or if service is required for this heater please contact us at the following Tel 866 876 4332 Email us at service pelonis com For questions or comments please write to PELONIS CUSTOMER SERVICE 1937 North Great Southwest Parkway Grand Prairie TX 75050 USA For your records staple your sales receipt to this manual and record the following DATE OF PURCHASE PLACE OF PURCHASE SERIAL NUMBER STAPLE SALES RECEIPT HERE NOTE PROOF OF PURCHASE IS REQUIRED FOR ALL WARRANTY CLAIMS THANK YOU FOR PURCHASING THIS ESSENTIAL NEEDS PRODUCT ONE 1 YEAR LIMITED WARRANTY e Please read all instructions before attempting to use this product e Please return the Warranty Registration card within fifteen 15 days from the date of purchasing this product PELONIS warrants as limited herein to the original purchaser of retail that each new Pelonis Fan Forced Heater shall be free of defects in material and workmanship for a period of one 1 year from the date of original purchase This one 1 year warranty is limited to the heating elements motor and electric control circuit board In the event of malfunctions or failure of your Pelonis Fan Forced Heater simply deliver or send the heater postage prepaid along with PROOF OF PURCHASE within the war
7. ranty period of one 1 year to PELONIS PELONIS reserves the right to inspect the claimed defective part or parts to determine if the defect or malfunction complaint is covered by this warranty PELONIS shall within sixty 60 days after receipt of the product at its option repair and or replace the defective part or parts free of charge This warranty shall only cover defects arising from normal usage PELONIS assumes no responsibility whatsoever if the Fan Forced Heater should fail during the warranty period by reason of e Misuse negligence physical damage or accidents e Lack of maintenance see instructions for proper maintenance e Repair by any unauthorized party during the warranty period e Damage caused by connection to an improper input voltage see specification label on your heater PELONIS makes no further warranties or representations express or implied except those contained herein No representative or dealer is authorized to assume any other liability regarding the Fan Forced Heater The duration of the implied warranty granted under State law including warranties of merchantability and fitness for particular purpose are limited in duration should the duration of the express warranty grant it hereunder PELONIS shall in no event be liable for direct indirect special or consequential damages Some states do not allow limitations on how long an implied warranty lasts and or the above limitations or exclusion may no
8. t apply to you This warranty gives you specific legal rights and you may have other rights which vary from state to state
Download Pdf Manuals
Related Search