Uncle Milton Remote Control Tarantula
Contents
1. remove the battery cover from the back of the controller See Fig 2 2 Insert 2 AA batteries and replace cover Rotate button NOTE This equipment has been tested and found to comply with the limits for a class B digital device pursuant to Part 15 of the FCC Rules These limits are designed to provide reasonable protection against FCC ID N9B2027UMI2006 or 49Mhz harmful interference in a residential installation This equipment generates uses and can radiate radio 362027UMI2007 frequency energy and if not installed and used in accordance with the instructions may cause harmful MADE IN CHINA interference to radio communications However there is no guarantee that interference will not occur ina This device complies with part 15 of the FCC Rules Operation is particular installation If this equipment does cause harmful interference to radio or television reception subject to the following two conditions which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver 1 this device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation WARNING Changes or modifications to this unit not expressly approved by the pa2. AGES 6 AND UP 2027 Ramote Geontreal Tarantula with LightUs Eye Installing batteries into tarantula Tool required Small Phillips head screwdriver 1 Using a Phillips head screwdriver remove the battery cover from the bottom of the tarantula See Fig 1 2 Insert 2 AAA batteries and replace cover BATTERY SAFETY INFORMATION Batteries must be replaced by an adult Follow the polarity diagram in the battery compartment Promptly remove dead batteries from the toy Dispose of used batteries properly Remove batteries for prolonged storage Only batteries of same or equivalent type as recommended are to be used DO NOT incinerate used batteries DO NOT dispose of batteries in fire as batteries may explode or leak DO NOT mix old and new batteries or types of batteries i e alkaline standard DO NOT use rechargeable batteries DO NOT recharge nonrechargeable batteries DO NOT short circuit the supply terminals Tarantula power switch Forward button Using your R C Tarantula Fig 2 1 Turn the power switches to the ON position on both the controller and tarantula Controller See Fig 1 power switch 2 Move the tarantula forward or make it turn using the buttons on the controller See Fig 3 Note For best performance use your r c tarantula on a smooth flat surface like a hardwood floor Fig 3 Install batteries into controller 1 Using a Phillips head screwdriver
3. rty responsible for compliance Connect the equipment into an outlet on a circuit different from that to which the receiver is connected aaa ae E user s daolilanps Operae the erie Consult the dealer or an experienced radio TV technician for help KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE DO NOT DISCARD Problems Before taking this product back to the store please call us We can help 1 888 742 2484 or go to www unclemilton com Uncle Milton Industries Westlake Village CA 91362 1 888 742 2484 Fax 818 707 0878 www unclemilton com UMI Inc All rights reserved Printed in China 2027 1107
Download Pdf Manuals
Related Search